关于锅炉大气污染物排放标准的思考

多年来锅炉大气污染物排放标准,一直沿用以锅炉排放污染物的浓度来评价的方法.由于锅炉燃烧的方式,锅炉运行、维护等方面的管理上存在很大的差异,目前低温连续供热的理念地提出,都给锅炉排放污染物的评价带来新的考验.本文主要探讨,锅炉大气污染物的评价指标以污染物排放量还是以浓度为标准,更能体现锅炉运行的实际状况,更准确地反映污染源源强.     

两种方法监测近岸大气NOX浓度的比较

分别用常规法和离子色谱法对近岸海域大气ＮＯＸ 进行同步监测，并对两方法间的相关性和测定结果的换算进行了研究。结果表明： 两者呈极显著的正相关，相关系数达０－８３５（ｎ＝ ９） ，其测定结果是可换算的。为此，建立了采用离子色谱法测定气溶胶ＮＯ－３ 浓度预测近岸大气ＮＯＸ 浓度的方法。     

4—氯苯甲酸钠的光催化氧化降解及其影响因素

本试验采用P－25TiO2，光催化剂，对4－氯苯甲酸钠的光催化氧化降解及污染物初始浓度，催化剂投加量和入射光强等因素的影响进行了研究，研究发现污染物初始降解速率与其初始浓度的关系遵循Langmuir-Hinshelwood模式，其中半饱和浓度常数Ks不仅是催化剂和污染物种类的函数，而且也是入射光强的函数，催化剂投加量存在一限值，当低于此限值时，污染物降解速率由于催化剂浓度的不足受到影响而下降，当高于此限值时，污染物降解速率受催化剂投加量的影响变小，在本试验4－CBA－Na浓度为0.15-0.6mmol／L时该催化剂限值浓度大约为0.4g/L，在入射光强为1-7mW/cm^2和催化剂浓度为0.4g／L下，污染物降解速率与光强成0.67次幂关系，经估算其量子效率为6．3％。     

一个研究街道峡谷流场及浓度场特征的三维数值模式

目前，研究街道峡谷内流场及机动车排放污染物的扩散行为特征所采用的主要方法为：采用野外测试法和物理模拟法，而采用三维数值模拟方法研究此问题的工作很少。本文创建了一个研究微尺度街道峡谷内流场及机动车排放污染物扩散特征的三维数值模式，即首次采用伪不定常方法，利用K——E闭合方案，建立了一个模拟城市街道峡谷内流场及污染物扩散特征与街道峡谷风场、街道几何结构及两侧建筑物高度对称性之间的复杂关系的三维数值模式。经过与实际监测资料及风洞实验对比，结果表明此三维模式具有较好的模拟精度，能够很好模拟峡谷内的风场及街谷几何结构对街道峡谷内流场及浓度场特征的影响，有很强的实用性。     

BUILDUP,WASHOFF, AND EVENT MEAN CONCENTRATIONS1

ABSTRACT: Most watershed water quality simulation models require the user to specify pollutant buildup and washoff rate parameters for pollutants, by land use. Buildup and washoff rates are difficult to measure directly, and only limited guidance and few observed data are available from the literature. Many studies, however, report storm event mean concentrations (EMCs). These EMCs must arise as a result of the buildup and washoff processes, but typically represent the net contribution from a variety of pervious and impervious surfaces. This paper explores the relationship between EMCs and buildup/washoff parameters. An assumption of the mathematical form of the buildup/washoff relationship gives an algebraic expression for the EMC consistent with model assumptions. This yields techniques to separate observed EMCs into contributions from different land uses and from pervious and impervious surfaces. Given this relationship, numerical optimization may be used to estimate site specific values of buildup and washoff parameters from observed storm EMCs for use in modeling. Use of this approach helps ensure that model parameters are consistent with observed data, providing a rational starting point for final model calibration. Several site examples demonstrate use of the method.     

Effect of soil solids concentration in batch tests on the partition coefficients of organic pollutants in landfill liner-soil materials

 The effect of the soil solids concentration in batch tests on the measured values of the partition coefficient (K _p) of organic pollutants in landfill liner-soil material was investigated. Since this study was based on the results of batch and column tests conducted independently, there were limitations to the conclusions derived. The organic compounds tested were benzene, methylene chloride, toluene, trichloroethylene, and p-xylene. The results of this study showed that as soil solids concentrations increased, the measured K _p values of these organic compounds strongly decreased. The observed values of K _p stabilized when the soil solids concentration was above a certain value. Typical K _p values obtained from batch tests conducted under high soil solids concentrations were close to those obtained from column tests. It was concluded that the K _p values of organic compounds measured under low soil solids concentrations, i.e., less than 100 g/l, may not correctly simulate the field situation. Consequently, the values of K _p obtained with low soil solids concentrations can result in an overestimation of the retardation factor of the landfill liner material. Received: March 14, 2002 / Accepted: August 25, 2002     

80m烟囟排放放射性气溶胶连续自动监测

本文介绍采用德国进口的ＬＢ９１００Ｄ监测系统对８０ｍ烟囟排放的α放射性气溶胶浓度进行连续、自动监测。并与国产ＦＪ－３６７，ＦＨ－４６３Ａ装置进行了对比则量，两套装置的测量结果符合得较好。     

仪化热电厂提高循环水浓缩倍率的措施

针对仪化热电厂将循环水用作冲灰水，导致浓缩倍率只有1.6，以及凝汽器铜管腐蚀结垢严重等问题，提出了隔断循环水与冲灰水的直接联系，实现闲路循环，对凝汽器铜管进行酸洗，并对循环水实施加缓蚀阻垢荆、杀菌剂和旁流过滤等办法，全部实施后产生了很好的效益，值得借鉴。     

大气污染物最大落地浓度计算方法的比较

大气环境影响评价工作中，采用有风点源扩散模式定量预测大气污染物的最大落地浓度，通常有轴线法、常数法和非常数法这三种计算方法。本文通过实例对上述三种计算方法进行比较分析，明确了各自的适用范围，其中以轴线法的应用最为全面。     

核事故中放射性核素扩散浓度的理论预测

在高斯烟羽模型的基础上,对核事故中放射性云团在大气中的扩散规律进行了研究。利用倾斜烟团模式,考虑实际过程中核素粒子的重力沉降、雨洗作用以及放射性衰变等因素的影响,提出一种迅速估算放射性核素扩散浓度的方法。该方法可计算核事故中连续点源和瞬时点源在不同气象、地形条件下的浓度分布,并可获得地面的干沉积率和湿沉积率。放射性核素浓度的确定是放射性事故抢险救援和辐射防护等工作的基础和前提,是放射性事故应急救援的重要组成部分。该结果在核事故的应急救援过程中,对救援人员划定警戒区和确定周围居民的疏散范围具有重要意义,并可为制定救援方案和应急决策提供科学依据。