中国2015年SO2排放总量宏观控制目标研究

1980年中国SO2排放量为1160万吨,2005年为2549万吨,伴随节能减排政策的实施和s02治理投资的增加,到2010年我国SO2排放量将降至2300万吨（削减10％）,仍位居世界第一位。在“十二五”期间,伴随人口、经济、能源的增长和发展模式的重大转变,我国2015年SO2排放总量面临微增长、不增长或减排的趋势。应用我国SO2减排宏观控制指标和模式预测了我国2015年SO2排放总量的4种图像或目标。提出了实现SO2排放总量削减10％目标的10条建议。     

火电机组状态及性能全息诊断系统技术及应用

阐述了火电机组状态及性能全息诊断系统的技术原理、系统结构及应用情况。该系统以解决机组应用性能问题为目标,采用状态空间分析模型,具备多层次分析的运行操作指导,基于性能渐变特性的设备状态检修,包括分散度在内的运行指标考核以及定期的节能潜力诊断等功能,在10余家电厂44台近1500万kW机组上取得了供电煤耗平均降低1.5～3.5g（标煤）/kW.h的节能效果。     

浅论石油化工企业二氧化硫总量减排

为满足石油化工企业总量控制的要求,采取相应的治理措施,降低污染物排放总量,避免采取大量投资和占地的末端治理措施,在工艺过程中采取措施降低主要污染物排放总量是行之有效的途径,采用催化工艺中添加硫转移脱氮剂的办法、热电厂锅炉采用改善炉体燃烧状态、配合石灰石脱硫等工艺过程措施,探讨进一步减少二氧化硫排放总量的可行性。     

石油污染土壤原位生物修复的强化实验研究

为研究添加营养物质和高效降解石油微生物对油污土壤生物修复的作用,通过分层土柱的方法,连续监测了不同条件下不同土层的含水率、石油烃含量、细菌数量及脱氢酶活性。结果表明:添加营养物质同时接种高效微生物可使降解效果明显改善,降解率比在自然条件下提高近50%,而单纯添加营养物质不接种高效微生物可使降解率比在自然条件下提高约25%。降解初期,上层土壤降解效果较好,而到中后期,中下层降解效果好于上层。微生物数量和脱氢酶活性与石油降解率之间存在良好的相关性,脱氢酶活性比微生物数量更能反映修复过程中微生物的存活状态。添加营养物质和高效降解石油微生物对油污土壤原位生物修复具有强化作用。     

不同种植方式对水生植物生长的影响

水生植物恢复是水体生态恢复与重建的一个关键,而人工快速大面积恢复沉水植物存在较大的难度。在淀山湖318国道近岸水域生态带内,运用水泥涵管覆土种植、箩筐覆土种植、纱布包裹覆土种植、编织袋覆土种植和竹签扦插法对水生植物进行种植。通过实验得出,运用水泥涵管覆土种植的芦苇存活率比用箩筐覆土种植的存活率高;运用水泥涵管覆土+竹签扦插法种植的狐尾藻存活率比其他几种种植方法的存活率高,几种种植方式下的生物量无显著差异。     

Analysis of a Farquhar-von Caemmerer-Berry leaf-level photosynthetic rate model for Populus tremuloides in the context of modeling and measurement limitations

The balance of mechanistic detail with mathematical simplicity contributes to the broad use of the Farquhar, von Caemmerer and Berry (FvCB) photosynthetic rate model. Here the FvCB model was coupled with a stomatal conductance model to form an [A,g_s] model, and parameterized for mature Populus tremuloides leaves under varying CO₂ and temperature levels. Data were selected to be within typical forest light, CO₂ and temperature ranges, reducing artifacts associated with data collected at extreme values. The error between model-predicted photosynthetic rate (A) and A data was measured in three ways and found to be up to three times greater for each of two independent data sets than for a base-line evaluation using parameterization data. The evaluation methods used here apply to comparisons of model validation results among data sets varying in number and distribution of data, as well as to performance comparisons of [A,g_s] models differing in internal-process components.     

Biomass fuel burning and its implications: Deforestation and greenhouse gases emissions in Pakistan

Pakistan is facing problem of deforestation. Pakistan lost 14.7% of its forest habitat between 1990 and 2005 interval. This paper assesses the present forest wood consumption rate by 6000 brick kilns established in the country and its implications in terms of deforestation and emission of greenhouse gases. Information regarding consumption of forest wood by the brick kilns was collected during a manual survey of 180 brick kiln units conducted in eighteen provincial divisions of country. Considering annual emission contributions of three primary GHGs i.e., CO₂, CH₄ and N₂O, due to burning of forest wood in brick kiln units in Pakistan and using IPCC recommended GWP indices, the combined CO₂-equivalent has been estimated to be 533019 t y⁻¹.     

Appraisal of measurement methods, chemical composition and sources of fine atmospheric particles over six different areas of Northern Belgium

Daily and seasonal variation in the total elemental, organic carbon (OC) and elemental carbon (EC) content and mass of PM_2.5 were studied at industrial, urban, suburban and agricultural/rural areas. Continuous (optical Dustscan, standard tapered element oscillating micro-balance (TEOM), TEOM with filter dynamics measurement system), semi-continuous (Partisol filter-sampling) and non-continuous (Dekati-impactor sampling and gravimetry) methods of PM_2.5 mass monitoring were critically evaluated. The average elemental fraction accounted for 2-6% of the PM_2.5 mass measured by gravimetry. Metals, like K, Mn, Fe, Cu, Zn and Pb were strongly inter-correlated, also frequently with non-metallic elements (P, S, Cl and/or Br) and EC/OC. A high OC/EC ratio (2-9) was generally observed. The total carbon content of PM_2.5 ranged between 3 and 77% (averages: 12-32%), peaking near industrial/heavy trafficked sites. Principal component analysis identified heavy oil burning, ferrous/non-ferrous industry and vehicular emissions as the main sources of metal pollution.     

城市生活垃圾降解率分析研究

针对城市生活垃圾降解率研究不足的现状,结合室内物理模拟实验,对垃圾温度和垃圾降解率的变化规律进行分析研究。研究结果表明,填埋初期垃圾填埋体温度升高较快,服从三次曲线变化规律;温度对垃圾降解率有重要的影响,单一温度下垃圾降解率随时间变化近似符合微生物生长曲线;不同温度下,温度高,垃圾降解率快,试验证明41.00、45.00℃垃圾降解率最快,垃圾降解率相差不大,可以认为温度高于41.00℃时垃圾降解率可以按照41.00℃时垃圾降解率计算。     

镍网负载纳米TiO2光催化反应器对酸性品红脱色效果实验研究

采用负载纳米TiO2的三维镍网装配了光催化反应器,就其对酸性品红溶液进行脱色效果进行了实验研究。考察了反应器的3种装配条件、品红初始浓度、pH值、H2O2投加量、紫外光剂量等因素对酸性品红脱色效果的影响。结果表明：UV灯＋镍网＋TiO2模式组合的反应器脱色效果最好;在相同的处理时间内酸性品红溶液的脱色率随起始浓度的增大而减小;将酸性品红溶液pH值调至5时脱色效果最明显,70 min的脱色率可高达94.8%。脱色效果还可以通过溶液中添加H2O2和控制紫外线剂量来调节。当溶液中H2O2投加量为0.5 g/L时,处理70 min后的脱色率可高达98.3%;到达反应界面紫外光剂量越多则能够获得越高的酸性品红脱色率。