北京市二个主要工业区汞污染及其来源的初步研究

为了调查北京市汞污染状况及其来源，选择二个主要工业区石景山区和朝阳区为研究对象．共采集表层土壤２６个，剖面样品４个，对照土壤样品４个，并且在冬季采集降雪样品和枯叶样品，分析汞含量．结果表明，燃煤烟尘排放的汞是北京市汞的主要来源，汽车尾气和化工厂泄漏可使局部汞含量增高，表层土壤中汞含量为００７—２７５ｍｇ／ｋｇ．土壤剖面中的汞含量在０—１００ｃｍ土层中均较高，其含量与土壤有机质和碳酸盐含量正相关．降雪中汞在０７—３７ｍｇ／Ｌ之间，明显高于背景值，其中大部分吸附在颗粒物上．枯叶中汞主要是从土壤吸收，并且有可能被雨水淋溶出来．     

11种有机磷农药对海洋微藻致毒效应的研究

通过研究不同盐度条件下１１种有机磷农药对扁藻的相对增长率和叶绿素ａ含量的影响，得到了Ｓ＝３０和Ｓ＝２０时的半数有效浓度，并比较其大小。盐度作为环境因子，影响到有机磷农药的毒性。研究发现，遥有机磷农药在低浓度时出现一定限度的促生长作用；容易进攻细胞膜的有机磷农药对扁藻的致毒性相对较强；此外，有机磷农药的毒性大小与其结构密切相关含有苯环结构的有机磷农药毒性大小不含有苯 有机磷农药的毒性。     

砖瓦厂含氟废气的治理

通过实验选取了一种固氟剂添加到砖坯中后，砖块的存氟率为９１０％，烟道气总氟排放降低率为７６７８％。连续五年的生物检测试验，没有发生任何家蚕氟中毒现象。固氟剂的应用为砖厂含氟废气的治理提供了一条新的途径     

船舶柴油机NOx后处理技术的进展

根据国内外的降低NOx排放方面最新的成果和科研动态，主要介绍了当前正在研究或者已经应用于实际的有效降低柴油机NOx排放的技术措施，并分析了各种技术方法的特点和在实际应用过程中面临的问题。     

SBR法运行控制工艺研究进展

SBR法是一种具有独特的优点的废水生物处理工艺，但至今还没有一套公认的运行控制工艺，本文从SBR法的启动，充水时间及反应时间的确定，模糊控制，目标控制操作等几方面对SBR工艺的运行控制做了评述，并对其今后的研究方向做了展望。     

镀液循环流量对封闭循环电沉积Ni-SiC复合镀层的影响

目的 研究封闭式镀液循环装置中不同镀液循环流量对Ni-SiC复合镀层的影响规律,优化镀液循环流量参数.方法 以Q235管状工件为待镀基体,以添加SiC颗粒的改良瓦特镀液为母液,在自主研发的封闭式镀液循环电镀装置中以0.3、0.5、0.7 m3/h的镀液循环流量于管件内壁制备Ni-SiC复合镀层,通过SEM检测、XRD测试、硬度测试和摩擦磨损性能测试等手段,对各Ni-SiC复合镀层宏微观形貌、厚度、成分、结构、硬度和耐磨性进行分析研究.结果 在0.5 m3/h流量条件下,镀层厚度为32.98μm,SiC颗粒含量为15.37％,镀层晶粒尺寸和硬度分别为10.84 nm和704HK0.245,该条件下制备的Ni-SiC复合镀层具有最佳耐磨性,摩擦系数为0.41,体积磨损率仅2.83×10–5 mm3/Nm.结论 在不同镀液循环流量参数下,采用该封闭式循环电镀装置,均可制得均匀完整的Ni-SiC复合镀层.随镀液循环流量的升高,镀层厚度和SiC颗粒体积含量均降低,镀层颜色金属光泽增强,镀层晶粒尺寸先减小、后增大,镀层硬度则先升高、后降低.     

低温高铁锰氨氮地下水两级生物净化快速启动

为了实现东北地区低温（5~6℃）高铁、锰、氨氮（TFe：9~15mg/L，Fe²⁺：6~12mg/L，NH₃-N：1.4~2.0mg/L，Mn²⁺：1.4~2.0mg/L）地下水的净化及解决同层净化中运行稳定性差、出水锰超标的问题，在水厂净化车间开展“两级曝气+两级过滤”工艺启动研究，采用差滤速和同滤速2种启动方式分别启动两级生物净化工艺.结果表明，2种启动方式分别在106，59d启动成功.同滤速启动可以有效的缩短两级生物净化的启动时间，铁、锰、氨氮去除负荷可达110.69，18.80，19.54g/（m²·h），沿程分析发现，铁在一级滤柱的60cm处即被去除至痕量；85.08%的氨氮在一级滤柱中去除，沿程各段去除均匀，14.92%的氨氮在二级滤柱中去除；锰的去除率和氧化活性去除区位受滤速及进水氨氮浓度影响较大，33.72%的锰在一级滤柱中去除，66.28%的锰在二级滤柱中去除，锰的去除仍然是滤池成熟的决定性因素.     

城市交通机动车污染控制研究进展

城市交通机动车污染问题非常复杂，在许多不可控因素，城市交通是一个动态系统，污染物排放量始终处于变化之中，控制城市交通污染，必须严格控制机动车排放，该文介绍了国内外对城市机动车污染控制研究的概况，以及几种城市中污染物扩散的模型，展望了这方面研究前发展趋势，并提出了可持续发展的效能系统设计与管理的新概念。     

Chance-constrained programming (CCP)abatement of SO_2 emission for acid deposition control in Liuzhou City

A deterministic linear programming model which optimizes the abatement of each SO2 emission source, is extended into a CCP form by introducing equations of probabilistic constrained through the incorporation of uncertainty in the source-receptor-specific transfer coefficients. Based on the calculation of SO2 and sulfate average residence time for Liuzhou City, a sulfur deposition model has been developed and the distribution of transfer coefficients have been found to be approximately log-normal. Sulfur removal minimization of the model shows that the abatement of emission sources in the city is more effective, while control cost optimization provides the lowest cost programmes for source abatement at each allowable deposition limit under varied environmental risk levels. Finally a practicable programme is recommended.     

The safety of fetoscopy: (I). Effect of umbilical vessel puncture on the fetal heart rate and cord histology

The fetal heart rate (FHR) was continuously monitored during 42 umbilical vessel punctures performed at the placental insertion of the cord in 24 diagnostic fetoscopies in which pure fetal blood was obtained. In only one patient did a deceleration first appear during puncture and aspiration of fetal blood. In two patients decelerations preceded fetoscopy and in two others they began during the fetoscopy but before puncture of an umbilical vessel. In 19 patients, the FHR did not change at all during the procedure. Fetal haemorrhage after sampling was either absent or minimal. Six pregnancies were terminated because a positive diagnosis had been made and 18 healthy babies were born. Umbilical cords were examined after 7 terminations of pregnancy and after 6 deliveries. In the former group the puncture could just be seen with the naked eye and the needle track was demonstrated histologically in 6. No traces of the puncture or other abnormalities were found in the cords after delivery. Fetal blood sampling from umbilical cord vessels, particularly at the placental insertion of the cord, is the technique of choice since pure fetal blood can be obtained without increasing the risk of fetoscopy.