Exposure Assessment to Mercury Vapor in Chloralkali Industry

The aim of the study was to develop a sampling method aimed at individual sampling of mercury vapor and subsequent individualexposure assessment of the worker. Hopcalite available fromInowrocawskie Zakady Chemiczne (in Poland) was founduseful for mercury vapor sampling in active and passive individual samplers. However the sampling rate determined forpassive sampler in steady-state laboratory chamber cannot be usedunder fluctuating conditions of mercury vapor concentration andair movement typical for field measurement. In order to check comparativeness of passive and active sampling methods, sampleswere taken in the same time and individual samplers fixed toworker's clothes were used. Mercury vapor concentration wasmeasured at two chloralkali industries in Poland and the resultswere presented. Excessive exposure in both industries wasconfirmed by finding elevated mercury concentration in urinesamples from the workers.     

RISK ASSESSMENT METHODOLOGY FOR KARST AQUIFERS: (2) SOLUTE-TRANSPORT MODELING

Ground-water flow and solute-transport simulation modeling are major components of most exposure and risk assessments of contaminated aquifers. Model simulations provide information on the spatial and temporal distributions of contaminants in subsurface media but are difficult to apply to karst aquifers in which conduit flow is important. Ground-water flow and solute transport in karst conduits typically display rapid-flow velocities, turbulent-flow regimes, concentrated pollutant-mass discharge, and exhibit open-channel or closed-conduit flow. Conventional ground-water models, dependent on the applicability of Darcy`s law, are inappropriate when applied to karst aquifers because of the (1) nonapplicability of Darcian-flow parameters, (2) typically nonlaminar flow regime, and (3) inability to locate the karst conduits through which most flow and contaminant transport occurs. Surface-water flow and solute-transport models conditioned on a set of parameters determined empirically from quantitative ground-water tracing studies may be effectively used to render fate-and-transport values of contaminants in karst conduits. Hydraulic-flow and geometric parameters developed in a companion paper were used in the surface-water model, TOXI5, to simulate hypothetical slug and continuous-source releases of ethylbenzene in a karst conduit. TOXI5 simulation results showed considerable improvement for predicted ethylbenzene-transport rates and concentrations over qualitative tracing and analytical ground-water model results. Ethylbenzene concentrations predicted by TOXI5 simulations were evaluated in exposure and risk assessment models.     

亚甲蓝分光光度法测定饮用水中阴离子表面活性剂的方法讨论

用10ml氯仿萃取离子缔合物一次,洗涤一次,不稀释。它与国标方法的线性回归无显著性差异,此方案测定样品的准确度En为0·34,小于1,结果令人满意,测量不确定度是除国标方法外最低的方案。因此它具有低污染、操作简单的特点,并可用于常规检测饮用水中的LAS。     

博斯腾湖水质矿化度模型及预测研究

根据博斯腾湖１９８５～１９９５年水质监测数据和出入湖水量等水文数据观测值，采用水质扩散模型和盐量平衡关系推导出博斯腾湖大湖区（简称博湖）水质矿化度模型，并预测了几种情况下博湖水质矿化度及近几年变化趋势，分析了影响博湖水质矿化度的主要因素，为博湖的近期和远期环境保护规划、环境管理等提供科学依据．     

哈密地区环境中^220Rn子体α潜能浓度所致居民剂量估算

用ＳｔｒａｎｄｅｎＥ．推荐的测量方法对哈密地区环境空气中２２０Ｒｎ子体α潜能浓度测量结果表明，室内、外平均值分别为５６．１和１０．２（×１０－７Ｊ·ｍ－３）。室内外２２０Ｒｎ／２２２Ｒｎ子体α潜能浓度比值分别为０．８４和０３２。２２０Ｒｎ子体所致居民有效剂量当量为２２８μＳｖ·ａ－１（集体有效剂量当量为０．９×０２ｍａｎ·Ｓｖ）。     

车载巡测在区域射频电磁环境质量监测与表征中的应用分析

对北京中央电视塔周围25 km²区域电磁环境质量分别进行了射频的网格法手工监测和车载巡测自动监测，通过SPSS软件等对两种监测方法获取的数据进行了统计对比分析，发现两组数据在总体水平及数值分布特征上较为接近，因此车载巡测监测可以替代网格法监测。以车载巡测数据为基础，绘制了实测数据的道路电磁地图，利用插值法绘制了区域电磁地图，对区域电磁环境质量进行了直观表征。从回应公众关注和城市电磁规划出发，建议今后可利用车载巡测监测加强时域和频域的监测。     

潜水含水层水位观测孔水位伪变化的观测与分析

结合CIRP试验场包气带的介质结构及渗透性特征，在S9孔进行了短期的孔中水位、孔口气压和温度测量，测量结果表明，观测孔水位波动与大气压变化有关，水位波动具有伪变化。水位伪变化对于试验场潜水位的监测有一定影响，因此，应对带有伪变化的水位观测结果进行必要的修正，以反映潜水位的真实动态。     

基于网格空间数据的晋陕蒙接壤区生态环境综合评价

晋陕蒙接壤区是典型的生态过渡带、生态脆弱带。文章在调查研究的基础上 ,选取了 1 3个评价指标 ,应用层次分析法确定其权重 ,并将各个因子分级标准化和定量赋值 ,再用加权求和法得到每个评价单元的环境质量综合评价指数。根据环境综合评价指数将环境质量分为较好 (≥ 8)、一般 (≥ 6～ <8)、较差 (≥ 4～ <6)、恶劣 (<4) 4级。结果表明 :晋陕蒙接壤区的环境质量大多处于较差等级 ,较好、一般、较差、恶劣等级的面积比例分别为 2 .2 % ,2 8% ,5 7.4%和1 2 .4%     

夜间建筑施工噪声扰民监测方法探讨

以一家夜间施工工地为例 ,通过对现有夜间建筑施工噪声测量方法及国家和深圳经济特区有关噪声污染定义的分析 ,阐述了夜间施工工地噪声扰民监测方法