Influence of temporally variable groundwater flow conditions on point measurements and contaminant mass flux estimations

Monitoring of contaminant concentrations, e.g., for the estimation of mass discharge or contaminant degradation rates, often is based on point measurements at observation wells. In addition to the problem, that point measurements may not be spatially representative, a further complication may arise due to the temporal dynamics of groundwater flow, which may cause a concentration measurement to be not temporally representative. This paper presents results from a numerical modeling study focusing on temporal variations of the groundwater flow direction. “Measurements” are obtained from point information representing observation wells installed along control planes using different well frequencies and configurations. Results of the scenario simulations show that temporally variable flow conditions can lead to significant temporal fluctuations of the concentration and thus are a substantial source of uncertainty for point measurements. Temporal variation of point concentration measurements may be as high as the average concentration determined, especially near the plume fringe, even when assuming a homogeneous distribution of the hydraulic conductivity. If a heterogeneous hydraulic conductivity field is present, the concentration variability due to a fluctuating groundwater flow direction varies significantly within the control plane and between the different realizations. Determination of contaminant mass fluxes is also influenced by the temporal variability of the concentration measurement, especially for large spacings of the observation wells. Passive dosimeter sampling is found to be appropriate for evaluating the stationarity of contaminant plumes as well as for estimating average concentrations over time when the plume has fully developed. Representative sampling has to be performed over several periods of groundwater flow fluctuation. For the determination of mass fluxes at heterogeneous sites, however, local fluxes, which may vary considerably along a control plane, have to be accounted for. Here, dosimeter sampling in combination with time integrated local water flux measurements can improve mass flux estimates under dynamic flow conditions.     

低压稳流过滤器的研制及在油田污水处理中的应用

为了解决大庆油田现有核桃壳、石英砂过滤器反冲洗憋压、跑料和滤料再生困难等问题,在对原有过滤装置分析的基础上,根据反冲洗特性,对过滤器进行了改造,开发出低压稳流核桃壳过滤器和低压稳流石英砂过滤器。经现场测试,核桃壳过滤器反冲洗压力由原来的0.15～0.5 MPa降低到0.03～0.08 MPa,石英砂过滤器反冲洗压力由原来的0.27～0.46 MPa降低到0.17～0.20 MPa,且均能实现罐群水反冲洗。改造后核桃壳过滤器出水油平均含量13.4 mg/L,平均去除率为78.1%;出水悬浮物平均含量20.5 mg/L,平均去除率为55%。改造后石英砂过滤器出水油平均含量5 mg/L以下,平均去除率达到75%以上;出水悬浮物平均含量为9.8 mg/L,去除率达到80%以上。为了进一步提高过滤效果,在二级滤前投加絮凝剂形成微絮凝过滤工艺,出水悬浮物可达到3 mg/L,通过两级过滤达到特低渗透地层回注水标准。     

摆管淋水试验装置的校准方法探讨

文中简述了摆管淋水试验装置的基本结构及其常见的校准方式,对其中的“摆角校准”这一技术难点提出了可行的解决方案并作了较详尽的说明分析。     

含油污泥调剖技术在陇东油田悦29区的应用

针对长庆陇东油田悦29区注水平面矛盾突出的特点,优选了含油污泥调剖技术。详细介绍了调剖体系的配制,调剖体系性能测试表明其相关性能指标满足要求。进行了驱替模拟试验,结果表明:其封堵作用可以维持较长时间,通过对不同注水井组进行现场应用,显示该技术能改善水驱开发效果,可以满足油藏深部封堵大孔道的技术要求,有增油降水效果。     

真空灭弧室导电回路产生的磁场环境对灭弧室短路开断的影响

设计良好的导电回路对真空断路器灭弧性能的提高有着重要的意义。本文首先从结构上分析了三种不同导电回路的优缺点,接着,分析了三种不同导电回路的电动斥力和吹弧磁场,为通过选择不同导电回路,触头直径和开距提高真空断路器灭弧性能提供方法和思路。     

苏里格气田试气队伍节能减排工作现状及改进建议

苏里格气田试气队伍因涉及数家企业单位,节能减排工作有其特殊性和复杂性。通过调查试气过程中的排污状况,分析了其节能减排工作中出现的几个问题,如计量粗放、管理薄弱、措施简单等,提出了健全管理制度,完善计量系统,鼓励技术研究,加强自主创新,创建统一平台,依靠丙方监管等措施,以促进其节能减排工作健康有序地发展。     

Development of a Quantitative Pasture Phosphorus Management Tool Using the SWAT Model1

Abstract: Assessment tools to evaluate phosphorus loss from agricultural lands allow conservation planners to evaluate the impact of management decisions on water quality. Available tools to predict phosphorus loss from agricultural fields are either: (1) qualitative indices with limited applicability to address offsite water quality standards, or (2) models which are prohibitively complex for application by most conservation planners. The purpose of this research was to develop a simple interface for a comprehensive hydrologic/water quality model to allow its usage by farmers and conservation planners. The Pasture Phosphorus Management (PPM) Calculator was developed to predict average annual phosphorus (P) losses from pastures under a variety of field conditions and management options. PPM Calculator is a vastly simplified interface for the Soil and Water Assessment Tool (SWAT) model that requires no knowledge of SWAT by the user. PPM Calculator was validated using 33 months of data on four pasture fields in northwestern Arkansas. This tool has been extensively applied in the Lake Eucha/Spavinaw Basin in northeastern Oklahoma and northwestern Arkansas. PPM Calculator allows conservation planners to take advantage of the predictive capacity of a comprehensive hydrologic water quality model typically reserved for use by hydrologists and engineers. This research demonstrates the applicability of existing water quality models in the development of user friendly P management tools.     

浅谈新疆风电场水土保持措施配置——以新疆华电小草湖风电场二场一期工程为例

风能作为一种清洁无污染的可再生能源,已经被广泛运用到电力事业的发展中来。近年来,新疆的风力发电发展迅速,风电场建设过程中不可避免地会对土壤及植被造成一定的破坏,人为地加剧了水土流失。概述了风电项目水土流失特点,以新疆华电小草湖风电场工程为例,结合项目区具体特点,分区设置防治措施。通过工程措施、植物措施与临时措施的有机结合,有效地防止水土流失。     

Evaluation of two models of a slipmeter

The aim of the study was to compare the performances of the Brungraber Mark II (BM II) and Mark III (BM III) slipmeters. Friction measurements with the two slipmeters were conducted in a laboratory using four footwear materials, four floor types, and three surface conditions. Both the coefficient of friction (COF) values obtained with the slipmeters and the force platform-based COF values were measured. The COF measured with the BM II was slightly higher than that measured with the BM III with a R² of 0.83. A comparison of the averaged normal force between the two slipmeters showed that the BM II generated a significantly higher normal force than the BM III at a low COF and the difference of the normal force between the two slipmeters decreased when the COF value was increased. The regression analysis results in this study showed that the force platform-based COF values were closer to the COF values obtained with the BM III than with the BM II. The R² values for the regression model between the COF values obtained from the slipmeter and the force platform were 0.90 and 0.79 for the BM II and BM III, respectively.     

双区电除尘器降低锅炉烟尘排放浓度

粉尘在传统结构的荷电区荷电之后,一部分尘粒被阳极板捕集,大部分带有正、负电荷的尘粒再分别被收尘区的管式辅助电极和阳极板捕集.模拟试验数据表明,收尘区具有高电压、低电流和板电流密度分布均匀的特性.工业性试验结果显示,应用双区电除尘技术设计或改造电除尘器,不仅可以较好地防止发生反电晕,而且能够将锅炉烟尘排放质量浓度降低到50 mg/m3以下.与传统的卧式电除尘器相比,还可节省10%左右的占地面积和钢材用量.