The Reuse of Urban and Industrial Waste in Tai-Lin-Pu Reclamation Project,Taiwan

Abstract

This study introduces the principles of KMG's (Kaoshiung Municipal Government) dealing with the non-poisonous urban and industrial waste through reclamation of shore land in reinforcing a sense of coastal protection and land development in Tai-Lin-Pu coastal area, southern Taiwan.

Through a series of experimental studies, we found that substitutes of coarse aggregate with a broad spectrum of integrating slag powder, fly ash, and cementitious material can be obtained with a benefit up to 80% saving of cement. the integrated aggregates from the non-poisonous industrial wastes were subsequently made into armour units and used in the field tests at Tai-Lin-Pu coastal area, where the shorelines are seriously eroded. After being subjected to several severe typhoon advents, the results showed that the waste-made units used as the protection breakwater, together with construction wastes and excavated soil as the filling material, prove to be an effective practice in utilizing recycled urban waste to reclaim erosive shore lands. Moreover, this study also demonstrates that through detailed analysis of the waste characteristics, scrap material could be turned into valuable construction aggregates, and highlights the value of non-poisonous urban and industrial waste as a alternative resource for the shore protection engineering.     

Leaching of trace and major elements from coal ash dumps

Coal ash samples taken from an active, currently filled cassette as well as samples taken from passive cassettes of the power plant in Obrenovac (Yugoslavia) were subjected to sequential leaching, comprising of extraction with distilled water, 1 M KC1 and 0.1 M HC1. Concentrations of trace and major elements found in extracts revealed that lead and cadmium are not present in significant concentrations, while other elements show different behavior: practically all absorbed trace elements and most of the major elements are partially leached during transport, while later, on the dump, only a slow release of most of the examined ion‐exchangeable elements occurs.     

Durability of conventional concretes containing black rice husk ash

In this study, black rice husk ash (BRHA) from a rice mill in Thailand was ground and used as a partial cement replacement. The durability of conventional concretes with high water–binder ratios was investigated including drying shrinkage, autogenous shrinkage, depth of carbonation, and weight loss of concretes exposed to hydrochloric (HCl) and sulfuric (H₂SO₄) acid attacks. Two different replacement percentages of cement by BRHA, 20% and 40%, and three different water–binder ratios (0.6, 0.7 and 0.8) were used. The ratios of paste volume to void content of the compacted aggregate (γ) were 1.2, 1.4, and 1.6. As a result, when increasing the percentage replacement of BRHA, the drying shrinkage and depth of carbonation reaction of concretes increased. However, the BRHA provides a positive effect on the autogenous shrinkage and weight loss of concretes exposed to hydrochloric and sulfuric acid attacks. In addition, the resistance to acid attack was directly varied with the (SiO₂ + Al₂O₃ + Fe₂O₃)/CaO ratio. Results show that ground BRHA can be applied as a pozzolanic material and also improve the durability of concrete.     

重庆金佛山降雪中飞灰单颗粒特征及来源解析

大气降雪能够保存大气环境信息,是研究区域环境的良好介质.位于渝黔交接带的金佛山海拔2 251.1 m,冬季降水以降雪的形式出现,周边区域人类活动强烈.关于该区域大气气溶胶中的飞灰单颗粒特征的研究比较缺乏.本研究采集了金佛山5个降雪样品,运用扫描电镜及X能谱分析联用系统(SEM-EDS)对样品中的132个飞灰进行单颗粒形貌、化学组成分析.结果表明,研究区降雪中存在大量球形飞灰,包含光滑颗粒、粗糙颗粒及聚合体颗粒3种形态,分别占统计颗粒的80.31%、14.39%和5.30%;平均粒径1.64μm,平均环度1.09.按主导化学元素分为富硅类、富碳类、富铁类、富铝类及富钛类5种,所占比例分别为34.09%、49.24%、12.88%、2.27%和1.52%.结合气象资料、气团后向运移轨迹和飞灰性质,推测富碳类飞灰可能主要来自于生活排放源和工业活动;富硅类飞灰可能来自于渝西、黔北、湘中、浙赣一带及粤西的火力发电厂等高温燃煤工业;富铁类及富钛类飞灰则可能来源于渝西和黔北、湘中的钢铁厂、轧钢厂等金属冶炼活动.     

Evaluation of micro- and nano-carbon-based adsorbents for the removal of phenol from aqueous solutions

This work reports on the adsorption efficiency of two classes of adsorbents: nano-adsorbents including carbon nanotubes (CNTs) and carbon nanofibers (CNFs); and micro-adsorbents including activated carbon (AC) and fly ash (FA). The materials were characterized by thermogravimetric analysis, transmission electron microscopy, Brunauer–Emmett–Teller (BET) specific surface area, zeta potential, field emission scanning electron microscopy, and UV spectroscopy. The adsorption experimental conditions such as pH of the solution, agitation speed, contact time, initial concentration of phenol, and adsorbent dosage were optimized for their influence on the phenol. The removal efficiency of the studied adsorbents has the following order: AC > CNTs > FA > CNFs. The capacity obtained from Langmuir isotherm was found to be 1.348, 1.098, 1.007, and 0.842 mg/g of AC, CNTs, FA, and CNFs, respectively, at 2 hours of contact time, pH 7, an adsorbent dosage of 50 mg, and a speed of 150 rpm. The higher adsorption of phenol on AC can be attributed to its high surface area and its dispersion in water. The optimum values of these variables for maximum removal of phenol were also determined. The experimental data were fitted well to Langmuir than Freundlich isotherm models.     

Chemical composition and physical properties of filter fly ashes from eight grate-fired biomass combustion plants

For the handling, treatment and utilization of fly ash from biomass combustion its chemical composition and physical properties are important. In this study eight filter fly ashes from different grate-fired biomass combustion plants were investigated. In fly ash from straw combustion high concentrations of(K) were found, whereas in the fly ash from wood combustion the concentrations of Ca and Mg were higher. The average concentration of PO3-4was similar in both types of fly ashes. In all wood fly ashes some measured heavy metal concentrations were above the limits for utilization. The straw fly ashes were much less contaminated and can be utilized. For wood fly ash most parameters showed little variation, except from one fly ash where the dust pre-separator is in poor condition. The average values were: mass median diameter 4.3 ± 0.8 μm, spread of particle size distribution19 ± 11, particle density 2620 ± 80 kg/m3 and angle of repose 50°± 1°. The density of the straw fly ashes is lower(2260 ± 80 kg/m3) and the spread of the size distribution is higher(72 ± 24).For one straw combustion fly ash the values of the mass median diameter and the angle of repose were similar to the values of wood combustion fly ash, for the other straw fly ash the values differed considerably. While the particle size of this fly ash was much smaller,surprisingly the angle of repose was also lower. This can be attributed to the formation of small agglomerates in this fly ash, which were not disintegrated without a certain stress.     

Effects of temperature and composite alumina on pyrolysis of sewage sludge

An interactive dual-circulating fluidized bed system has been proposed in which the pyrolysis of sewage sludge(SS) and incineration of biomass proceed simultaneously, and alumina is used as the bed material and heat carrier. The alumina coated with biomass ash would mix with sewage sludge in the pyrolysis reactor of this device. It is important to know the influence of composite alumina(CA) on the pyrolysis progress. Sewage sludge was pyrolyzed in a fixed bed reactor from 400 to 600°C using CA as catalyst. The effects of temperature and CA additive ratio on the products were investigated. The product yields and component distribution of non-condensable gas were more sensitive to the change of temperature, and the maximum liquid yield of 48.44 wt.% and maximum Useable Energy of Liquid of 3871 k J/kg sludge were observed at 500°C with 1/5 CA/SS(mass ratio). The gas chromatography–mass spectrometry results showed that the increase of temperature enhanced devolatilization of organic matter and promoted cyclization and aromatization of aliphatics. The presence of CA could strengthen secondary cracking and interaction among primary products from different organic compounds, such as acid–amine condensation,and reduce the content of oxygenated compounds. When the CA additive amount exceeded a certain proportion, the aromatization was clearly strengthened. The effects of CA on decomposition of fatty acids and formation of aromatics were similar to that of temperature. This means that the reaction temperature could be lowered by introducing CA, which has a positive effect on reducing energy consumption.     

Synthesis of novel CeO2-BiVO4/FAC composites with enhanced visible-light photocatalytic properties

To utilize visible light more effectively in photocatalytic reactions, a fly ash cenosphere （FAC）-supported CeO2-BiV04 （CeO2-BiVO4/FAC） composite photocatalyst was prepared by modified metalorganic decomposition and impregnation methods. The physical and photophysical properties of the composite have been characterized by X-ray diffraction （XRD）, scanning electron microscope （SEM） and energy dispersive X-ray spectroscopy （EDX）, X-ray photoelectron spectroscopy （XPS）, and UV-Visible diffuse reflectance spectra. The XRD patterns exhibited characteristic diffraction peaks of both BiVO4 and Ce02 crystalline phases. The XPS results showed that Ce was present as both Ce4＋ and Ce3＋ oxidation states in Ce02 and dispersed on the surface of BiV04 to constitute a p-n heterojunction composite. The absorption threshold of the CeO2-BiVO4/FAC composite shifted to a longer wavelength in the UV-Vis absorption spectrum compared to the pure Ce02 and pure BiV04. The composites exhibited enhanced photocatalytic activity for Methylene Blue （MB） degradation under visible light irradiation. It was found that the 7.5 wt.% CeO2-BiVO4/FAC composite showed the highest photocatalytic activity for MB dye wastewater treatment.     

粉煤灰对阴离子水溶性混合染料的吸附动力学

以燃煤废弃物粉煤灰作为吸附剂,对活性红23与活性蓝4、活性黄4、酸性黑1、酸性蓝193的混合染料溶液进行吸附性能研究.结果表明,在不同的混合体系中,活性红23的脱色率基本保持在60%~70%;体系中酸性染料的脱色率均超过90%;活性蓝4的脱色率高达85%;活性黄4的脱色率仅为50%.准二级吸附动力学能够更好地描述粉煤灰对水溶性混合染料的吸附过程.染料在溶液中的外扩散系数均为10-4cm·s-1数量级,染料在粉煤灰颗粒的内扩散系数为10-8cm2·s-1数量级.根据BN数,水溶性染料在粉煤灰上的竞争吸附是外扩散控制的吸附过程.     

污泥灰渣中重金属煅烧脱除规律研究及安全性评价

污泥目前被认为是磷酸盐矿的二次资源,焚烧处理可实现污泥中磷资源的浓缩富集,但其中重金属毒性问题尚待解决.该文以污泥焚烧灰渣为研究对象,利用马弗炉进行煅烧实验,通过改变反应时间(从10 min到60 min)、温度(从900℃到1200℃)及CaCl2的添加量(以Cl计,从1.5%到8.0%)研究重金属(Pb、Zn和Cu)的去除率及在煅烧灰渣中的赋存形态.结果表明:Pb有较高的去除率,且其去除率均随温度、时间及Cl含量的升高而升高,在1200℃、Cl含量为5.0%的时候有最大值为82.4%;Zn的去除率受温度的影响较大,高温时Zn有较高的去除率,且在1100℃时有最大值为83.9%;Cu的去除率较低,而在温度为1100℃时有最大的去除率为68.2%.就煅烧灰渣中重金属的赋存形态而言,各种工况下Pb在煅烧灰渣中均以残渣态存在;Zn在煅烧灰渣中主要也是以残渣态存在;Cu在煅烧后还存在一定的酸溶态,在900℃、煅烧10min时煅烧灰渣中酸溶态可达29.2%.增加CaCl2的添加量可以促进重金属的去除,同时使煅烧底渣中的重金属更稳定.地累积指数(Igeo)评价结果显示,煅烧底渣中的这3种重金属的污染程度都降低了.