粉煤灰及改性粉煤灰对邻甲酚吸附性能的研究

研究了水溶液中粉煤灰(FA)和浸渍粉煤灰(IFA)吸附有害的邻甲酚,试验了颗粒大小、浸渍条件、pH值和温度等因素对吸附量的影响.结果表明,在稀溶液中进行吸附时,提高温度、减小粒径和pH值,可增加粉煤灰对邻甲酚的吸附量;用Al3+离子浸渍的粉煤灰具有较大的吸附量;吸附过程机理主要是多孔物质和静电作用的共同结果所致.     

城市污泥和粉煤灰配施影响砂化土壤微生物区系的实验研究

目前,对利用城市污泥和粉煤灰改良土壤的研究大多集中在二者对土壤理化特性、作物产量以及重金属累积的影响等方面,而对土壤微生物区系进行研究的相对较少。为了了解城市污泥和粉煤灰改良砂化土壤对土壤微生物区系的影响,文章对包头试验田改良前后土壤微生物区系进行了比较,研究发现,刚刚改良后,土壤中微生物数量较对照组明显增加;在改良后的最初2个月内,细菌和放线菌的数量有所减少,真菌数量少量增加;改良后2～5个月内,改良后土壤中微生物数量较对照组增加幅度显著,细菌、放线菌和真菌数量分别增加79.53%～589.76%,46.53%～270%,61.92%～143.59%,且微生物数量增加的幅度随着时间的延长,呈上升的趋势。     

Tailor-made FAU zeolite composite membrane for wastewater treatment

In this work, a novel multipurpose Faujasite (FAU) zeolite composite membrane was fabricated by in-situ hydrothermal method to separate different solute molecules such as vanillic acid, phenol, and brilliant green from the aqueous solution. The coal fly ash based ceramic substrate was synthesized and used as substrate for preparing the zeolite composite membrane. The X-ray diffraction (XRD) pattern confirmed the crystalline nature of membranes and the presence of Quartz and hematite in the composite membrane. The presence of Si-O and Al-O in zeolite coated composite membrane was confirmed by Fourier Transform infrared spectroscopy (FTIR) analysis. Scanning electron microscope (SEM) analysis showed the porous structure and 8.34 μm thickness of zeolite coating on membrane. The isoelectric point of composite membrane was observed at pH 2.07 through zeta potential analysis. Brunauer-Emmett-Teller (BET) surface area, average pore volume and pore diameter of zeolite composite membrane were estimated as 6.406 m²/gm, 0.0070 cm³/gm, and 4.371 nm, respectively. The hydraulic pore radius and porosity of composite membranes were 27.7 nm and 20.1%. The maximum separation efficiency of FAU zeolite composite membrane towards vanillic acid, phenol and brilliant green was estimated as 78.67%, 89.13%, and 94.28%, respectively, for 200 mg/L feed concentration at 276 kPa applied pressure. The results obtained in this study reveals that the multipurpose FAU zeolite composite membrane fabricated in this study can be effectively used for separation of various solutes molecules present in the wastewater.     

混凝吸附法深度处理焦化废水

采用混凝吸附法对丹东某焦化厂的焦化废水进行深度处理。混凝剂为聚合氯化铝,助凝剂为聚丙烯酰胺,吸附剂为粉煤灰,当聚合氯化铝的投加量为0.4g/L,聚丙烯酰胺的投加量为4mg/L,粉煤灰的投加量为0.9g/L时,采用混凝剂和吸附剂同时加入的方式,可使COD值降至41mg/L、色度为50倍,达到辽宁地方排放标准,处理成本仅为0.74元/t。     

生活垃圾焚烧飞灰制陶瓷砖

分析了飞灰的性质,利用飞灰、黄陶土、缸砂及文石研制陶瓷砖,并进行正交配比试验。结果表明:飞灰主要矿物成分是硅酸盐及铝硅酸盐,可用作陶瓷砖的原材料;飞灰的掺加量对陶瓷砖表观质量起决定性影响,最佳配比方案为飞灰25%,黄陶土55%,缸砂10%,文石10%;最佳配比制品浸出毒性均达标。     

Na_3PO_4-粉煤灰胶结材组合工艺处理垃圾焚烧飞灰

垃圾焚烧飞灰由于重金属含量高,被认为是危险废物,必须要加以稳定化处理。Na3PO4-粉煤灰组合工艺被用来稳定-固化焚烧飞灰中的重金属。结果表明,Na3PO4稳定-粉煤灰胶结材固化组合处理飞灰降低重金属浸出浓度明显,1.5%Na3PO4,25%掺量的粉煤灰胶结材固化飞灰后,养护7 d即可满足填埋标准。     

不同渗滤条件下垃圾焚烧飞灰中重金属的渗滤特性

对垃圾焚烧飞灰在酸性及碱性条件下的渗滤特性进行了实验研究,结果表明,重金属Pb、Zn、Ni、Cr及Hg存在相似的渗滤规律,即在酸性及碱性(pH>12)条件下均有一定的渗滤,且渗滤量随着渗滤液浓度及液固比(L/S)的增加而增加,如对于Pb在酸、碱2种渗滤环境下,当液固比由20增加到40时,渗出量分别由0.457 mg/kg、51.142 mg/kg增加到104.576 mg/kg、59.692 mg/kg.而Cd、Cu只在酸性环境下存在渗滤情况,在碱性环境下几乎没有渗滤,在酸性环境下对于所研究的几种重金属,Cd、Pb、Zn的渗出率较高,而其余几个重金属的渗滤相对较少.     

煤矸石和粉煤灰pH与电导率动态变化规律及其相关性研究

煤矸石和粉煤灰是煤矿区两种常见的固体废弃物,对环境造成极大的污染。pH波动幅度大是废弃物农用治理的主要障碍之一。对两种废弃物连续浸提时的pH和电导率(EC)进行长期动态监测,结果表明,不同层次的煤矸石尽管风化程度不同,但经过长时间浸取后,pH和EC变化趋势相似,且煤矸石、粉煤灰的pH、EC值有很大的相关性。该试验为今后两种废弃物合理利用奠定了基础。     

A novel approach to preparing ultra-lightweight ceramsite with a large amount of fly ash

•Ultra-lightweight ceramsite is prepared with 80% fly ash. •SiO₂, Al₂O₃, and flux contents significantly influence the performance of ceramsite. •The expansion of ceramsite is caused by the formation of a dense glaze and gas. •The bulk density of ultra-lightweight ceramsite is only 340 kg/m³. The disposal of fly ash has become a serious problem in China due to its rapid increase in volume in recent years. The most common method of fly ash disposal is solidification-stabilization-landfill, and the most common reuse is low-value-added building materials. A novel processing method for preparing ultra-lightweight ceramsite with fly ash was developed. The results show that the optimal parameters for preparation of ultra-lightweight ceramsite are as follows: mass ratio of fly ash:kaolin:diatomite= 80:15:5, preheating temperature of 800°C, preheating time of 5 min, sintering temperature of 1220°C, and sintering time of 10 min. The expansion agent is perlite, at 10 wt.% addition. Finally, a ceramsite with bulk density of 340 kg/m³, particle density of 0.68 g/cm³, and cylinder compressive strength of 1.02 MPa was obtained. Because of its low density and high porosity, ultra-lightweight ceramsite has excellent thermal insulation performance, and its strength is generally low, so it is usually used in the production of thermal insulation concrete and its products. The formation of a liquid-phase component on the surface, and generation of a gas phase inside ceramsite during the sintering process, make it possible to control the production of the suitable liquid phase and gas in this system, resulting in an optimization of the expansion behavior and microstructure of ceramsite. These characteristics show the feasibility of industrial applications of fly ash for the production of ultra-lightweight ceramsite, which could not only produce economic benefits, but also conserve land resources and protect the environment.     

MSWI BA treated with Advanced Dry Recovery: a field scale study on materials’ leaching properties

In many European countries, the environmental properties of waste-derived aggregates are mostly assessed based on laboratory leaching tests such as the standardised percolation tests CEN/TS/14405, ISO/TS 21268-3, or DIN 19528. These tests are conducted under specified conditions, which are similar yet somewhat different from realistic field conditions. Therefore, this study aimed to investigate the leaching properties of ADR (Advanced Dry Recovery) recovered MSWI BA in the field in order to understand more about its environmental impacts in actual civil engineering structures. Two field scale studies (a lysimeter and a larger interim storage field study) were constructed and the leachate quality was investigated. These results were then complemented with the results of previously conducted laboratory leaching tests using a liquid to solid ratio (L kg^?1) comparison. The results demonstrated that the leaching behaviours of many potentially harmful substances, such as chloride, copper and antimony, was similar despite the study scale. In addition, this study illustrated the importance of investigating the leaching properties of waste-derived aggregates on a larger scale, even though the uncertainties in such studies may not be easily controlled.