低床层烟炱吸附法脱硫试验及机理探讨

研究了以锅炉烟气沉降物为吸附剂的烟炱吸附法脱除SO2的工艺条件，结果表明该法较适宜的工艺条件为SO2浓度小于2400mg/L,烟气流速小于36m/h，烟气温度低于100℃，此时脱硫效率可达30％以上。初步探讨了烟炱吸附法脱硫的作用机理。     

稻米和土壤中农美利残留量气相色谱分析方法的研究

建立了测定稻田土壤、稻米中农美利残留量的气相色谱分析方法。用配有NPD的气相色谱仪、DB-1301毛细管柱测定稻田土壤及稻米中农美利的残留量，最低检测浓度为0．01mg／kg、平均回收率为80．4％-99．8％，变异系数为6．3％-11．7％，均达到残留分析的要求。     

过滤捕集法处理含DEP雾废气的研究

为了探讨玻璃纤维过滤器处理含DEP雾废气的效率问题,在实验室进行了DEP雾去除实验。考查了不同气体入口浓度、过滤流速下玻璃纤维过滤捕集装置对含DEP雾废气的净化能力,结果表明:利用玻璃纤维过滤器去除DEP雾,在DEP雾粒径主要分布为0.48～3.4μm之间,DEP雾浓度小于220 mg/m3,过滤流速小于10 cm/s情况下,玻璃纤维过滤器对DEP雾的去除率大于99%,最大气体流量下的压力降小于1610Pa;同时对含油(酸)雾废气除雾效果好,特别是对于粒径特别细微的油(酸)雾,捕集效率也很高,还可回收利用,不会产生二次污染。     

常用氧化剂性能研究

用四种常用的氧化剂:高锰酸钾、漂白粉、NaClO和H2O2/Fe2+对大港油田港深11井酸化废水进行了处理。考察了氧化剂的投加量、氧化时间和pH值对酸化废水色度和COD去除率的影响。实验结果表明,在最佳条件下,H2O2/Fe2+对酸化废水的色度和COD的去除率最高;用高锰酸钾处理废水,其COD去除率较高,但脱色效果差;而漂白粉和NaClO的脱色率较高,但其氧化能力有限。建议油田用氧化法处理废水时应采用H2O2/Fe2+催化氧化体系。     

化学活化法制取污泥衍生吸附剂的实验研究

用有机污泥按照一定的工艺制作污泥衍生吸附剂。结果表明，氯化锌作为化学活化剂在吸附剂的生成过程中起到了关键作用，热解温度是影响吸附剂性能的最主要因素，750℃是最佳热解温度。     

小型炭素焙烧炉沥青烟气净化技术初探

阐述了颗粒层吸附技术在小型炭素焙烧沥青烟气净化中的应用。     

现代电化学技术与环境保护

介绍了电化学技术在清洁工艺的开发、清洁产品的制备、废水与废气的处理、被污染土壤的修复和环境污染物监测方面的应用情况。电化学技术具有能量利用率高、经济实用以及污染物产生量少或污染物去除率高等特点，在环境保护领域具有广阔的应用前景。     

黄磷尾气现场脱硫试验

黄磷尾气的主要成分是CO，其中含硫杂质主要以硫化氢的形式存在。测定了黄磷尾气中硫化氢、氧气的含量，分别采用吸收、吸附工艺及其组合工艺对黄磷尾气进行了现场脱硫试验，得出了最佳的黄磷尾气净化脱硫工艺，即吸收、活性炭变温吸附。出口气中H2s的质量浓度为1—5mg/m^3，净化效率达到99．7％。     

Chemical Composition and Acidity of Rain at the Gulf of Iskenderun,North-East Mediterranean

The purpose of the present work was to investigate the chemistry of rain in the Gulf of Iskenderun, North East Mediterranean, Turkey. The Gulf region has a large number of industries. Main industries existing in the region are iron and steel works, fertilizer plants, a cement plant, and several medium and mini size steel mills in addition to the international pipe line terminals. This study aims to apportion the local sources contributing to the overall pollution of the region. To this end a precipitation sampling program was started in January 2000, and over 48 precipitation samples were collected from each of 5 stations located at Iskenderun city center, Iskenderun industrial zone, Payas city center, the campus of Iskenderun Technical College and the campus of Mustafa Kemal University. Samples were analysed for pH, NO₃ ⁺, Cl^-. Ca, Al, Ba, Na, Cd, Co, Cr, Cu, Pb, Li, Mg, Mn, Ni, Zn, Fe, K. Concentrations of metal ions were determined by ICP-AES. NO₃ ^- ions and pH were determined by using NO₃ ^- selective electrode and pH meter, respectively.pH values of the collected samples at the industrial zone and at Payas city center, ranged between 5.02 and 7.38, respectively. NO₃ ^- and metal ions concentrations were highly variable. Concentrations of Ca and Fe ions were higher in the industrial zone and Payas city center. In the other three stations, concentrations of metal ions and NO₃ ^- ion were lower than that of industrial zone and the values of pH ranged between 6 and 7.4. The average pH values at Iskenderun Gulf showed that the precipitation was not acidic, because of the high concentration of Ca. The highest concentrations of Na and Cl ions were recorded in the University campus because the campus is located by the Mediterranean Sea.     

Drying of granulated wood ash by flue gas from saw dust and natural gas combustion

At the district heating plant of Kalmar, Sweden an on-line unit for production of granulated wood ash for nutrient recycling on forest soils is being applied. Currently, the granules are dried by hot air from an oil-fired burner. The objective of this work was to investigate how drying by flue gas affects the hardening of granules, or impacts their chemical composition and properties. Ninety-six granule samples were treated by flue gas from natural gas combustion in a laboratory pilot scale flue gas generator. CO₂, CO, O₂, C₃H₈ and NO concentrations were varied during the experiment. Additionally, some samples were treated by flue gas from combustion of sawdust at the heating plant in Kalmar. Drying by flue gases did not affect the chemical composition of granules, but minor effects were seen in their mineralogy. The carbonate content was slightly higher in granules treated with flue gas from natural gas combustion compared to the granules dried by hot air only, when measured by wet chemical methods. Results from XRD analysis imply that the calcite content is higher and the portlandite and arcanite content slightly less in granules treated with flue gas from sawdust combustion compared to the granules dried by hot air only. The results from this investigation showed no negative effects on ash granule composition or physical structure by the use of a flue as a drying medium.