聚合氯化铝铁去除微污染水体中藻类的研究

以聚合氯化铝铁(PAFC)为絮凝剂,H2O2为预氧化剂,用正交实验研究了PAFC处理微污染水体中藻类和降低浊度,得出正交实验中各因素的主次关系及对除藻和除浊度的影响,研究表明,ρPAFC是影响除藻和除浊度的重要因素.在最佳处理条件,即ρPAFC为20 mg/L,ρH2O2为6 mg/L,pH为7,搅拌时间为4 min,能使水体中藻细胞街度从9.4×107 cells/L降至3.16×106 cells/L,除藻率为96.6%,浊度降至0.70 NTU,除浊度率达93.0%.     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

N掺杂TiO_2光催化剂的制备及其H_2O_2改性的研究

以钛酸四丁酯为前驱物,采用水解沉淀法制备了N掺杂TiO_2光催化剂和H_2O_2改性的N掺杂TiO_2光催化剂.实验表明,H_2O_2改性的N掺杂TiO_2光催化剂的最佳制备条件为:氨水(质量分数28%)加入量20 mL,焙烧温度500 ℃,H_2O_2(质量分数30%)加入量2.0 mL.日光下,N掺杂TiO_2光催化剂及H_2O_2改性的N掺杂TiO_2光催化剂在反应90 min时的活性红紫去除率达99%,它们对活性红紫的去除率远高于P_(25)TiO_2光催化剂.H_2O_2改性的N掺杂TiO_2光催化剂中N质量分数比改性前明显提高,制备的两种催化剂中不仅含有N元素,同时还含有C和H元素.     

模糊事故树在分析氯乙烯单体槽爆炸风险中的应用

在对氯乙烯单体槽爆炸事故构建事故树的基础上,根据现场设备实际运行状况的统计及依据专家经验所提供的模糊信息,运用模糊事故树理论,引入L-R型模糊数,应用其尖态型隶属函数,对氯乙烯单体槽进行了模糊可靠性分析,求出了氯乙烯单体槽爆炸事故的模糊概率可能性分布;并利用结构重要度系数近似值法对其进行结构重要度分析,运用对事故树底部事件进行排序分级的加权结构重要度分析法,确立了影响系统的最主要因素,为系统安全分析提供了新的方法和途径。     

Seasonal Differences in the Levels of Gaseous Air Pollutants in the Vicinity of a Waste Dump

Hydrogen sulphide, ammonia, nitrogen dioxide, mercaptans and sulphur dioxide (H₂S, NH₃, NO₂, R-SH, SO₂) concentrations were measured at the location in the vicinity of the waste dump to determine the air pollution level of these pollutants prior to the operation of the Mobile Thermal Treatment Plant. Samples were collected over one year period. Seasonal differences, and the influence of meteorological parameters (temperature, relative humidity, pressure and wind direction) on the air pollution levels were studied. Results show relatively low concentrations of H₂S, NO₂, R-SH and SO₂, while NH₃ levels were higher compared to the guideline values. Good weather conditions (high air pressure and low relative humidity) are connected to long range transport of NO₂, while higher temperatures result in elevated NH₃ and R-SH concentrations. Because of the predominant northeast wind direction (the same as the waste dump direction), the contribution of air pollution from the direction of the waste dump at the measuring site is significant, but that does not necessarily mean that the pollutants originated from that source.     

铝铁锡共聚物的合成及其特性研究

合成制备了铝铁锡共聚物,测定分析了其水解共聚合和熟化过程中的pH变化,并通过扫描电镜和混凝实验对共聚物的晶形貌像和絮凝作用进行了研究。结果表明：Sn^4 具有比Fe^3 ,Al^3 更强的水解活性,它有使共聚物的分子趋于均一的作用;铝铁锡共聚物的最佳配比为：NAl∶NFe∶NSn=5∶5∶3,最佳水解度B^*＝2．0,此共聚物具有比CPAFC更优良的絮凝性能。     

微波强化CWPO工艺CuO_x-CeO_2/GAC催化剂的制备及其对二甲亚砜的降解

以颗粒活性炭(GAC)为载体、铜为活性组分、铈为助剂组分、草酸钠为沉淀剂,采用浸渍焙烧法制得CuO_x-CeO_2/GAC催化剂。以H_2O_2为氧化剂,微波强化催化湿式过氧化氢氧化(CWPO)处理二甲亚砜(DMSO)初始质量浓度为1 000 mg/L的废水,处理3 min后DMSO去除率达93.8%。催化剂第7次使用时DMSO去除率仍保持在75%以上。初始废水pH在3~9范围内,DMSO去除率均在85%以上。助剂Ce的加入提高了催化剂表面活性组分的分散性和稳定性,使催化剂的活性稳定性和使用寿命显著提高。     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

Techno-economic and environmental analysis of an integrated standalone hybrid solar hydrogen system to supply CCHP loads of a greenhouse in Iran

The techno-economic and environmental performance of hybrid solar hydrogen energy systems was investigated to provide combined cooling, heating and power (CCHP) demands of a standalone greenhouse in Iran to achieve sustainable agriculture based on an optimization procedure. From the environmental point of view, by deploying hybrid energy systems, 83%, to 100% of emissions can be avoided. Also a sensitivity analysis was performed on the hybrid energy systems in order to study the effect of major parameter variation on the systems justification. It was concluded that hybrid solar systems are economically competitive with conventional systems, for high solar intensity locations with high diesel fuel prices and decreased prices for PV and hydrogen storage technology.     

O3-H2O2氧化法处理印染废水

采用O₃-H₂O₂氧化法对印染废水进行氧化处理,比较了O₃氧化法和O₃-H₂O₂氧化法对印染废水的处理效果,考察了初始废水pH、H₂O₂加入量、O₃流量和反应时间对废水的色度去除率和COD去除率的影响。实验结果表明：O₃-H₂O₂氧化法对废水的COD和色度的去除效果比O₃氧化法更好;在初始废水pH为11、H₂O₂加入量为13mmol/L、O₃流量为6g/h、反应时间为60min的最佳工艺条件下,处理后废水COD为61.50mg/L,COD去除率为95.73%,废水色度为5倍,色度去除率为99.75%,TOC为37.84mg/L,TOC去除率为85.10%,BOD₅为22.76mg/L,BOD₅去除率为90.20%,BOD₅/COD为0.37。