聚合氯化铝污泥对磷的吸附动力学及热力学

聚合氯化铝污泥（polyaluminium chloride sludge,PACS）是指以聚合氯化铝（PAC）为混凝剂的城镇给水厂在生产过程中所产生的污泥。采用批量吸附实验考察了PACS对磷的吸附动力学及热力学行为。结果表明,吸附反应发生1 h后,PACS对磷的吸附量达到平衡吸附量的75%～90%,随后PACS对磷的...     

Low‐concentration hydrogen peroxide decontamination for Bacillus spore contamination in buildings

Remediation and recovery efforts after a release of Bacillus anthracis (anthrax) spores may be difficult and costly. In addition, response and recovery technologies may be focused on critical resources, leaving the small business or homeowner without remediation options. This study evaluates the efficacy of relatively low levels of hydrogen peroxide vapor (HPV) delivered from off‐the‐shelf equipment for the inactivation of Bacillus spores within an indoor environment. Decontamination evaluations were conducted in a house using both Bacillus atrophaeus var. globigii (Bg; as surrogates for B. anthracis) inoculated on the carpet and galvanized metal as coupons and Geobacillus stearothermophilus (Gs) as biological indicators on steel. The total decontamination time ranged from 4 to 7 days. Using the longer exposure times, low concentrations of HPV (average levels below 20 parts per million) effectively inactivated Bg and Gs spores on the materials tested. The HPV was generated with commercial humidifiers and household‐strength hydrogen peroxide solutions. The presence of home furnishings did not have a significant impact on HPV efficacy. This simple, inexpensive, and effective decontamination method could have significant utility for remediation following a B. anthracis spore release, such as following a terrorist attack.     

Techno-economic and environmental analysis of an integrated standalone hybrid solar hydrogen system to supply CCHP loads of a greenhouse in Iran

The techno-economic and environmental performance of hybrid solar hydrogen energy systems was investigated to provide combined cooling, heating and power (CCHP) demands of a standalone greenhouse in Iran to achieve sustainable agriculture based on an optimization procedure. From the environmental point of view, by deploying hybrid energy systems, 83%, to 100% of emissions can be avoided. Also a sensitivity analysis was performed on the hybrid energy systems in order to study the effect of major parameter variation on the systems justification. It was concluded that hybrid solar systems are economically competitive with conventional systems, for high solar intensity locations with high diesel fuel prices and decreased prices for PV and hydrogen storage technology.     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

聚合氯化铝铁去除微污染水体中藻类的研究

以聚合氯化铝铁(PAFC)为絮凝剂,H2O2为预氧化剂,用正交实验研究了PAFC处理微污染水体中藻类和降低浊度,得出正交实验中各因素的主次关系及对除藻和除浊度的影响,研究表明,ρPAFC是影响除藻和除浊度的重要因素.在最佳处理条件,即ρPAFC为20 mg/L,ρH2O2为6 mg/L,pH为7,搅拌时间为4 min,能使水体中藻细胞街度从9.4×107 cells/L降至3.16×106 cells/L,除藻率为96.6%,浊度降至0.70 NTU,除浊度率达93.0%.     

纳米级聚合氯化铝处理石化废水絮凝效果研究

采用自制的纳米级聚合氯化铝絮凝荆处理石大科技股份公司胜华炼油厂隔油池出水,以处理后水样的透光率作为混凝沉降效果的评价指标,并对絮凝剂投加量、搅拌速度、搅拌时间等影响混凝效果的因素进行了研究。试验表明,聚合氯化铝对石化废水的处理达到较为理想的效果,聚合氯化铝混凝处理石化废水的最佳条件为：纳米级聚合氯化铝投加量为15mg／L左右,慢速搅拌的搅拌速度为50～60rpm,快速搅拌的搅拌速度为190—225rpm,快速搅拌时间90s。慢速搅时间10min时效果最佳。使用Al-Ferron逐时络合比色法及XRD对絮凝荆进行了表征,结果证实样品中Alb含量可达到85％左右。     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

N掺杂TiO_2光催化剂的制备及其H_2O_2改性的研究

以钛酸四丁酯为前驱物,采用水解沉淀法制备了N掺杂TiO_2光催化剂和H_2O_2改性的N掺杂TiO_2光催化剂.实验表明,H_2O_2改性的N掺杂TiO_2光催化剂的最佳制备条件为:氨水(质量分数28%)加入量20 mL,焙烧温度500 ℃,H_2O_2(质量分数30%)加入量2.0 mL.日光下,N掺杂TiO_2光催化剂及H_2O_2改性的N掺杂TiO_2光催化剂在反应90 min时的活性红紫去除率达99%,它们对活性红紫的去除率远高于P_(25)TiO_2光催化剂.H_2O_2改性的N掺杂TiO_2光催化剂中N质量分数比改性前明显提高,制备的两种催化剂中不仅含有N元素,同时还含有C和H元素.     

模糊事故树在分析氯乙烯单体槽爆炸风险中的应用

在对氯乙烯单体槽爆炸事故构建事故树的基础上,根据现场设备实际运行状况的统计及依据专家经验所提供的模糊信息,运用模糊事故树理论,引入L-R型模糊数,应用其尖态型隶属函数,对氯乙烯单体槽进行了模糊可靠性分析,求出了氯乙烯单体槽爆炸事故的模糊概率可能性分布;并利用结构重要度系数近似值法对其进行结构重要度分析,运用对事故树底部事件进行排序分级的加权结构重要度分析法,确立了影响系统的最主要因素,为系统安全分析提供了新的方法和途径。     

铂载钴钼二元硫化物对H_2S电催化活性研究

为考察溶胶凝胶法制备的Co-Mo二元硫化物对H_2S气体的电催化活性,通过循环伏安法和Tafel曲线分析对铂载不同Co、Mo掺杂比的电催化剂进行表征.结果表明,不同阳极电催化剂交换电流密度J_0由大到小依次为,铂载n(Co):n(Mo)=2:3、铂载n(Co):n(Mo)=2:1、铂载n(Co):n(Mo)=1:1和铂,即铂载n(Co):n(Mo)=2:3阳极电催化剂具有较好的活性,这与循环伏安曲线测试结果一致.电解质溶液pH值为6～7时,随着温度的升高铂载n(co):n(Mo)=2:3阳极电催化剂活性呈现上升的趋势.优化后的Co、Mo掺杂原子比约为0.66,此类电催化剂在操作温度80℃下,交换电流密度为1.318mA/cm~2,表观活化焙值为616.6 kJ/mol .研究表明,铂载钴钼二元硫化物适合作为低温H_2S燃料电池阳极电催化剂,其中Co、Mo掺杂比对电催化活性影响较大.