冲击载荷下各向异性煤体渗透-应力敏感性试验研究*

为揭示冲击煤样渗透率的变化规律,通过立式分离式霍普金森（SHPB）冲击装置对不同层理方向煤样进行动态冲击,进而采用渗透仪对冲击后的煤样进行渗透率测试,分析不同冲击荷载下煤岩的渗透率及应力敏感性。结果表明:冲击煤样的渗透率远大于原煤样品,冲击载荷越大,渗透率越大;在相同的冲击载荷和气体压力下,平行于层理方向的煤样渗透率最大,其次是斜交45°层理方向的煤样渗透率,垂直于层理方向的煤样渗透率最小;渗透率受有效应力影响显著;在冲击荷载的作用下,垂直于层理方向煤样渗透率的变化率对孔隙压力更为敏感。     

基于疲劳累积破坏机制的储罐结构动力可靠度分析

针对随机风载荷作用下储罐结构动力可靠性问题,以300 m3的中小型立式低温储罐为研究对象,利用AR模型进行数值模拟得到风载荷的脉动风速时程与脉动功率谱密度函数。采用ANSYS建立储罐三维有限元模型,并对储罐进行动力学分析,计算出储罐结构的随机响应,进而求出随机风载荷作用下储罐结构动力可靠性所需全部数字特征,最后利用疲劳累积损伤机制计算得到储罐的动力可靠度。结果表明:假设结构强度不随时间退化,前5 a动力可靠度基本保持不变,随着使用年限的延长,动力可靠度下降速度明显增大。研究方法可为储罐的动力可靠性及寿命预测提供一定的理论依据。     

混凝沉淀-高级氧化联合处理垃圾转运站污水的实验研究

城市生活垃圾转运站污水具有水质水量变化大、有机污染负荷高、具有强烈恶臭、色度高等显著特点,已成为城市重要的点源污染。为有效消减转运站污水有机负荷,探讨了混凝沉淀-高级氧化联合使用的物化处理方法,考察了联合处理过程中双氧水/亚铁、亚铁投加量、酸化后pH值、混凝剂投加量、中和后pH值等因素对处理效果的影响。小试研究结果表明,在混凝剂投加400 mg/L,亚铁0.06 mol/L,酸化后pH为3,双氧水/亚铁=4∶1,中和后pH为7.5的条件下,污水COD消减量达到60%以上,色度去除率98%,恶臭基本消除。     

Comparison among model estimates of critical loads of acidic deposition using different sources and scales of input data

The critical load (CL) of acidic atmospheric deposition represents the load of acidity deposited from the atmosphere to the earth’s surface at which harmful acidification effects on sensitive biological receptors are thought to occur. In this study, the CL for forest soils was estimated for 27 watersheds throughout the United States using a steady-state mass balance approach based on both national and site-specific data and using different approaches for estimating base cation weathering. Results suggested that the scale and source of input data can have large effects on the calculated CL and that the most important parameter in the steady-state model used to estimate CL is base cation weathering. These results suggest that the data and approach used to estimate weathering must be robust if the calculated CL is to be useful for its intended purpose.     

生物滴滤塔处理氯苯废气的工艺性能

将活性污泥培养及驯化后接种于生物滴滤塔中,挂膜启动后处理模拟氯苯废气（简称氯苯废气）,考察了生物滴滤塔在挂膜启动阶段及稳定运行阶段的性能。实验结果表明：接种41 d后生物滴滤塔成功挂膜,此时氯苯去除率稳定在90%以上;生物滴滤塔稳定运行阶段,随着进气中氯苯质量浓度由303.82 mg/m³逐渐增至1 489.05 mg/m³,氯苯去除率从85.1%降至70.1%。处理氯苯废气适宜的工艺条件为：空塔停留时间超过45 s,喷淋液流量31.8 mL/min,氯苯负荷23.97~128.01 g/（m³·h）。生物滴滤塔对喷淋液的酸性环境有较好的适应性,喷淋液pH的变化对氯苯去除率无显著影响。     

三峡库区香溪河流域非点源营养盐输出变化的试验研究

综合三峡库区香溪河流域土地利用结构和水系特点,在三大支流出口处设置常规水质监测断面,于干流响滩处设置水文控制断面,通过断面水质水量监测,利用数字滤波法解析径流多源和污染多源,研究上游来流点源和非点源营养盐输出负荷变化。结果表明：受农业非点源污染影响,TN是高岚河（0788 mg/L）＞古夫河（0712 mg/L）＞南阳河（0567 mg/L）;南阳河受磷矿企业点源输入的影响,TP是南阳河（0323 mg/L）＞高岚河（0074 mg/L）＞古夫河（0053 mg/L）;断面流量与降雨量的相关系数〖WTBX〗R〖WTBZ〗2=0720 2;TN和TP非点源年负荷输出分别占总量的61%和40%的, 20100607次降雨径流监测分析发现此次降雨汇流期间营养盐TN和TP输出的非点源贡献率分别达752%和709%;营养盐负荷主要受径流量影响,TN和TP输出负荷与流量的相关系数分别是0963 6和0978 9     

近49年中国夏季制冷度日数的变化

利用全国531个气象站1960~2008年逐日平均气温资料,分析了近49 a来我国夏季制冷度日数的变化趋势,并以浙江省为例分析了制冷度日数与夏季空调降温电力负荷的关系。主要结论如下：我国日平均温度等于或高于26℃的日数（1971~2000年平均）大于10 d,夏季有制冷需求的站点主要分布在新疆、四川盆地和太行山 巫山 雪峰山一线以东地区,以及云南干热河谷地区。1960~2008年我国黄河以北地区夏季有制冷需求的站点6~9月平均气温从20世纪90年代中期开始呈现出较明显的上升趋势,使得制冷日数和度日数都相应增加;黄河以南、南岭以北地区近49 a来6~9月平均气温线性趋势不明显,制冷度日数变化不大;南岭以南地区6~9月气温持续上升,夏季制冷度日数的增加最为显著。以浙江省为例的分析显示,制冷度日数与夏季空调降温电力负荷有很好的线性相关关系,可以用来预测降温耗电量。
     

烟囱与吸收塔合一结构分析

通过手工计算和ANSYS有限元软件计算两种方法对安徽新源热电有限公司烟囱与吸收塔合一结构进行结构计算。分析了结构在风载荷、地震载荷作用下的应力和变形,比较了手工计算和有限元电算结果,可为类似工程的计算提供理论参考。     

Automated energy management in distributed electricity systems: An EEPOS approach

The increasing capacity of distributed electricity generation brings new challenges in maintaining a high security and quality of electricity supply. New techniques are required for grid support and power balance. The highest potential for these techniques is to be found on the part of the electricity distribution grid.

This article addresses this potential and presents the EEPOS project’s approach to the automated management of flexible electrical loads in neighborhoods. The management goals are (i) maximum utilization of distributed generation in the local grid, (ii) peak load shaving/congestion management, and (iii) reduction of electricity distribution losses. Contribution to the power balance is considered by applying two-tariff pricing for electricity.

The presented approach to energy management is tested in a hypothetical sensitivity analysis of a distribution feeder with 10 households and 10 photovoltaic (PV) plants with an average daily consumption of electricity of 4.54 kWh per household and a peak PV panel output of 0.38 kW per plant. Energy management shows efficient performance at relatively low capacities of flexible load. At a flexible load capacity of 2.5% (of the average daily electricity consumption), PV generation surplus is compensated by 34–100% depending on solar irradiance. Peak load is reduced by 30% on average. The article also presents the load shifting effect on electricity distribution losses and electricity costs for the grid user.     

An imprecise fuzzy risk approach for water quality management of a river system

Uncertainty plays an important role in water quality management problems. The major sources of uncertainty in a water quality management problem are the random nature of hydrologic variables and imprecision (fuzziness) associated with goals of the dischargers and pollution control agencies (PCA). Many Waste Load Allocation (WLA) problems are solved by considering these two sources of uncertainty. Apart from randomness and fuzziness, missing data in the time series of a hydrologic variable may result in additional uncertainty due to partial ignorance. These uncertainties render the input parameters as imprecise parameters in water quality decision making. In this paper an Imprecise Fuzzy Waste Load Allocation Model (IFWLAM) is developed for water quality management of a river system subject to uncertainty arising from partial ignorance. In a WLA problem, both randomness and imprecision can be addressed simultaneously by fuzzy risk of low water quality. A methodology is developed for the computation of imprecise fuzzy risk of low water quality, when the parameters are characterized by uncertainty due to partial ignorance. A Monte-Carlo simulation is performed to evaluate the imprecise fuzzy risk of low water quality by considering the input variables as imprecise. Fuzzy multiobjective optimization is used to formulate the multiobjective model. The model developed is based on a fuzzy multiobjective optimization problem with max–min as the operator. This usually does not result in a unique solution but gives multiple solutions. Two optimization models are developed to capture all the decision alternatives or multiple solutions. The objective of the two optimization models is to obtain a range of fractional removal levels for the dischargers, such that the resultant fuzzy risk will be within acceptable limits. Specification of a range for fractional removal levels enhances flexibility in decision making. The methodology is demonstrated with a case study of the Tunga–Bhadra river system in India.