水固液微界面氧化还原反应过程与污染物控制研究

本文介绍了3个反应体系,包括铁锰复合氧化物氧化吸附除砷体系、铁氧化物包覆零价铁光芬顿催化和负载型多价态锰氧化物臭氧催化体系,通过固液微界面不同的氧化还原反应,实现了对水中砷和难降解有机污染物的高效去除.重点介绍了不同氧化还原反应对污染物转移转化的作用机制,说明了水体中固液微界面氧化还原反应,对污染物的转移转化起着重要作用.     

生物法净化处理低浓度挥发性有机及恶臭气体

结合课题组研究工作,概要介绍生物法废气净化技术的基础菌种及应用条件、菌种库与菌种批量生产线、初步工业应用等方面的研究成果与应用情况。     

液固比对含重金属水泥熟料制品中重金属释放的影响

通过模拟煅烧试验制取水泥熟料,参照JGJ 55-2000（《普通混凝土配比设计规程》）制取混凝土样品,参考SR003.1和NEN 7375浸出试验,分别研究液固比对粒状及块状混凝土样品中重金属（Cr、Ni和As）释放的影响。结果表明,在不同液固比条件下粒状混凝土中的重金属浸出浓度为Cr>Ni>As,Cr、As浸出浓度基本保持不变,分别为2 500 μg/L左右和5～6 μg/L,Ni在液固比（L∶S）<6时,浸出浓度随着液固比的增加而降低,在L∶S>6时,浸出浓度较稳定,为35.7～41.5 μg/L;浸出量均随着液固比的增加而增大。液固比（L∶S）<10时,块状混凝土中重金属累积释放量及扩散系数均随液固比的增加而增大,当L∶S>10时两者基本保持不变。     

矿渣与工业废渣改良黄土的性能与机理研究进展

黄土在世界上分布面积较广,在我国也有约60×104 km2的分布,具有湿陷性是其区别于其它区域性土的最显著特点,并由此引发造成各种地质灾害和工程问题.采用石灰、水泥或高分子材料等对其进行改性以达到消除湿陷性或提高黄土强度的目的,是岩土工程领域的重要课题.选用矿渣和工业废渣作为改性参料,用以研究改性黄土的力学特性变化和改...     

表面活性剂加强动电技术去除污泥中铜和镉

以实际城市污泥为研究对象,通过采用表面活性剂作为阴极液,并考虑阴极液pH值、表面活性剂类型和电压3种因素对动电技术去除污泥中重金属(铜和镉)的影响,选用正交试验确定最佳试验条件.结果表明,采用表明活性剂作为阴极液加强动电技术去除污泥中重金属足可行的,铜和镉的去除率分别达到11.1%～52.6%和9.1%～46.7%.通过对正交试验结果进行极差和方差分析,试验的最佳条件为:电压为20 V,阴极液加入十六烷基三甲基氯化铵并控制pH值为4～6.表面活性剂的类型对动电技术去除镉具有显著影响.其中,表面活性剂类型对动电过程的影响最大,阴极液pH值次之,电压影响最小.     

垃圾填埋场渗滤液运移规律分析与模拟

基于多孔介质流体力学、多相流以及土壤水动力学理论,利用理论分析和数值模拟相结合的方法,研究了垃圾填埋场中渗滤液运移过程的基本规律,并对填埋场底部可渗和不可渗2种情况下渗滤液的运移规律进行了模拟比对,研究成果可为填埋场渗滤液控制系统的设计和管理提供科学的理论依据和技术支持。     

浙江省危险废物和污泥处置现状及加强全过程监管工作的探讨

随着近几年经济发展水平的提高,浙江省的危险废物和污泥产生量呈不断增长趋势,它们的产生、贮存、转运和处置过程中的监管压力也逐年增大。总结了浙江省的危险废物产生现状,分析了存在的主要问题,对比了发达国家的相关管理经验,提出了进一步完善浙江省危险废物和污泥全过程监管工作的建议。     

邯郸市沁河水污染治理方案

本文对邯郸市沁河水污染现状进行了调查分析,总结了城市内河治理经验,通过方案比较,推荐“清淤,护坡,建坝,分质截污,邯钢废水混凝沉淀处理”为沁河治理方案。     

CFD simulation of MSW combustion and SNCR in a commercial incinerator

A CFD scheme was presented for modeling municipal solid waste (MSW) combustion in a moving-grate incinerator, including the in-bed burning of solid wastes, the out-of-bed burnout of gaseous volatiles, and the selective non-catalytic reduction (SNCR) process between urea (CO(NH₂)₂) and NO_x. The in-bed calculations provided 2-D profiles of the gas–solid temperatures and the gas species concentrations along the bed length, which were then used as inlet conditions for the out-of-bed computations. The over-bed simulations provided the profiles of incident radiation heat flux on the top of bed. A 3-dimensional benchmark simulation was conducted with a 750 t/day commercial incinerator using the present coupling scheme incorporating with a reduced SNCR reduction mechanism. Numerical tests were performed to investigate the effects of operating parameters such as injection position, injection speed and the normalized stoichiometric ratio (NSR) on the SNCR performance. The simulation results showed that the distributions of gas velocity, temperature and NO_x concentration were highly non-uniform, which made the injection position one of the most sensitive operating parameters influencing the SNCR performance of moving grate incinerators. The simulation results also showed that multi-layer injections were needed to meet the EU2000 standard, and a NSR 1.5 was suggested as a compromise of a satisfactory NO_x reduction and reasonable NH₃ slip rates. This work provided useful guides to the design and operation of SNCR process in moving-grate incinerators.     

Stabilization of heavy metals in MSWI fly ash using silica fume

The objective of this work was to investigate the feasibility and effectiveness of silica fume on stabilizing heavy metals in municipal solid waste incineration (MSWI) fly ash. In addition to compressive strength measurements, hydrated pastes were characterized by X-ray diffraction (XRD), thermal-analyses (DTA/TG), and MAS NMR (²⁷Al and ²⁹Si) techniques. It was found that silica fume additions could effectively reduce the leaching of toxic heavy metals. At the addition of 20% silica fume, leaching concentrations for Cu, Pb and Zn of the hydrated paste cured for 7 days decreased from 0.32 mg/L to 0.05 mg/L, 40.99 mg/L to 4.40 mg/L, and 6.96 mg/L to 0.21 mg/L compared with the MSWI fly ash. After curing for 135 days, Cd and Pb in the leachates were not detected, while Cu and Zn concentrations decreased to 0.02 mg/L and 0.03 mg/L. The speciation of Pb and Cd by the modified version of the European Community Bureau of Reference (BCR) extractions showed that these metals converted into more stable state in hydrated pastes of MSWI fly ash in the presence of silica fume. Although exchangeable and weak-acid soluble fractions of Cu and Zn increased with hydration time, silica fume addition of 10% can satisfy the requirement of detoxification for heavy metals investigated in terms of the identification standard of hazardous waste of China.