应用表面活性剂-生物柴油微乳液去除污染土壤中多环芳烃

针对修复焦化厂高浓度多环芳烃污染土壤高成本的现实,采用以非食用性植物油、生物柴油、表面活性剂及其乳化合成的微乳液为淋洗剂,比较不同淋洗剂的淋洗效果。结果表明乳化合成的微乳液对焦化厂土壤中多环芳烃的总去除率高于单独使用表面活性剂为淋洗剂对土壤中多环芳烃的总去除率,说明生物柴油及植物油与表面活性剂乳化形成的微乳液对原污染土壤中的多环芳烃具有显著的增溶作用。1%TW-80和2.5%TW-80对土壤中多环芳烃总去除率分别为11%和14%;以2.5%TW-80为原料乳化合成的微乳液的淋洗去除率较以1%TW-80为原料乳化合成的微乳液高,总去除率分别为15%～30%和11%～18%;以生物柴油为原料乳化合成的微乳液的淋洗去除率较以植物油为原料乳化合成的微乳液高,分别为17%～30%和15%～23%,且对多环芳烃的去除率与其辛醇水分配系数(logKow)呈线性相关关系。     

西安市大气中多环芳烃的季节变化及健康风险评价

对西安市2009年6月-2010年5月空气中的总悬浮颗粒（TSP）和气态样品进行了连续采样,利用GC—MS对16种PAHs进行分析。∑PAHs浓度（气相＋颗粒相）范围为39．93～1032．46ng／m^3,平均值为197．34ng／m^3;其中,冬季大气中∑PAHs浓度最大,相对浓度的范围为31．21％～72．98％,而夏季的浓度最小;检测出16种2～6环的PAHs,其中以3—4环为主。利用特征分子比值法和因子分析进行源解析,发现研究区PAHs的主要来源为燃煤和机动车尾气排放。通过苯并（a）芘（BaP）等效毒性（BEQ）和苯并（a）芘等效致癌浓度（BaPE）进行健康风险评价,结果显示,西安大气中PAHs的毒性具有明显的季节差异,特别是秋季和冬季大气中PAHs对人类的健康存在较大的潜在威胁。     

Sources and distribution of polycyclic aromatic hydrocarbons in sediments from the Spanish northern continental shelf. Assessment of spatial and temporal trends

The distribution of polycyclic aromatic hydrocarbons was determined in surface sediments collected at 36 stations along the Spanish Northern continental shelf in March and September 2003, and February 2005. Concentrations of PAHs (Σ13 parent components) were in the range of 22-47528 μg/kg dw, the highest values corresponding to coastal urban-industrial hotspots and decreasing offshore. Sediment quality guidelines (SQGs) showed that concentrations of total PAHs were below the threshold effect level (TEC) in 27 stations (81%) and above in 7, two of which (Gijon and Bilbao) were above the probable effect concentration (PEC). The detailed study of diagnostic ratios suggested a rather uniform mixture of petrogenic and pyrolytic PAH sources along the continental shelf, with a slight decrease of the latter moving westwards and offshore. In order to assess the incidence of sediment sampling on the variability of the results, selected stations were also monitored in February and September 2004 and September 2005. The average field variance of the values obtained for each station was 31% that decreased to 23% when the values were normalized to TOC.     

Effects of temperature and fertilization on total vs. active bacterial communities exposed to crude and diesel oil pollution in NW Mediterranean Sea

The dynamics of total and active microbial communities were studied in seawater microcosms amended with crude or diesel oil at different temperatures (25, 10 and 4 °C) in the presence/absence of organic fertilization (Inipol EAP 22). Total and hydrocarbon-degrading microbes were enumerated by fluorescence microscopy and Most Probable Number (MPN) method, respectively. Total (16S rDNA-based) vs. active (16S rRNA) bacterial community structure was monitored by Capillary-Electrophoresis Single Strand Conformation Polymorphism (CE-SSCP) fingerprinting. Hydrocarbons were analyzed after 12 weeks of incubation by gas chromatography-mass spectrometry. Total and hydrocarbon-degrading microbial counts were highly influenced by fertilization while no important differences were observed between temperatures. Higher biodegradation levels were observed in fertilized microcosms. Temperature and fertilization induced changes in structure of total bacterial communities. However, fertilization showed a more important effect on active bacterial structure. The calculation of Simpson's diversity index showed similar trends among temperatures whereas fertilization reduced diversity index of both total and active bacterial communities.     

Environmental monitoring of complex hydrocarbon mixtures in water and soil samples after solid phase microextraction using PVC/MWCNTs nanocomposite fiber

A novel nanocomposite based on incorporation of multiwalled carbon nanotubes (MWCNTs) in polyvinyl chloride (PVC) was prepared. Proposed nanocomposite was coated on stainless steel wire by deep coating. Composition of nanocomposite was optimized based on results of morphological studies using scanning electron microscopy. The best composition (83% MWCNTs:17% PVC) was applied as a solid phase microextraction fiber. Complex mixture of aromatic (BTEX) and aliphatic hydrocarbons (C₅–C₃₄) were selected as model analytes, and performance of proposed fiber in extraction of the studied compounds from water and soil samples was evaluated. Analytical merits of the method for water samples (LODs = 0.10–1.10 ng L⁻¹, r² = 0.9940–0.9994) and for soil samples (LODs = 0.10–0.77 ng kg⁻¹, r² = 0.9946–0.9994) showed excellent characteristics of it in ultra trace determination of petroleum type environmental pollutants. Finally, the method was used for determination of target analytes in river water, industrial effluent and soil samples.     

Factors influencing on the bioaccessibility of polybrominated diphenyl ethers in size-specific dust from air conditioner filters

Size-specific concentrations and bioaccessibility of polybrominated diphenyl ethers (PBDEs) in dust from air conditioner filters were measured, and the factors influencing the PBDE bioaccessibility were determined. Generally, the PBDE concentrations increased with decreasing dust particle size, and BDE209 (deca-BDE) was generally the predominant congener. The bioaccessibility ranged from 20.3% to 50.8% for tri- to hepta-BDEs, and from 5.1% to 13.9% for BDE209 in dust fractions of varied particle size. The bioaccessibility of most PBDE congeners decreased with increasing dust particle size. The way of being of PBDE (adsorbed to dust surface or incorporated into polymers) in dust significantly influenced the bioaccessibility. There was a significant negative correlation between the tri- to hepta-BDE bioaccessibility and organic matter (OM) contents in dust. Furthermore, tri- to hepta-BDE bioaccessibility increased with increasing polarity of OMs, while with decreasing aromaticity of OMs. The tri- to hepta-BDE bioaccessibility significantly positively correlated with the surface areas and pore volumes of dust. Using multiple linear regression analysis, it was found that the OM contents and pore volumes of dust were the most important factors to influence the tri- to hepta-BDE bioaccessibility and they could be used to estimate the bioaccessibility of tri- to hepta-BDEs according to the following equation: bioaccessibility (%) = 45.05 − 0.49 × OM% + 1.79 × pore volume. However, BDE209 bioaccessibility did not correlate to any of these factors.     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

Temperature-dependent sorption of polycyclic aromatic hydrocarbons on natural and treated sediments

In aqueous environment temperature is considered to play a significant role in the sorption process of polycyclic aromatic hydrocarbons (PAHs) and its influence on the sorption equilibrium is indicative of sorption energies and mechanisms. In this study, sorptions of five PAHs on three heterogeneous sorbents including one river sediment (YHR), one estuary sediment (YRD) and one treated sediment with organic matter removed (IM) were carried out at a range of temperature from 5 °C to 35 °C. Stronger sorptions were observed at lower temperatures, with the equilibrium sorption coefficient K_d increasing 2-5 times as the temperature decreases 30 °C. The increase of K_d value was attributed primarily to the change of PAH water solubility, which predicted 40-75% of the increase of K_d in the sorption process. To provide insight into the sorption mechanism, enthalpy change (ΔH_S) for the sorption process was calculated and the values were observed to be negative for all of the interactions, suggesting that the exothermal sorption of PAHs inversely dependents on temperature. Based on the values of ΔH_S, van der Waals forces were inferred as the main sorption mechanism for the PAHs, especially on the YHR sediment which contained more organic matter. For sorption of larger size PAHs on the sorbents with low organic matter, specific interactions were deduced to contribute to the overall sorption.     

Temporal and geographical genetic variation in the amphipod Melita plumulosa (Crustacea: Melitidae): Link of a localized change in haplotype frequencies to a chemical spill

Anthropogenic effects such as contamination affect the genetic structure of populations. This study examined the temporal and geographical patterns of genetic diversity among populations of the benthic crustacean amphipod Melita plumulosa in the Parramatta River (Sydney, Australia), following an industrial chemical spill. The spill of an acrylate/methacrylate co-polymer in naphtha solvent occurred in July 2006. M. plumulosa were sampled temporally between December 2006 and November 2009 and spatially in November 2009. Genetic variation was examined at the mitochondrial cytochrome c oxidase subunit I locus. Notably, nucleotide diversity was low and Tajima’s D was significantly negative amongst amphipods collected immediately downstream from the spill for 10 months. We hypothesize that the spill had a significant localized effect on the genetic diversity of M. plumulosa. Alternate explanations include an alternate and unknown toxicant or a localized sampling bias. Future proposed studies will dissect these alternatives.     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.