Optimization of extraction of oil and biodiesel from Thespesia populnea seed oil by alkali catalyst in India

Thespesia populnea oil was new source of biodiesel. Crude Thespesia populnea oil was used as feedstock for biodiesel production by alkali-catalyzed methanolysis. The reaction in the presence of NaOH as catalyst was carried out to investigate the optimum conditions and to study the effects of variables on the reaction. A methanol to oil ratio of 6:1, sodium methoxide catalyst concentration of 1.5%, mixing intensity of 250 rpm and reaction temperature of 60°C offered the best Thespesia populnea seed oil methyl esters (biodiesel) yield (92.6%). The methyl ester content under these optimum conditions was 92.6% w/w, and all of the measured properties of the Thespesia populnea biodiesel (TPME) met the international standards ASTM D 6751-02. The results reveal that all of the reaction variables in this study had positive effects on the reaction. The results of the present study indicated that TPME could be a potential alternative to petrodiesel     

Production of soybean ethanol-based biodiesel using CaO heterogeneous catalysts promoted by Zn,K and Mg

This article focuses on the optimization of the production of fatty acid ethyl esters from soybean oil using CaO-based heterogeneous catalysts. Three different catalytic promoters were evaluated: Magnesium, zinc, and potassium. The reaction has evaluated the promoter content (promoter to calcium molar ratio), catalyst load, alcohol to oil molar ratio, and temperature. Response surface methodology (RSM) was used to evaluate the influence of each variable on the yield of biodiesel. The addition of K₂O or MgO in the catalyst has enhanced the yield in fatty acid ethyl esters, while the use of ZnO as a promoter was not successful.     

The effect of industry activities on public support for ‘fracking’

Research suggests that previous, current, and prospective extractive industry activities influence perceptions of new development. Studies that have drawn this conclusion, however, have usually focused on specific projects in specific communities. Here, these factors are examined on an aggregate, national scale. Combining geospatial data on extractive industry activities and survey data from a nationally representative sample (N = 1061), the influence of extractive industry activities on support for fracking is studied. While limited evidence is found for the impact of proximity to oil and gas wells or production on support for fracking, employment levels in the natural resources and mining sector in the respondent’s county and residence in an area experiencing active oil and gas development significantly increase support for fracking. The results highlight the role of spatial and community factors in shaping support for energy development.     

生活垃圾催化热解液体产物特性

为探索生活垃圾催化热解液体产物特性变化规律,选取Na2CO3、CaO、Fe2O33种催化剂,利用固定床实验、红外分析(FT-IR)进行生活垃圾热解液体产物产率和组分特性研究.结果表明,热解终温600℃无催化剂时,生活垃圾热解液产率为39.80 wt％,添加3种催化剂后热解液产率均降低;生活垃圾分别添加1％的Na2CO3和CaO后,热解油氧含量由22.49％分别降低到20.12％和18.53％,低位热值由30.30 MJ/kg分别提高到33.79和32.74 MJ/kg;无催化剂时热解油成分为脂肪类、含氧化合物及少量芳香类混合物,加催化剂后热解油中芳香类物质峰面积比例显著增加,而含氧化合物峰面积比例降低,羟基类及羧酸类含氧化合物峰面积比例明显减少,其他含氧物峰面积比例却增加;CaO催化效果较明显,生活垃圾添加1％的CaO热解油中芳香类物质峰面积比例从4.36％增加到29.46％,含氧化合物峰面积比例由49.42％降低到23.12％,其中羟基类和羧酸类化合物峰面积比例分别由34.03％和10.65％降低到0.00％和3.34％,其他含氧化合物峰面积比例由4.73％增加到19.77％.     

嗜油菌NY3对蜡质油污泥无害化处理

蜡质油污泥(WOS)成分复杂,含大量老化原油、蜡质油、沥青质及其他化学药剂,属危险性固体废弃物,大量排放已成为石化企业可持续发展的障碍.研究利用铜绿假单胞菌NY3处理高浓度WOS的条件,结果表明,WOS∶木屑(m/m)(d =0.30 mm) 7∶1并结合热熔分散为最佳油污泥预处理条件;液相降解体系含油量为24.5 g/L时,6d内,油泥中C20以下的正构烷烃完全被去除,C21～C34和C35～C38大分子量正构烷烃去除率分别在91％ ～99％和78％ ～ 89％之间.添加鼠李糖脂能明显提高长链烃和多环芳烃的降解率.6d内210 mg/L鼠李糖脂使C29 ～ C38的降解率提高17.27％ ～36.65％,芘、菲分别提高13.67％和16.12％.添加葡萄糖和Fe2+的条件下,NY3菌可将油污泥转化成为糖蛋白,产量达28 g/L.     

用膨润土处理油田污水的研究进展

介绍了膨润土的基本特性及其存油田污水处理中的研究情况。天然膨润土经改性后,可吸附去除油田污水中的油、烃类衍生物、注聚残留聚合物及表面活性剂;负载金属氧化物的改性膨润土可对光催化氧化产生协同效应,提高光催化氧化油田污水中有机物的能力;在高压下将膨润土制成薄膜,对油田污水中的无机离了有一定的截留去除作用。     

化学混凝法去除稠油废水中的硅

以新疆油田稠油废水为研究对象,采用化学混凝除硅方法对稠油废水进行处理。实验结果表明:采用锌复合混凝剂的混凝、软化及镁剂除硅相结合的方法具有较好的除硅效果。确定了最佳除硅配方:NaOH的加入量为500~600mg/L,除硅剂MgCl2.6H2O的加入量为700~800mg/L,锌复合混凝剂加入量为100~150mg/L,处理后废水中SiO2的质量浓度小于50mg/L,达到热采锅炉的用水标准。     

北京地区土壤对柴油的吸附及影响因素研究

通过静态吸附实验,研究了北京地区土壤对柴油的吸附行为,考察了溶液pH和添加乙醇对柴油吸附的影响. 结果表明,6种不同土样对柴油的吸附等温线均较好地符合Langmuir吸附方程,其吸附系数(K)分别为0.193, 0.218, 0.203, 0.199, 0.211和0.182 L/mg,6种土样吸附能力依次为轻壤土>轻粘土>中壤土>砂壤土>重壤土>紧砂土,这主要是由于6种土样的pH,有机质含量和机械组成不同所致;溶液pH的升高,不利于柴油在土壤中的吸附,pH从4升高到10,柴油在1～6号土样中的吸附量分别从1　012, 1　800, 1　377, 1　272, 1　601和862 μg/g降低到114, 236, 163, 150, 201和85 μg/g;向柴油中添加乙醇会减小柴油的吸附量,并且吸附量随添加乙醇量的增大而降低,这有利于柴油的向下运移.      

重庆市废润滑油的污染状况及改善策略的研究

针对重庆市2005年3～9月的半年时间里,仅嘉陵江主城流域内即出现四起重大油污染事故的现象,开展了对重庆市各类废润滑油年均产生量及处理现状的跟踪调研,结果表明:重庆市废润滑油的不当处理,在造成约5.5万t/a宝贵资源大量浪费的同时,还形成了对长江水系的严重污染。为推动重庆市经济的可持续发展和有效的保护环境,对目前在废油处理中存在的问题,进行了深层次原因的分析,并提出解决这些问题的有效措施:完善废油回收处理机制及体系,统一建立一个年处理能力在10万t以上的废油专业再生厂,通过废油再生的产业化实现对资源的最大化利用和对环境污染的最小化。     

潜流人工湿地去除大庆地区湖泊水体中石油类化合物的研究

针对大庆地区石油类化合物污染湖泊水质特点和气候条件,采用包含砾石床、砾石芦苇床、炉渣芦苇床和炉渣床单元的现场试验系统,考察启动期、投加微生物、投加缓释碳源、水温低于5℃和常规运行期等工况下各单元对石油类化合物的去除效果及其去除机理.在整个试验期内4个单元石油类化合物的平均去除率分别为24.7％、28.4％、45.9％和42.9％;投加微生物和缓释碳源都可提高石油类化合物污染物的去除效果;以炉渣为填料的单元污染物去除效果显著优于以砾石为填料的单元.2005年常规运行期间,湿地床和对照床石油类化合物去除率存在显著性差异（p<0.05）,植物对石油类化合物的去除起到显著的促进作用.系统运行期内通过截留去除的石油类化合物占总去除量70％左右,各单元该比例没有显著性差异（p<0.05）.