O／W型乳化液的处理

采用药剂破乳－电解破乳工艺处理Ｏ／Ｗ型乳化液，药剂破乳选用聚合硫酸铁为破乳剂，破乳时最佳ＰＨ为８，聚合硫酸铁的最佳投量为１５００ｍｇ／Ｌ，电解破乳选用铁作阳极，铝作阴极，电流密度０．８６Ａ／ｄｍ＾２，极距２５ｍｍ，电解时间３ｈ。在上述条件下，破乳效果良好，出水清澈透明，ＣＯＤ总去除率可达到９６－９７％。     

聚氯化铝/聚丙烯酰胺复合絮凝剂处理染料废水的研究

研究了聚氯化铝-Fe_3O_4-聚丙烯酰胺复合絮凝剂对硫化黑染料废水的去除效果。研究结果表明,该复合絮凝剂对硫化黑染料废水具有较好的絮凝效果,在絮凝剂投加量为20 mg/L、废水pH值为8.0的条件下,该复合絮凝剂对硫化黑染料废水的浊度、色度、COD的去除率分别为95.59%,97.67%,85.55%。     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.     

模拟阳光下Ag／I-TiO2光催化预处理山核桃加工废水

研究了在模拟太阳光下,采用银修饰的碘掺杂二氧化钛光催化剂（Ag／I—TiO2）对某食品厂山核桃加工废水进行光催化预处理的效果。结合x射线衍射（XRD）、比表面积分析（BET）、紫外-可见漫反射光谱（uV—Vis）的表征结果,来分析催化剂结构对于废水处理效果的影响。探讨了Ag含量、废水初始pH（pHi）和光照时间等因素对化学需氧量（COD）去除及水质可生化性（B／C）提高的影响。并得出适宜的反应参数为：3％Ag含量;pHi为6;光照时间为240min。在最佳条件下,COD去除率45％,废水B／C比由0．17上升到0．31。光催化氧化法能够有效降低山核桃加工废水的COD含量,并达到显著提高废水可生化性的目的。     

移动床生物膜反应器—膜生物反应器深度处理模拟废水及工业园区综合废水

将移动床生物膜反应器(MBBR)与膜生物反应器(MBR)有机结合,研究了该MBBR—MBR串联系统在水力停留时间(HRT)为17.50、11.75h条件下的脱碳脱氮的效果以及对工业园区综合废水污染物的去除情况。结果表明:(1)MBBR—MBR串联系统脱碳脱氮的效果良好,HRT的改变对系统的去除效果有一定的影响,随着总HRT由17.50h变为11.75h,模拟废水中COD的去除效果降低,但氨氮、硝态氮和TN的去除效果基本不受影响。(2)MBBR—MBR串联系统处理印染工业园区综合废水也有较好的效果,当进水COD、氨氮分别为150~450、20~40mg/L时,出水COD、氨氮平均分别为53.1、1.8mg/L,MBBR—MBR串联系统对COD、氨氮的去除率平均分别为80.4%、93.1%,但系统对TN的去除效果不是很理想。     

城市生活污水及二级处理水中手足口病病毒及肠道病毒的赋存状态

手足口病是由多种肠道病毒引起的传染病,其主要病原体有EV71、CVA16及CVA10。为了研究污水处理厂的生活原污水及二级处理水中此类病毒的存活情况,实验利用手足口病3种主要病毒的通用引物对其进行分型检测,同时使用肠道病毒通用引物检测所有肠道病毒,并对常规水质指标进行分析。结果表明,原污水及二级处理水的手足口病病毒阳性率分别为83.3%与36.7%,而肠道病毒阳性率更高达100%及93.3%。说明生活污水中的肠道病毒可以稳定存在,且若未进行有效消毒处理,可能存在于二级处理水中。在3种手足口病主要病毒中,CVA10检出率最高,达45.0%,CVA16及EV71检出率分别为8.3%及10.0%。可推断,CVA10为实验阶段该地区主要的手足口病病毒。通过相关性分析,肠道病毒的存活与水质条件密切相关。     

微电解-Fenton联合工艺预处理煤层气井压裂废水

利用Fenton强化微电解工艺对煤层气井压裂废水展开预处理研究,以COD去除率和可生化性(B/C)为考察指标,单独工艺正交实验结果表明pH为3、反应时间为90 min、铁碳体积比为1.5∶1和pH为4、反应时间为80 min、H2O2投加量为4 mL/L分别是微电解与Fenton反应的最优条件,各可获得48.1%和44.9%的COD去除率。在最优条件下进行微电解-Fenton联合运行实验,连续61 h内COD去除率均稳定在65%以上,B/C由0.158上升到0.3以上,有利于后续生化处理的运行。     

A full-scale sequencing batch reactor system for swine wastewater treatment

A full-scale sequencing batch reactor (SBR) system was evaluated for its ability to remove carbon and nitrogen from swine wastewater. The SBR was operated on four, six-hour cycles each day, with each cycle consisting of 4.5 hours of “React,” 0.75 hours of “Settling”, 0.75 hours for “Draw” and “Fill.” Within each cycle, an amount of wastewater equivalent to about 5% of the reactor volume (5,500 litres) was removed and added. The SBR system was able to remove 82% of biochemical oxygen demand (BOD) and more than 75% of nitrogen. Even though the SBR effluent, with an average effluent BOD₅ of about 588 mg L^{? 1}, did not meet the discharge criteria, it enabled a reduction of the land base required for land application of swine wastewater by about 75%. Results indicated that the SBR system was a viable method for the treatment of swine wastewater.     

阿海水电站新源沟砂石加工废水处理工艺浅谈

新源沟砂石加工系统生产废水SS浓度高,采用水力旋流/加药絮凝/多级沉淀工艺处理,运行结果表明,处理出水水质满足《污水综合排放标准》（GB8978-1996）一级标准中的给定限值70mg/L,达标出水全部回用。     

Ozonation as an advanced oxidant in treatment of bamboo industry wastewater

The present study employed ozonation process to treat the bamboo industry wastewater (BIWW). The impact of ozone dosage and initial organic concentration on color, COD and TOC removal rates were studied along with characterization of the major organics in raw and treated wastewater. The results suggested the ozone dosage of 3.15 g h⁻¹ (concentration 52.5 mg L⁻¹) was suitable for the treatment. After 25 min ozonation of 1 L raw wastewater, the color, COD and TOC removal efficiencies were 95%, 56% and 40%, respectively, with an influent COD concentration of 835 mg L⁻¹. The ratio of kg O₃ kg⁻¹ COD at 3.15 g h⁻¹ was 2.8 (<3), revealing that ozonation was a cost effective process for tertiary treatment of BIWW. Longer oxidization time was required to achieve similar results for raw wastewater with higher COD concentration. The chromatogram from gel permeation chromatography revealed that ozonation resulted in the breakdown of high molecular weight compounds into lower molecular weight components but could not completely mineralize the organic matter. The majority of these compounds were identified in both raw and ozonated samples via GC-MS analysis. In addition to ester derivatives as the main intermediates of ozonation, 1-chloroctadecane, methyl stearate, benzophenone and α-cyperone were identified as the by-products of ozonation.