有机废物厌氧发酵液链延长合成中链脂肪酸研究进展

有机废物产量巨大,具备较高的资源化利用潜力。以有机废物厌氧发酵液为底物,通过链延长工艺生产中链脂肪酸,可有效提升产物的经济价值,因而是一种极具潜力的有机废物资源化方法。梳理了有机废物厌氧发酵液链延长的机理以及影响因素,分析了不同有机废物在厌氧发酵链延长中的作用,并提出了今后研究的方向。学术界已获得的研究结果表明,以混合有机废物作为底物进行厌氧发酵,可以实现氮源和碳源的相互补充,其获得的发酵液中挥发性脂肪酸浓度更高,这对后续的链延长产中链脂肪酸具有良好的促进作用。     

Effect of soil moisture dynamics on dense nonaqueous phase liquid (DNAPL) spill zone architecture in heterogeneous porous media

The amount, location, and form of NAPL in contaminated vadose zones are controlled by the spatial distribution of water saturation and soil permeability, the NAPL spill scenario, water infiltration events, and vapor transport. To evaluate the effects of these processes, we used the three-phase flow simulator STOMP, which includes a new permeability-liquid saturation-capillary pressure (k-S-P) constitutive model. This new constitutive model considers three NAPL forms: free, residual, and trapped. A 2-D vertical cross-section with five stratigraphic layers was assumed, and simulations were performed for seven cases. The conceptual model of the soil heterogeneity was based upon the stratigraphy at the Hanford carbon tetrachloride (CT) spill site. Some cases considered co-disposal of NAPL with large volumes of wastewater, as also occurred at the Hanford CT site. In these cases, the form and location of NAPL were most strongly influenced by high water discharge rates and NAPL evaporation to the atmosphere. In order to investigate the impact of heterogeneity, the hydraulic conductivity within the lower permeability layer was modeled as a realization of a random field having three different classes. For six extreme cases of 100 realizations, the CT mass that reached the water table varied by a factor of two, and was primarily controlled by the degree of lateral connectivity of the low conductivity class within the lowest permeability layer. The grid size at the top boundary had a dramatic impact on NAPL diffusive flux just after the spill event when the NAPL was present near the ground surface. NAPL evaporation with a fine grid spacing at the top boundary decreased CT mass that reached the water table by 74%, compared to the case with a coarse grid spacing, while barometric pumping had a marginal effect for the case of a continuous NAPL spill scenario considered in this work. For low water infiltration rate scenarios, the distribution of water content prior to a NAPL spill event decreased CT mass that reached the water table by 98% and had a significant impact on the formation of trapped NAPL. For all cases simulated, use of the new constitutive model that allows the formation of residual NAPL increased the amount of NAPL retained in the vadose zone. Density-driven advective gas flow from the ground surface controlled vapor migration in strongly anisotropic layers, causing NAPL mass flux to the lower layer to be reduced. These simulations indicate that consideration of the formation of residual and trapped NAPLs and dynamic boundary conditions (e.g., areas, rates, and periods of different NAPL and water discharge and fluctuations of atmospheric pressure) in the context of full three-phase flow are needed, especially for NAPL spill events at the ground surface. In addition, NAPL evaporation, density-driven gas advection, and NAPL vertical movement enhanced by water flow must be considered in order to predict NAPL distribution and migration in the vadose zone.     

液体旋流分离器分离效率的研究

液体旋流分离器是水环境污染治理的主要设备之一.分离效率是衡量液体旋流分离器分离过程进行完善程度的最重要的技术指标,它能从质与量两方面反映出设备性能的优劣.当前液体旋流分离器设计过程还缺少具体量化的理论依据,为了给液体旋流分离器的设计提供理论依据,通过液体旋流分离器从水中分离固体粒子的性能实验,得出了液体旋流分离器各部结构尺寸、形状、相对比例对分离效率的不同影响程度,提出了结构参数的最佳取值范围.按照本研究提出的设计原则和方法,可以制造出性能优良的液体旋流分离器.     

液化气运输过程中的危险分析

应用各种爆炸后果估计模型对液化气运输过程中的爆炸后果进行了评估，并用ETA分析方法对存在的危险进行了分析，指出了控制措施。     

剩余污泥碱性发酵产物对硝化过程及性能的影响

为探究剩余污泥碱性发酵产物作为碳源对硝化过程及性能的影响,建立了以污泥碱性发酵混合物作为碳源的生物脱氮(BNR)系统.投加初期,氨氧化菌(AOB)和亚硝态氮氧化菌(NOB)活性均受到抑制;16 d后AOB活性开始迅速恢复,NOB活性仍受到抑制,比硝态氮积累速率(SNaPR,以N/VSS计)由初始的0.179 1 g·(g·d)^-1下降至0.007 8 g·(g·d)^-1,系统内亚硝积累率由8.12%上升至91.42%并维持稳定.将污泥发酵混合物分离为污泥发酵液和污泥发酵底泥,考察添加3种不同类型的发酵产物对硝化效果良好的全程硝化污泥硝化活性的影响.结果表明,投加污泥碱性发酵混合物和投加碱性发酵液的实验组,NOB活性皆有所下降,SNaPR由初始的0.179 3 g·(g·d)^-1分别下降至0.151 0 g·(g·d)^-1和0.161 7 g·(g·d)^-1;投加发酵底泥的实验组,NOB的活性有所上升,SNaPR由0.179 3 g·(g·d)^-1上升至0....     

填料型A2/O工艺污水处理及反硝化除磷效能

填料型A~2/O工艺是在A~2/O工艺的基础上通过向厌氧池、缺氧池、好氧池中投加醛化纤维式组合填料,将传统活性污泥法与生物膜法相结合组成一套脱氮除磷的新系统,文章对填料型A~2/O工艺与传统A~2/O工艺处理生活污水的效果进行了对比研究,以及对该复合式工艺在不同硝化液回流比下反硝化除磷能力进行了分析.研究结果表明,相同条件下,填料型A~2/O工艺对生活污水的处理效果要优于传统A~2/O工艺,分别使COD和氨氮的去除率达到92.5%和93.1%.试验通过增加硝化液回流比的措施使得反硝化聚磷菌在填料上富集程度增大,当硝化液回流比为300%时,缺氧池的NO-3-N浓度为3.03 mg·L~(-1),吸磷量最大为26.28 mg·L~(-1),胞内聚合物PHB代谢活性最好,利用率最高为1.32 g·g~(-1)·L~(-1).体现了填料型A~2/O工艺具有显著的反硝化除磷效果.     

离子液体对废旧印刷线路板中铜、锌、铅的浸出规律

以离子液体1-丁基磺酸-3-甲基咪唑三氟甲烷磺酸盐([BSO_3HMIm]OTf)为浸出剂,初步研究了WPCBs浸铜过程中锌和铅浸出率的影响因素。实验结果表明:铜、锌的浸出率随着WPCBs粒径的减小、H_2O_2溶液加入量的增大而增大,铜的浸出率随浸出温度的升高先增大后减小,锌的浸出率受浸出温度影响不大;铅的浸出率受5种因素影响不大,且总体处于较低水平。在WPCBs粒径为0.100~0.250 mm、离子液体加入量为60.0%(φ)、H_2O_2溶液加入量为7.5%(φ)、固液比为1∶15、浸出温度为50℃的条件下,铜、锌、铅的浸出率分别为99.84%,93.25%,22.46%。     

高效液相色谱-电感耦合等离子体质谱法测水中不同形态砷

采用高效液相色谱(HPLC)分离水中两种常见的砷形态As(III)、As(V),电感耦合等离子体质谱系统进行检测鉴定,利用C8色谱柱,探讨了甲醇含量、磷酸二氢钾浓度、四丁基氢氧化铵浓度、p H等测试条件,由此建立了水中砷形态的分析方法。结果表明,以1.5 mmol/L磷酸二氢钾、2 mmol/L四丁基氢氧化铵(TBAOH)、5%甲醇作为流动相,调节流动相为p H 5.5,流速为1.4 m L/min,上述两种不同形态的砷可在5.5 min内得以有效分离,As(III)、As(V)检出限分别为0.001、0.01μg/L,定量下限分别为0.005、0.03μg/L。该方法实现了对水中常见的不同形态砷(As(III)、As(V))的同时分析,具有灵敏度高、选择性好、检测速度快的特点,在水质分析领域具有重要意义与应用价值。     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。