硫酸铝渣去除水中磷研究

分别以蒸馏水和太湖水为例,研究了硫酸铝渣去除水中磷的能力,并分析了其对水体Al3+、SO24-以及pH的影响.结果表明:(1)除太湖水pH为9.0、10.0两种条件外,随着磷平衡浓度的增加,硫酸铝渣除磷量趋于某一定值,其规律符合Langmuir吸附等温式;太湖水pH为9.0、10.0两种条件下,硫酸铝渣除磷量符合Fre...     

催化裂解法处理有机硅高沸物

采用催化裂解法处理有机硅高沸物,解决高沸物储存过程中的安全、环保问题。研究了催化剂种类、HCl加入量和精馏高沸物加入量对高沸物转化率的影响。实验结果表明:在以N,N-二丁基-1-丁胺为催化剂、合成高沸物为原料、HCl加入量为13%(w)的条件下,高沸物转化率为83.10%,二甲基二氯硅烷收率为23.78%;合成高沸物中精馏高沸物加入量为9.0%(w)时,高沸物转化率最高,为85.58%。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标,通过单因素实验和正交实验,确定了制备裂解残渣的最佳工艺条件,并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5,制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g;用制备的裂解残渣对苯酚废水进行处理,室温下振荡5 min,苯酚去除率即可达到87.9%,且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.     

Virtues of simple hydro-economic optimization: Baja California, Mexico

This paper uses simple hydro-economic optimization to investigate a wide range of regional water system management options for northern Baja California, Mexico. Hydro-economic optimization models, even with parsimonious model formulations, enable investigation of promising water management portfolios for supplying water to agricultural, environmental and urban users. CALVIN, a generalized hydro-economic model, is used in a case study of Baja California. This drought-prone region faces significant challenges to supply water to agriculture and its fast growing border cities. Water management portfolios include water markets, wastewater reuse, seawater desalination and infrastructure expansions. Water markets provide the flexibility to meet future urban demands; however conveyance capacity limits their use. Wastewater reuse and conveyance expansions are economically promising. At current costs desalination is currently uneconomical for Baja California compared to other alternatives. Even simple hydro-economic models suggest ways to increase efficiency of water management in water scarce areas, and provide an economic basis for evaluating long-term water management solutions.     

Comparison of Function of Created Wetlands of Two Age Classes in Central Pennsylvania

Hydrogeomorphic (HGM) functional assessment models were used to assess whether function in created wetlands of two ages (1 year old and >12 years old) was equivalent to that of natural (reference) mainstem floodplain wetlands. Reference wetlands scored higher than both created age classes for providing energy dissipation and short-term surface water storage. Reference wetlands scored higher in maintaining native plant community and structure than 1-year-old sites, and 12-year-old wetlands scored higher than reference sites for providing vertebrate habitat structure. Analysis of individual model variables showed that reference wetlands had greater vegetative biomass and higher soil organic matter content than both created wetland age classes. Created wetlands were farther from natural wetlands and had smaller mean forest patch sizes within a 1-km-radius circle around the site than did the reference sites, indicating less hydrologic connectivity. Created wetlands also had less microtopographic variation than reference wetlands. The 1-year-old created sites were placed in landscape settings with greater land use diversity and road density than reference sites. The 12-year-old sites had a higher gradient and a higher percentage of their surrounding area in urban land use. These results show that the created wetlands were significantly structurally different (if not functionally so) from reference wetlands even after 12 years. The most profound differences were in hydrology and the characteristics of the surrounding landscape. More attention needs to be focused on placing created wetlands in appropriate settings to encourage proper hydrodynamics, eliminate habitat fragmentation, and minimize the effects of stressors to the site.     

Evaluating the role of environmental quality in the sustainable rural economic development of England

The issue of the sustainable development of rural economies in England has recently received considerable attention. This is because many of the poorest areas in the country are rural, often of high environmental quality, but suffering from high unemployment and a lack of services and facilities. The rapid decline in agricultural incomes and in-migration of affluent urban workers since 1990 has exacerbated economic inequality in such areas. A number of factors have the potential to drive rural development and this paper applies, and considers, the feasibility of a method from the USA for combining economic and environmental variables in a regional growth model to examine the hypothesis that environmental quality is an important determinant of sustainable rural development in England. The model output suggests that, although environmental quality does play a role in sustainable rural development in England there are other, more important, factors driving development. These include business and communications infra-structure, the degree and opportunities for commuting and underlying employment prospects. The robustness and limitations of the method for combining economic and environmental variables is discussed in relation to the spatial interrelatedness of Local Authority Districts in England, and conclusions are drawn about areas for refinement and improvement of the method.

A Multilevel Model of the Impact of Farm‐Level Best Management Practices on Phosphorus Runoff1

Abstract: Multilevel or hierarchical models have been applied for a number of years in the social sciences but only relatively recently in the environmental sciences. These models can be developed in either a frequentist or Bayesian context and have similarities to other methods such as empirical Bayes analysis and random coefficients regression. In essence, multilevel models take advantage of the hierarchical structure that exists in many multivariate datasets; for example, water quality measurements may be taken from individual lakes, lakes are located in various climatic zones, lakes may be natural or man‐made, and so on. The groups, or levels, may effectively yield different responses or behaviors (e.g., nutrient load response in lakes) that often make retaining group membership more effective when developing a predictive model than when working with either all of the data together or working separately with the individuals. Here, we develop a multilevel model of the impact of farm level best management practices (BMPs) on phosphorus runoff. The result of this research is a model with parameters which vary with key practice categories and thus may be used to evaluate the effectiveness of these practices on phosphorus runoff. For example, it was found that the effect of fertilizer application rate on farm‐scale phosphorus loss is a function of the application method, the hydrologic soil group, and the land use (crop type). Further, results indicate that the most effective method for controlling fertilizer loss is through soil injection. In summary, the resultant multilevel model can be used to estimate phosphorus loss from farms and hence serve as a useful tool for BMP selection.     

Kinetics of carbon dioxide absorption into mixed aqueous solutions of MDEA and MEA using a laminar jet apparatus and a numerically solved 2D absorption rate/kinetics model

New comprehensive numerically solved 1D and 2D absorption rate/kinetics models have been developed, for the first time, to interpret the experimental kinetic data obtained with a laminar jet apparatus for the absorption of carbon dioxide (CO₂) in CO₂ loaded mixed solutions of mixed amine system of methyldiethanolamine (MDEA) and monoethanolamine (MEA). Three MDEA/MEA weight ratios ranging from 27/03 to 23/07, over a concentration range of 2.316–1.996 kmol/m³ for MDEA and of 0.490–1.147 kmol/m³ for MEA were studied. The models take into account the coupling between chemical equilibrium, mass transfer, and the chemical kinetics of all possible chemical reactions involved in the CO₂ reaction with MDEA/MEA solvent. The partial differential equations of the 1D model were solved by two numerical techniques; the finite difference method (FDM) based on in-house coded Barakat–Clark scheme and the finite element method (FEM) based on COMSOL software. The FEM comprehensive model was then used to solve the set of partial differential equations in the 2D cylindrical coordinate system setting. Both FDM and FEM produced very accurate results for both the 1D and 2D models, which were much better than our previously published simplified model. The reaction rate constant obtained for MEA blended into MDEA at 298–333 K was k_MEA = 5.127 × 10⁸ exp(−3373.8/T). In addition, the 2D model, for the first time, has provided the concentration profiles of all the species in both the radial and axial directions of the laminar jet, thereby enabling an understanding of the correct sequence in which the reaction steps involved in the reactive absorption of CO₂ in aqueous mixed amines occur.     

Virtues and humanitarian ethics

This paper analyses the contribution of virtue ethics, the study of good character traits, to the humanitarian context. It argues that a virtue ethics perspective paints a realistic picture of the use of ethical standards in morally complex circumstances. Virtuous relief workers can employ standards in their thinking, but they are also committed to professional excellence that goes beyond any formal code. The concept of virtue ethics places a stress on moral development, which can be facilitated by role models that impart modest and feasible ideals. However, virtue ethics cannot provide simple guidelines on how to resolve difficult situations. It is possible that two virtuous persons can disagree on what should be done in a particular instance. In addition, a virtue ethics perspective emphasises the need for both individuals and organisations to discuss the actual purpose of relief work in order to pinpoint the virtues of a good relief professional.