Photosynthesis and related metabolic mechanism of promoted rice (Oryza sativa L.) growth by TiO2 nanoparticles

• The rice growth was promoted by nano-TiO₂ of 0.1–100 mg/L. • Nano-TiO₂ enhanced the energy storage in photosynthesis. • Nano-TiO₂ reduced energy consumption in carbohydrate metabolism and TCA cycle. Titanium dioxide nanoparticle (nano-TiO₂), as an excellent UV absorbent and photo-catalyst, has been widely applied in modern industry, thus inevitably discharged into environment. We proposed that nano-TiO₂ in soil can promote crop yield through photosynthetic and metabolic disturbance, therefore, we investigated the effects of nano-TiO₂ exposure on related physiologic-biochemical properties of rice (Oryza sativa L.). Results showed that rice biomass was increased >30% at every applied dosage (0.1–100 mg/L) of nano-TiO₂. The actual photosynthetic rate (Y(II)) significantly increased by 10.0% and 17.2% in the treatments of 10 and 100 mg/L respectively, indicating an increased energy production from photosynthesis. Besides, non-photochemical quenching (Y(NPQ)) significantly decreased by 19.8%–26.0% of the control in all treatments respectively, representing a decline in heat dissipation. Detailed metabolism fingerprinting further revealed that a fortified transformation of monosaccharides (D-fructose, D-galactose, and D-talose) to disaccharides (D-cellobiose, and D-lactose) was accompanied with a weakened citric acid cycle, confirming the decrease of energy consumption in metabolism. All these results elucidated that nano-TiO₂ promoted rice growth through the upregulation of energy storage in photosynthesis and the downregulation of energy consumption in metabolism. This study provides a mechanistic understanding of the stress-response hormesis of rice after exposure to nano-TiO₂, and provides worthy information on the potential application and risk of nanomaterials in agricultural production.     

碘量法测定水中溶解氧有关问题的探讨及改进

碘量法测定溶解氧时,采用NH3·H2O—KI代替NaOH(KOH)—KI固定溶解氧,用H2SO4—H3PO(41+1)混合酸代替H2SO4溶解沉淀,使沉淀沉降速度加快,分界线明显,沉淀溶解也更完全。同时做样品空白实验,校正了氧化还原性物质产生的干扰,对废水有明显的抗干扰能力。通过对蒸馏水、自来水、池塘水、废水进行溶解氧测定,结果均非常满意。     

二氧化碳水合物储气特性的实验研究

利用二氧化碳水合物小型实验装置分别在恒容和恒压条件下,研究了机械搅拌对二氧化碳气体溶解的影响以及温度与水-气比对二氧化碳水合物形成和储气密度的影响。通过实验结果发现,机械搅拌对二氧化碳的溶解有非常明显的促进作用,可以在3 min内完成溶解过程,促进溶解作用好于添加剂SDS。研究还发现,反应温度越低,二氧化碳水合物的生成速率越快,总的储气量越大,而水-气比越大,储气密度越小。在实验压力3 MPa、反应温度273.55 K的条件下,1体积的水生成水合物后可储存157体积的二氧化碳。     

Petrophysical analysis to investigate the effects of carbon dioxide storage in a subsurface saline aquifer at Ketzin, Germany (CO2SINK)

To test the injection behaviour of CO₂ into brine-saturated rock and to evaluate the dependence of geophysical properties on CO₂ injection, flow and exposure experiments with brine and CO₂ were performed on sandstone samples of the Stuttgart Formation representing potential reservoir rocks for CO₂ storage. The sandstone samples studied are generally fine-grained with porosities between 17 and 32% and permeabilities between 1 and 100 mD.Additional batch experiments were performed to predict the long-term behaviour of geological CO₂ storage. Reservoir rock samples were exposed over a period of several months to CO₂-saturated reservoir fluid in high-pressure vessels under in situ temperature and pressure conditions. Petrophysical parameters, porosity and the pore radius distribution were investigated before and after the experiments by NMR (Nuclear Magnetic Resonance) relaxation and mercury injection. Most of the NMR measurements of the tested samples showed a slight increase of porosity and a higher proportion of large pores.     

电磁阀贮存寿命加速试验技术研究

首先陈述了贮存寿命加速试验的基本原理,介绍电磁阀的结构组成,分析了失效模式和失效机理后,采取恒定应力加速试验方法,然后运用极大似然估计和最小二乘法对数据进行处理,最后得出其贮存寿命等结论。     

Effective communication about complex environmental issues: Perceived quality of information about carbon dioxide capture and storage (CCS) depends on stakeholder collaboration

This experimental research addresses the effectiveness of communication about complex environmental issues, depending on whether the same information is provided by multiple collaborating or by individual organizations (i.e., stakeholders). The information provided pertains to carbon dioxide capture and storage (CCS) technology, as an example of a complex environmental issue. In Studies 1 (N = 75) and 2 (N = 66) we found that participants perceived factual information from collaborating stakeholders to be of higher quality than when the same information was provided by individual stakeholders. As predicted, the expectation of diverse perspectives being represented in the collaborative information mediated this effect. In addition, in Study 3 (N = 79) the perceived dissimilarity of collaborating stakeholders was shown to be an important precondition for the collaboration effect observed in Studies 1 and 2. Finally, these studies indicate that occasional collaboration between different stakeholders does not necessarily harm the perceived credibility of each individual stakeholder.     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.     

中国陆上油藏CO2封存潜力评估

CO2捕集与封存是减缓气候变化的一种关键的碳减排选择方案。将CO2注入油藏作为一种碳埋存方式引起广泛关注。作为判断某一国家、某一区域或某一具体储层是否适合CO2地质封存开展的重要依据之一,有必要在规划碳捕集与封存(CCS)项目前,对潜在的封存库进行封存潜力评估。本文在已有可公开的地质资料的基础上,评估了中国陆上216个油田实施CO2地质封存的潜力,并与相关研究结果进行了比较。结果表明:在满足埋存深度大于800 m的筛选条件下,当假设我国陆上油田全部用于CO2-EOR时,CO2封存潜力约3.6 Gt;当陆上油田全部视为废弃油藏处理时,CO2理论封存潜力约4.6 Gt。其中,东北和华北地区油藏封存CO2潜力巨大,占陆上油田CO2封存总量的60%以上;同时这里CO2集中排放源分布密集,排放源和封存地间的匹配性良好,可以减少CO2运输和封存成本。在这两个地区可以优先考虑实施油藏封存CO2项目。     

中国碳捕集、利用与封存技术研发与示范

碳捕集、利用与封存(CCUS)是一项新兴的、具有大规模减排潜力的技术,有望实现化石能源使用的CO2近零排放,被认为是进行温室气体深度减排最重要的技术路径之一.开展CCUS技术的研发和储备,将为中国未来温室气体减排提供一种重要的战略性技术选择,受到政府、企业和学术界的广泛关注.本文从CCUS技术产生和发展的背景出发,概括了该技术的特点及存在的主要同题,总结了当前中国CCUS技术政策,介绍了中国CCUS技术研发、试点示范、国际合作等的开展情况,并通过与欧美等发达国家CCUS技术发展与示范活动现状的对比,初步分析了中国CCUS技术发展方面存在的主要不足.为进一步推动我国CCUS技术的研发与示范,文章提出应加强国家层面的技术政策指导和宏观协调、引导资源有效配置;推动建设行业间的CCUS技术合作平台;重视CCUS来来技术应用软环境建设等有针对性的建议.     

Mg3MnxAl1-xCO3类水滑石衍生NSR催化剂的制备及其性能评价

采用共沉淀法合成了三元类水滑石Mg_3Mn_xAl_(1-x)CO_3,通过高温煅烧得到其衍生氧化物Mg_3Mn_xAl_(1-x)O_m,再经浸渍负载Pt或BaO后制得新型NO_x存储/再还原(NSR)催化剂。XRD及SEM表征结果显示,当Mn与Al的摩尔比(Mn/Al)大于1时所制备的Mg_3Mn_xAl_(1-x)O_m有杂晶相出现且发生团聚,结合NO_x存储性能评价结果,确定最优Mn/Al为1。BaO负载不利于NO_x的存储,而当Pt负载量为1%(w)时NO_x存储性能最优,250℃条件下的存储量由负载前的0.52 mmol/g提升至0.61 mmol/g。CO_2与NO_x之间存在较强的竞争吸附。负载1%Pt催化剂的NSR性能评价结果表明,8个稀燃-富燃循环后NO_x的去除率为68%,表明催化剂的还原性能仍需加强。