城市生活垃圾机械生物处理效果

采用机械生物处理工艺研究了淋洗水解、脱水与好氧生物干燥对城市生活垃圾的处理效果.结果表明:在淋洗水解及压榨脱水机械生物处理阶段,控制淋洗液与生活垃圾重量比2∶1,停留时间1.2 ～1.4 d条件下,生活垃圾可以减量49.7％.而过程中产生的淋滤液COD为32 939 mg/L、pH为5.1、COD∶N∶P=261∶5∶3.6,可以进行厌氧消化处理或作为碳源进行资源化利用.在好氧生物干燥阶段,通风量采用0.08 m3/min,2～3d堆体温度可升至73℃,7d左右即可产出LCV高达15 000 kJ/kg左右的高品位垃圾衍生燃料(RDF),其产率为38.2％,氯元素含量低于0.5％,重金属含量较低,满足燃料要求.     

以聚己内酯作为生物反硝化固体碳源的研究

为解决水体因低碳氮比而导致脱氮效率差的问题,将颗粒聚己内酯(PCL)重新塑形为阶梯环状,研究其作为反硝化过程的生物膜载体与固相碳源的反硝化性能。结果表明,在静态实验中,平均反硝化速率为8.57 mg NO3-N/(L·h);反硝化过程为零级反应。连续填充床实验中,超过90%的硝酸盐可被去除,出水NO2-N质量浓度低于0.20 mg/L;出水NH3-N质量浓度略有上升;出水溶解性有机碳(DOC)先上升后降低至1 mg/L左右。电子扫描显微镜扫描显示,PCL阶梯环反应表面空隙率较高,表面生物膜以杆菌为主,反应后被明显腐蚀;液相色谱检测显示PCL阶梯环分子量反应前后略有下降,其结构未受到破坏;表明该材料适合作为反硝化反应的碳源的同时,又可以作为载体供微生物附着生长。     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

Sorption and Desorption Behavior of Chloroanilines and Chlorophenols on Montmorillonite and Kaolinite

The bioavailability of pollutants, pesticides and/or their degradation products in soil depends on the strength of their sorption by the different soil components, particularly by the clay minerals. This study reports the sorption-desorption behavior of the environmentally hazardous industrial pollutants and certain pesticides degradation products, 3-chloroaniline, 3,4-dichloroaniline, 2,4,6-trichloroaniline, 4-chlorophenol, 2,4-dichlorophenol and 2,4,6-trichlorophenol on the reference clays kaolinite KGa-1 and Na-montmorillonite SWy-l. In batch studies, 2.0 g of clay were equilibrated with 100.0 mL solutions of each chemical at concentrations ranging from 10.0 to 200.0 mg/L. The uptake of the compounds was deduced from the results of HPLC-UV-Vis analysis. The lipophilic species were best retained by both clay materials. The most lipophilic chemical used in the study, 2,4,6-trichloroaniline, was also the most strongly retained, with sorption of up to 8 mg/g. In desorption experiments, which also relied on HPLC-UV-Vis technique, 2,4,6-trichloroaniline was the least desorbed from montmorillonite. However, on kaolinite all of the compounds under study were irreversibly retained. The experimental data have been modelled according to the Langmuir and Freundlich isotherms. A hypothesis is proposed concerning the sorption mechanism and potential applications of the findings in remediation strategies have been suggested.     

Treating solid dairy manure using microwave-enhanced advanced oxidation process

The microwave enhanced advanced oxidation process (MW/H₂O₂-AOP) was used to treat separated solid dairy manure for nutrient release and solids reduction. The MW/H₂O₂-AOP was conducted at a microwave temperature of 120°C for 10 minutes, and at three pH conditions of 3.5, 7.3 and 12. The hydrogen peroxide dosage at approximately 2 mL per 1% TS for a 30 mL sample was used in this study, reflecting a range of 0.53–0.75 g H₂O₂/g dry sludge. The results indicated that substantial quantities of nutrients could be released into the solution at pH of 3.5. However, at neutral and basic conditions only volatile fatty acids and soluble chemical oxygen demand could be released. The analyses on orthophosphate, soluble chemical oxygen demands and volatile fatty acids were re-examined for dairy manure. It was found that the orthophosphate concentration for untreated samples at a higher % total solids (TS) was suppressed and lesser than actual. To overcome this difficulty, the initial orthophosphate concentration had to be measured at 0.5% TS.     

Corynebacterium glutamicum as an indicator for environmental cobalt and silver stress–A proteome analysis

Cobalt and silver are toxic for cells, but mechanisms of this toxicity are largely unknown. Analysis of Corynebacterium glutamicum proteome from cells grown in control and cobalt or silver enriched media was performed by two dimensional gel electrophoresis (2DE) followed by mass spectrometry. Our results indicate that the cell adapted to cobalt stress by inducing five defense mechanisms: Scavenging of free radicals, promotion of the generation of energy, reparation of DNA, reparation and biogenesis of Fe-S cluster proteins and supporting and reparation of cell wall. In response to the detoxification of Ag⁺ many proteins were up-regulated, which involved reparation of damaged DNA, minimizing the toxic effect of reactive oxygen species (ROS) and energy generation. Overexpression of proteins involved in cell wall biosynthesis (1,4-alpha-glucan branching enzyme and nucleoside-diphosphate-sugar epimerase) upon cobalt stress and induction of proteins involved in energy metabolism (2-methylcitrate dehydratase and 1, 2-methylcitrate synthase) upon silver demonstrate the potential of these enzymes as biomarkers of sub-lethal Ag⁺ and Co toxicity.     

Improved xenobiotic-degrading activity of Rhodococcus opacus strain 1cp after dormancy

The goals of the present work were as follows: to obtain the dormant forms of R. opacus 1cp; to study the phenotypic variability during their germination; to compare phenotypic variants during the growth on selective and elective media; and to reveal changes in the ability of the strain to destruct xenobiotics that had not been degradable before dormancy. It was shown that Rhodococcus opacus 1cp (the strain degrading chlorinated phenols) became able to utilize a broader spectrum of xenobiotics after storage in the dormant state. Germination of the dormant forms of R. opacus 1cp on an agarized medium was followed by emergence and development of phenotypic variants that could grow on 4-chlorophenol and 2,4,6-trichlorophenol without adaptation. The cells of R. opacus 1cp phenotypic variants also utilized all of the tested chlorinated phenols: 2,3-, 2,5-, and 2,6-dichloro-, 2,3,4- and 2,4,5-trichloro-, pentachlorophenol, and 1,2,4,5-tetrachlorobenzene in concentrations up to 60 mg/L, though at the lower rates than 4-CP and 2,4,6-TCP. The improved degradation of chlorinated phenols by R. opacus strain 1cp exposed to the growth arrest conditions demonstrates the significance of dormancy for further manifestation of the adaptive potential of populations. A new principle of selection of variants with improved biodegradative properties was proposed. It embraces introduction of the dormancy stage into the cell life cycle with subsequent direct inoculation of morphologically different colonies into the media with different toxicants, including those previously not degraded by the strain.     

固体厌氧消化原料流变特性研究综述

厌氧消化原料的流变特性是厌氧消化工艺设计和运行的重要参数。本文从研究对象、实验操作、研究内容和结果、影响因素以及发展方向等方面对固体厌氧消化原料,特别是污泥的流变特性研究现状进行了概述。研究表明,污泥来源广泛,成分复杂,属于非牛顿流体的范畴,其流变特性受多种因素影响,其中污泥的总悬浮固体(TSS)(或混合液悬浮固体(MLSS))和温度是最主要的影响因素。大部分研究采用层流剪切实验对物料的流变特性进行表征,研究对象范围有待于扩大。尚需针对流体本构方程的改进,共消化对于原料流变特性的影响,混合液固、液相指标与流变参数的关系等方面开展研究,为利用流变参数作为工艺控制参数提供理论依据,并解决工程放大等问题。     

Ex situ remediation of contaminated sediments using mineral additives: assessment of pollutant bioavailability with the Microtox solid phase test

The aim of this work is to assess the potential ecotoxicological effects of contaminated sediments treated with mineral additives. The Microtox solid phase test was used to evaluate the effect of mineral additives on the toxicity of sediment suspensions. Four Mediterranean port sediments were studied after dredging and bioremediation: Sample A from navy harbor, sample B from commercial port and samples C and D from pleasure ports. Sediment samples were stabilized with three mineral additives: hematite, zero-valent iron and zeolite. Results show that all studied mineral additives can act as stabilizer agent in highly contaminated sediments (A and C) by decreasing dissolved metal concentrations and sediment toxicity level. On the contrary, for the less contaminated samples (B and D) hematite and zeolite can provoke toxic effect towards Vibrio fischeri since additive particles can favor bacteria retention and decrease bioluminescence emission.