环丁砜-哌嗪溶液吸收烟道气中二氧化碳

采用搅拌实验装置,研究环丁砜溶液及不同配比的环丁砜-PZ复合溶液对烟道气中二氧化碳的吸收和解吸性能,揭示了吸收容量与酸碱度、时间之间的内在联系,并对CO2初始逸出温度、试液再生温度、试液再生率、再生pH下降率进行了细致记录分析。实验结果表明,环丁砜-PZ复合溶液配比为0.4∶0.6时:吸收效果最佳,吸收量约为0.126 mol;再生温度最高,为105℃;再生率最高,为90.34%。同时与相同配比的MEA、DEA相比具有较大再生优势。实验结果还表明,环丁砜-PZ复合体系之间存在负交互作用。     

旋转填料床/柠檬酸盐法吸收-解吸SO2

提出采用旋转填料床结合柠檬酸盐法脱除烟气中SO2的方法,考察了旋转填料床转子转速、液气比、初始柠檬酸根浓度和初始pH值等因素对脱硫效率的影响。结果表明,采用超重力法超重机转子转速为1 000 r/min、液气比为7L/m3、初始柠檬酸根浓度为1.5 mol/L、吸收液的初始pH值为5.0,脱硫效率稳定在99%左右。研究了水蒸气汽提法解吸SO2时初始柠檬酸根浓度、初始pH值、SO2浓度、富液流量和水蒸气流量对解吸效率的影响,得出了影响SO2解吸率的基本规律,并进行了分析。通过实验证明该方法在技术上是可行的,具有良好的应用前景。     

骨炭对水中不同形态Sb吸附和解吸的影响

采用骨炭作为吸附剂,研究其在不同骨炭用量、pH值和温度条件下对水中Sb（Ⅲ）和Sb（Ⅴ）吸附和解吸的影响。结果表明,骨炭对Sb（Ⅲ）的吸附效果远好于Sb（Ⅴ）,在0.2~8.0 mmol/L的Sb（Ⅲ）和Sb（Ⅴ）浓度下,骨炭对这2种形态Sb的去除率分别为46.1%~78.6%和9.6%~31.7%。采用Langmuir方程和Freundlich方程均可以很好地拟合骨炭对Sb（Ⅲ）和Sb（Ⅴ）的吸附,Sb（Ⅲ）和Sb（Ⅴ）的最大吸附容量分别为110.1034 mg/g和17.4167 mg/g。骨炭对Sb（Ⅲ）的解吸也大于对Sb（Ⅴ）的解吸。骨炭对Sb（Ⅲ）和Sb（Ⅴ）的吸附受不同骨炭用量、pH值和温度影响。     

HZ-16型大孔树脂吸附处理含RDT-8废水

采用HZ-16型大孔树脂对含三（三溴苯氧基）三嗪（RDT-8）废水进行吸附及脱附处理。实验结果表明：在废水流量为4.0 BV/h的条件下,树脂最佳吸附工艺条件为出水体积88.0 BV,此条件下出水COD小于291 mg/L,挥发酚质量浓度小于0.08 mg/L;在脱附液流量为0.5 BV/h的条件下,树脂最佳脱附工艺条件为脱附液体积3.0 BV,此条件下脱附液中挥发酚质量浓度为30.6 mg/L,挥发酚脱附率高达76.4%。在最佳吸附-脱附工艺条件下,连续进行10次动态吸附-脱附实验,吸附出水中COD为137~294 mg/L,COD去除率为72.5%~89.1%,挥发酚质量浓度稳定在0.05 mg/L以下,挥发酚去除率为99.8%~100%,说明HZ-16型大孔树脂的吸附-脱附性能稳定。     

盐析分相微萃取—高效液相色谱法测定水中含氯除草剂

采用盐析分相微萃取—高效液相色谱法同时测定水中3种含氯除草剂,建立并优化了反相离子对液相色谱条件,考察了萃取剂种类、盐析剂的种类和加入量及试样pH对萃取效果的影响。对氯苯氧乙酸、2,4-二氯苯氧乙酸和2,4-滴丁酯的质量浓度在0.1~100.0mg/L内与色谱峰面积呈良好的线性关系,相关系数不低于0.9992。平均回收率分别为96.29%、79.16%和70.21%,相对标准偏差小于5.3%。该方法操作简便、绿色环保,适合于水中含氯除草剂的测定。     

新型吸附材料AGS在油气回收中的应用

考查了自制疏水性硅胶吸附材料AGS在加油站模拟油气回收装置及某油库现场油气回收装置的应用效果,并与常用的柱状活性炭进行了比较。实验结果表明：与活柱状性炭相比,AGS对油气的吸附速率和吸附量较小,但是油气脱附效果更好;将二者混合得到的吸附材料同时具备二者的优点,既具有较高的油气吸附量又具有良好的脱附性能,使油气回收装置具有更大的油气吸附量和更好的回收效果。     

Evaluation of C18 solid‐phase extraction cartridges for the isolation of select pesticides and metabolites

Abstract

Nine different C₁₈ solid‐phase extraction (SPE) cartridges were evaluated for their efficiency at extracting nine pesticides and two s‐triazine metabolites from spiked deionized water samples. The SPE cartridges were found to contain nitrogen (N) and/or phosphorus (P) contaminants and varied in their extraction efficiency for certain pesticides and metabolites. Four of the nine SPE cartridges gave acceptable (70 to 120%) pesticide and metabolite recovery percentages, while five cartridges had marginal (50 to 70%) to poor (< 50%) recoveries. Statistical analyses showed that the poor to marginal recoveries found for three compounds could not be explained by considering several indigenous chemical and physical traits of the cartridge. It is suggested that proper SPE cartridge selection for pesticide recovery should be evaluated using several different cartridges.     

固体厌氧消化原料流变特性研究综述

厌氧消化原料的流变特性是厌氧消化工艺设计和运行的重要参数。本文从研究对象、实验操作、研究内容和结果、影响因素以及发展方向等方面对固体厌氧消化原料,特别是污泥的流变特性研究现状进行了概述。研究表明,污泥来源广泛,成分复杂,属于非牛顿流体的范畴,其流变特性受多种因素影响,其中污泥的总悬浮固体(TSS)(或混合液悬浮固体(MLSS))和温度是最主要的影响因素。大部分研究采用层流剪切实验对物料的流变特性进行表征,研究对象范围有待于扩大。尚需针对流体本构方程的改进,共消化对于原料流变特性的影响,混合液固、液相指标与流变参数的关系等方面开展研究,为利用流变参数作为工艺控制参数提供理论依据,并解决工程放大等问题。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

Using LCA to evaluate impacts and resources conservation potential of composting: A case study of the Asti District in Italy

Separate collection of municipal solid waste has overcome the 50% threshold in the Asti District in northern Italy, nearly one-third being composed of household and green organic waste. In order to address present and future solutions, it becomes therefore fundamental to assess the environmental performances of the current management of organic waste from separate collection. A from-gate-to-cradle life cycle assessment (LCA) model has been developed by expanding system boundaries, in order to carry out the assessment in the context of the whole waste management streamline. The environmental performances of an existing aerobic plant were made available, based on field measured data, by paying attention to the role and contribution of waste management subsystems. The need for actual and reliable data on materials and energy input, as well as gross and net gains from materials recovery, including benefits arising from use of compost in farming activities, was probably the major drawback that had to be faced. The study integrated the findings of different investigations from the literature with field measured data in order to obtain a more comprehensive framework representative of the area under study. The results may help public administrators to better understand the suitability of using LCA tools when dealing with solid waste management strategies.