某型橡胶密封圈加速贮存试验设计与实践

目的针对某型橡胶密封圈开展加速贮存试验设计,并通过试验预测产品贮存寿命。方法通过分析橡胶密封圈在贮存使用环境下的失效机理,结合橡胶材料性能老化模型,在不改变失效机理、又不增加新的失效机理的前提下,以密封圈整件作为试验对象,用加大温度应力的试验方法加速产品失效过程,根据试验结果预计正常环境应力下的产品贮存寿命。结果采用温度应力作为加速贮存应力开展密封圈加速贮存试验方案设计和验证工作,评估得到其在贮存温度为20℃的环境中,贮存寿命可以达到16.97年,置信度大于0.95。结论以密封圈整件作为试验件,采用温度应力作为贮存敏感应力开展加速贮存试验,所评估得到的贮存寿命与产品已有的自然贮存寿命结果吻合得较好,试验状态更加真实,为橡胶密封圈更换周期提供参考依据,并为密封圈贮存寿命的定量评估提供了一种参考方法。     

甲硫醇在苏玛罐及气袋中稳定性研究

以硅烷化苏玛罐和Tedlar气袋为保存容器,干燥空气为本底,利用低温冷阱浓缩-气相色谱/质谱联用法检测,研究甲硫醇气体样品在不同容器、温度和浓度等条件下的浓度变化趋势.结果表明,甲硫醇样品使用Tedlar气袋采样并在4℃环境下保存时具有相对较好的稳定性,对于浓度在约3 ppb至20 ppb的样品其保存有效期可达96 h;当有一定量的二甲二硫共存时,可延长甲硫醇的保存期限,以保证结果的有效性与准确性.     

Experimental investigation of the complex deflagration phenomena of hybrid mixtures of activated carbon dust/hydrogen/air

This paper aims to develop quantitative insights based on measured deflagration parameters of hybrid mixtures of activated carbon (AC) dust and hydrogen (H₂) gas in air. The generated experimental evidence is used to reject the claim of the null hypothesis (H₀) that severity of deflagrations of H₂/air mixtures always bound the severity of deflagrations of heterogenous combustible mixtures of AC dust/H₂/air containing the same H₂ concentrations as in the H₂/air binaries. The core insights of this investigation show that the maximum deflagration pressure rise (ΔP_MAX) and maximum rate of pressure rise ((dP/dt)_MAX) of this hybrid mixture are greater than those corresponding to deflagrations of H₂/air mixtures for all the dust and H₂ concentrations being examined. The deflagration severity indices (K_St and ES) of the hybrid mixture containing 29 mol% H₂ are found to be greater than those of the H₂/air mixture containing 29 mol% H₂. Also, the minimum explosible concentration (MEC) of the hybrid mixture is lower than that of the AC dust in air only. The insights gained should lead to better realization of the severity of a postulated safety-significant accident scenario associated with on-board cryoadsorption H₂ storage systems for fuel-cell (FC) powered light-duty vehicles. The identified insights could also be relevant to other industrial processes where combustible dusts are generated in the vicinity of solvent vapors. Moreover, these insights should be useful for supporting quantitative risk assessment (QRA) of on-board H₂ storage systems, designing improved safety measures for cryoadsorption H₂ storage tanks, and guiding H₂ safety standards and transportation regulations.     

漫湾电站库区降雨侵蚀力时空变化

漫湾水电站是澜沧江水能梯级开发的第一个干流大型水电站，加强库区水土流失治理与监督监测尤为必要，而降雨侵蚀力的时空分布规律研究则是实现区域土壤侵蚀定量监测预报的重要基础。根据有关降雨侵蚀力的计算方法，利用漫湾电站库区4个测站1980～2000年的逐月平均降雨资料，估算了其降雨侵蚀力R值的时空分布规律及其变化特征。结果表明：漫湾电站库区多年平均降雨侵蚀力在1 9336～3 9727 MJ·mm/hm2·h；R值的年内变化显著，且较大值集中分布在雨季的5月～10月，平均R值占全年的867%，尤其6～8月连续3个月的降雨侵蚀力平均占全年侵蚀力的一半以上；R值的年际变化显示20世纪90年代漫湾电站库区降雨侵蚀力比80年代平均增加2835 MJ·mm/hm2·h；R值的空间分布上以凤庆站点的年降雨侵蚀力最大；南涧站点的年降雨侵蚀力最小，但是其年际波动幅度较大。全面地分析了漫湾电站库区降雨侵蚀力R值的时空变化特征，为该地区有效防止与监测水土流失情况、更好地安置水电站工程移民提供参考。     

Do lower electricity storage costs reduce greenhouse gas emissions?

In the electricity sector, innovation in large-scale storage is anticipated to reduce costs and improve performance. The effect on greenhouse gas emissions of lower storage costs depends on the interactions between storage and the entire grid. The literature has disagreed on the role of storage in reducing emissions. In this paper we present a stylized model, which suggests that the effect of storage costs on emissions depends on the supply responsiveness of both fossil and renewable generators. Under common conditions in the United States, lower storage costs are more likely to reduce emissions when wind investment responds to equilibrium electricity prices and when solar investment does not. Simulations of a computational model of grid investment and operation confirm these intuitions. Moreover, because of its effect on coal and natural gas–fired supply responsiveness, introducing a carbon dioxide emissions price may increase the likelihood that lower storage costs reduce emissions.     

合肥地区不同类型源头溪流暂态存储能力及氮磷滞留特征

为揭示合肥地区不同类型源头溪流暂态存储能力及氮磷吸收滞留的基本特征,在城区和城郊筛选4条典型源头溪流,并以NH4Cl、KH2PO4为添加营养盐,以Na Cl为保守型示踪剂,开展现场示踪实验.在此基础上,利用OTIS模型水文参数(D、A、As和α),计算暂态存储指标(Ts、Tc、Ls、Rh和F200med),进而开展暂态存储能力分析,并以NH+4-N和SRP一阶吸收系数(λ、λs)解析氮磷滞留特征.结果表明:4条溪流水体的α值均处于10-4~10-3数量级;各溪流Tc基本都显著超过Ts,意味着这些溪流水体溶质滞留效应主要来自主渠道流动水体,而不是暂态存储区;根据Tc、Ts、Ls和Rh等指标,得到各源头溪流暂态存储能力排序为:二十埠河二级支流二十埠河一级支流十五里河源头段关镇河支渠;4条源头溪流主渠道流动水体与暂态存储区的NH+4-N、SRP滞留特征存在很大的差异,并且二十埠河一、二级支流和十五里河均不同程度出现λ-NH+4、λs-NH+4为负值的现象,意味着这些水体对于NH+4-N既具有短期存储作用,也起着"源"的作用.     

活性污泥储存与消耗乙酸基质的试验研究与模拟

同时贮存与生长理论认为,活性污泥吸收有机碳基质同时用于储存和生长.向SBR反应器投加不同浓度乙酸基质,监测活性污泥氧利用速率(OUR)、聚羟基烷酸盐(PHA)和出水COD的变化,运用活性污泥同时贮存与生长理论分析有机碳储存与消耗过程的特征.结果表明,饱食期结束与COD消耗至最低水平、PHA浓度出现最大值和OUR由最大值急速下降相对应;在饱食阶段,基质贮存OUR是利用外部基质直接生长OUR的2倍.随基质投加历时延长,饱食期平均OUR和最大OUR均下降,PHA产率降低,甚至出现PHA净消耗.因此,基质投加方式对有机碳基质储存与消耗有重要影响.     

Reuse of nickel recovered from spent Ni–Cd batteries for the preparation of C/Ni and C/Ni/Pd layered electrodes for energy sources

Nickel recovered in the recycling process of Ni–Cd batteries was used as a main component of bath for electrodeposition of nickel onto carbon fabric in order to obtain C/Ni composite. A part of the obtained composite was additionally coated with a thin layer of palladium (C/Ni/Pd composite). All the materials were investigated to assess the possibility of their use in the processes of electrochemical storage (sorption/desorption) of hydrogen and electrochemical oxidation of methanol. The obtained results showed the composites to be active electrode materials in these processes. The electrodes exhibited high activity and cyclability, especially in the process of methanol oxidation due to electrocatalytic activity of both nickel deposited onto carbon fabric and the outer layer of porous palladium coating nickel substrate.     

Removal of VOCs emitted from p-xylene liquid storage tanks by a full-scale compost biofilter

A full-scale compost biofilter system (CBS) was built to treat vapor losses emitted from three analogous vertical fixed roof p-xylene (p-X) liquid storage tanks of 7500 m³ total working volume. The CBS showed a stable and efficient treatment of standing loss (L_S) and working loss (L_W) with an average removal efficiency of 95.4% through 18-month standing storage and filling operation of the tanks. The weight of activated carbon employed in the concentration buffer influences the CBS performance for L_W treatment under high organic loads. The daily average pressure drops across biofilter bed displayed very low with a maximum of 7.6 mm-H₂O. This reflects that the CBS can be operated without stress and compression of biofilter bed and thus reduce maintenance frequency. No additional inputs of chemicals and fuels along with low electricity and water usage helped in its prolonged operation and increased its cost effectiveness. These advantages make the CSB become a promising control technology of vapor losses emitted from fixed roof organic liquid storage tanks.     

Fire accident investigation of an explosion caused by static electricity in a propylene plant

This study investigated a 2010 fire and explosion that occurred at a polypropylene (PP) and copper-clad laminate high-tech plant in Taiwan. Liquid acetone leakage caused the fire and explosion. One person was killed and five were injured; property damage was estimated at US$20 million. In contrast to conventional plants, high-tech plants have sophisticated instrumentation, highly complex pipelines, and confined spaces. In addition, the floor area in a high-tech plant is large and frequently contains a channel through the ground floor to the second or third floor. This channel design enables the fire compartment to be destroyed. Therefore, the system cannot confine the fire to a specific area, thus hindering fire-relief operations. In this study, the original fire outbreak occurred in the PP processing area on the ground floor. The acetone storage tank was located on the third floor. The investigation conducted at the fire site of the situations of the burning (bursting) loss determined that the acetone liquid leaked and dripped from floor cracks and tunnel oven to the PP processing area. Because the PP manufacturing process rapidly generates static electricity, the flammable liquids made contact with the source of ignition, which caused the explosion and fire. Various procedures, such as those involving the operating environment of production, packaging, and processing in a high-tech plant, are likely to produce static electricity in a workplace. Improved electrostatic management can prevent the loss of property and lives, liquid acetone leakage, and loss of equipment caused by static electricity fire.