青藏高原地区准好氧填埋单元试验研究

为研究准好氧填埋技术在海拔高、空气稀薄、气温低、昼夜温差大、蒸发强、降雨少的青藏高原地区的适用性,在青藏高原不冻泉地区开展了为期14个月的准好氧填埋单元试验研究.试验结果表明,准好氧填埋单元的渗滤液COD浓度由3307 mg/L降低到403 mg/L,氨氮由135.4 mg/L降低到0.04 mg/L,渗滤液量大幅减少.研究为青藏高原地区提供了一种垃圾处理方式.     

有机固体废弃物的热解处理研究

通过对锯末、稻壳、纸屑、橱芥、塑料和橡胶6种具有代表性的有机固体废弃物原料的热解实验,测量了它们三相产物收率,并分析了它们固体、液体和气体三相产物的组成.特别对液体产物,针对它们的特殊性分别采用了层析、模拟蒸馏和全烃气相色谱分析,详细探讨了热解焦油的具体组分,得到了热解法处理有机固体废弃物的一些有意义的数据.     

渗滤液回流量对生物反应器型垃圾填埋的影响

利用3个生物反应器研究了回流量的大小对模拟填埋场厌氧处理城市生活垃圾的影响。0号罐设定渗滤液不回流,1号罐和2号罐采取渗滤液回流措施,其回流量分别是10L/d(反应器体积的10.5%),20L/d(反应器体积的21%)。试验结果表明:1号罐中的甲烷产量和甲烷含量都要优于0号罐和2号罐。在2号罐中渗滤液回流量相对提高1倍后,其pH会下降而VFA和COD的浓度会有相应的增加。相对于10L的渗滤液回流量,高回流量(20L)有利于产甲烷化的启动和提高填埋气的产量和甲烷含量。但在反应后一阶段,高回流量(20L)导致产气量比低回流量的(10L)减少34.83%左右。     

热解析-固相微萃取-气相色谱法测定空气样品中挥发性有机化合物

建立了热解析-固相微萃取-气相色谱法测定空气样品中挥发性有机化合物的分析方法,并对色谱分离条件、玻璃针筒保存样品的稳定性、固相微萃取萃取纤维、萃取时间、色谱进样时间等条件进行了优化,9种挥发性有机化合物的峰面积与其质量浓度在所测范围内有较好的线性关系,相对标准偏差＜8.8%,检出限为0.05～0.75 μg/100 mL,满足实际空气样品测定需要。     

城市垃圾焚烧飞灰中重金属的形态及酸浸出性研究

研究了城市垃圾焚烧飞灰中重金属形态在不同粒径上的分布,以及HNO3对飞灰中重金属的浸出性.结果表明:飞灰中重金属主要以残渣态存在,可交换离子态含量很少;易挥发性的重金属在较大粒径上有较高分布,亲石性重金属Cr和Ni的分布与粒径的相关性不大,在各粒径上的分布较均匀;飞灰中以碳酸盐结合态存在的重金属对酸不稳定,易被HNO3浸出,而残渣态部分对酸较稳定,不易被HNO3浸出.     

微波技术在固体废弃物处理中的应用

介绍了微波加热的基本原理,综述了微波技术在工业污泥、医疗垃圾、废旧轮胎、电子垃圾以及建筑垃圾等固体废弃物处理中的应用现状,展望了微波技术在污染控制领域的应用前景.     

全白土催化剂生产废水的处理

用4种无机絮凝剂和3种有机絮凝剂进行了脱除全白土催化剂生产废水（简称废水）中固体悬浮物（SS）的实验研究。实验结果表明：在废水pH6．8条件下,无机絮凝剂和有机絮凝剂脱除废水中SS的效果均较差,用无机絮凝剂时的SS去除率低于26％,用有机絮凝剂时的SS去除率低于18％;废水pH对SS去除率的影响较大,当调节废水pH为8．0时,无机絮凝剂中硫酸铝脱除废水中的SS效果最好,在硫酸铝加入量为0．02mg／L、沉降时间为2h的最佳操作条件下,SS的去除率可达93％。     

The effects of leachate recirculation with supplemental water addition on methane production and waste decomposition in a simulated tropical landfill

In order to increase methane production efficiency, leachate recirculation is applied in landfills to increase moisture content and circulate organic matter back into the landfill cell. In the case of tropical landfills, where high temperature and evaporation occurs, leachate recirculation may not be enough to maintain the moisture content, therefore supplemental water addition into the cell is an option that could help stabilize moisture levels as well as stimulate biological activity. The objectives of this study were to determine the effects of leachate recirculation and supplemental water addition on municipal solid waste decomposition and methane production in three anaerobic digestion reactors. Anaerobic digestion with leachate recirculation and supplemental water addition showed the highest performance in terms of cumulative methane production and the stabilization period time required. It produced an accumulated methane production of 54.87 l/kg dry weight of MSW at an average rate of 0.58 l/kg dry weight/d and reached the stabilization phase on day 180. The leachate recirculation reactor provided 17.04 l/kg dry weight at a rate of 0.14l/kg dry weight/d and reached the stabilization phase on day 290. The control reactor provided 9.02 l/kg dry weight at a rate of 0.10 l/kg dry weight/d, and reached the stabilization phase on day 270. Increasing the organic loading rate (OLR) after the waste had reached the stabilization phase made it possible to increase the methane content of the gas, the methane production rate, and the COD removal. Comparison of the reactors' efficiencies at maximum OLR (5 kgCOD/m(3)/d) in terms of the methane production rate showed that the reactor using leachate recirculation with supplemental water addition still gave the highest performance (1.56 l/kg dry weight/d), whereas the leachate recirculation reactor and the control reactor provided 0.69 l/kg dry weight/d and 0.43 l/kg dry weight/d, respectively. However, when considering methane composition (average 63.09%) and COD removal (average 90.60%), slight differences were found among these three reactors.     

悬浮填料活性污泥法优化填料投配比试验

悬浮填料活性污泥法中试试验系统,利用某城市污水厂生产工艺回流污泥为系统悬浮污泥,探讨了悬浮填料投配比、投配方式和中试硝化效果之间的关系。试验结果表明,悬浮填料最小投配比为15%即可满足系统硝化功能的要求;悬浮填料的投配方式宜采用集中投配并布置于曝气池的末端,这样既可提高系统的生物膜量,又有利于硝化反应的实现。而且,控制适当的溶解氧浓度,悬浮填料的投加有助于同步硝化反硝化更充分的进行。     

UASB法处理城市生活垃圾焚烧场渗滤液

垃圾焚烧场的渗滤液具有pH低、污染成分复杂、COD_(Cr)浓度高、可生化性好等特点。本研究探索了UASB法处理焚烧场渗滤液时的快速启动方法,考察了水力停留时间、容积负荷对COD_(Cr)去除率的影响及产气量与COD_(Cr)去除率的关系,结果表明,在水力停留时间6d、容积负荷5kg/(m3.d)的情况下,COD_(Cr)去除率可达到93%,每升原水产气量可达22.5L,折合热值492.7kJ。