成都市土壤天然放射性核素的外照射水平估算研究

利用IED22000A便携式微机多道能谱仪对成都市区土壤的天然放射性核素进行了直接就地测量,估算出天然环境放射性核素^238U、^232Th、^40K的比活度范围分别为10.37～77．19Bq／kg、17,85～225．74Bq／kg、284．83～892．67Bq／kg;外照射指数范围为0．16—0．8;离地面1m高的空气吸收剂量率均值为83．23nGy／h;1外照射年有效剂量当量为0．34～0．70mSv;等效镭浓度的变化范围是59．06-386．45Bq／kg,均值为164．15Bq／kg。各项指标均在容许范围之内,因而成都市属于外照射水平的安全区域,人居环境不受影响。     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

利用餐饮业废油脂制造生物柴油

世界的石油产量将会逐渐减少,石化柴油燃烧后所排放的废气是造成的城市空气污染的主要原因,生物柴油是石化柴油很好的替代能源,文章介绍了国外废油脂处理利用和甸餐饮业废油脂的概况,提出了利用餐饮业废油脂制造生物柴油的方法和工艺流程,并讨论了利用餐饮业废油脂制造生物柴油的几个问题。     

外力作用下管道内表面缺陷处裂纹扩展研究

为提高油气管道安全风险评估的准确性,以含内表面缺陷管道为研究对象,利用ABAQUS软件线弹性及弹塑性分析不同尺寸缺陷对裂纹萌生特征的影响;采用扩展有限元法,建立管道3点弯曲模型与全尺寸静载物理试验,并非线性拟合裂纹扩展尺寸,研究内表面缺陷处裂纹扩展情况.研究结果表明:内表面缺陷中心处极易萌生裂纹,随着缺陷尺寸的增大,裂...     

武汉市一次污染过程的局地流场和边界层结构的数值模拟

利用2013年11月武汉市逐日空气质量资料、地面气象观测资料、NCEP/NCAR再分析资料和L波段雷达探空资料,通过WRF模式模拟空气污染生消过程中的局地气象条件变化,探讨特殊地形条件下边界层结构变化和局地环流在污染物生消过程中的作用和影响。结果表明：（1）武汉地区当背景环流场强的时候,由地形引起的局地流场对污染物扩散的影响就弱,反之当背景环流场弱的时候, 地形对流场影响明显:夜间为山风,白天为谷风。夜间山风与偏西北气流及偏东气流在武汉及周边地区辐合,形成气流汇聚带,在武汉地区形成一个反复污染带,即由地形引起的局地流场对污染物扩散的贡献就大;（2）武汉地区发生空气污染时,地面湿度较高,边界层呈上干下湿状态,其特征为暖而干且有偏东小风,这导致污染物不断堆积和重污染过程的形成。     

模拟降雨径流作用下红壤坡面侵蚀水动力学机制

土壤侵蚀过程受控于侵蚀外营力和土壤抗侵蚀性能,深入理解坡面流水动力学特性及其侵蚀动力是研究土壤侵蚀动力学机制的基础。利用可变坡土槽,通过不同雨强(60、90和120 mm/h)和径流冲刷(10、15和20 L/min)组合模拟试验,研究了第四纪黏土红壤坡面水流的水动力学特征参数及其与土壤侵蚀量间的关系。结果显示:降雨和径流冲刷影响了坡面产流产沙过程和坡面流水力学特性,其中平均流速v、平均水深h、雷诺数Re和水流功率ω均随降雨强度和上方来水流量的增加而增大,相对水深曼宁糙率n/h则减小,其水力学他参数(弗如德数Fr、阻力系数f和水流剪切力τ)变化规律不明显。坡面水流平均速度取值范围为0.21~0.45 m/s,平均水深取值范围为5.6~9.4 mm,在试验条件下红壤坡面侵蚀水流流态大部分均处于"紊流-急流区"。不论从径流角度看或是从泥沙角度分析,由相对水深和曼宁糙率系数两种水动力因子共同组成的复合水动力特征参数-相对水深曼宁糙率,是表征不同上方来水流量和降雨强度条件下第四纪粘土红壤坡面侵蚀特征的水动力参数。     

Measurement of public awareness of climate change in China: based on a national survey with 4,025 samples

Just before the new round of UN climate change conference in Bonn, a survey report, named as the Climate Change in the Chinese Mind 2017, was released in Beijing. The investigation was conducted in the form of a computer-assisted telephone survey with a sample size of 4,025 samples, covering 332 prefecture-level administrative units and four municipalities in China. Urban-rural proportion and sex proportion were specially taken into account, so as to demonstrate the Chinese public awareness objectively. The investigation measures the public awareness from six aspects, which includes climate change beliefs, impacts, response, policies, actions, and the assessment of the effectiveness of climate communication. This article presents the key findings of the survey and provides further insights behind the data.     

长三角城市群“空间流”网络结构特征——基于公路运输、火车客运及百度指数的综合分析

信息技术的应用与社会信息技术的传输,使大量的要素(人流、物流、信息流)在城市群空间内集聚与扩散,加密城市群空间内城市联系。在基于公路运输、普通列车、高速列车以及百度指数4个要素的综合分析基础上,对长三角城市群"空间流"网络结构特征进行探析。研究结果表明:(1)长三角城市群区域内城市联系虽具备了网络化规模,但城市间的联系不均衡,以上海、南京、杭州等城市为多中心的协调网络发展格局特征明显;(2)长三角城市群16个核心城市"空间流"特征呈现三角形网络结构,其三角形的顶角分别由上海(沪)、南京(宁)与杭州(杭)3个核心节点城市构成。在空间结构内部,形成若干次级城市网络连线;在空间分布上,北翼网络化程度较高于南翼线性联系程度,区域联系强度以"沪—宁"、"沪—杭"沿线向两侧递减;(3)上海、南京、杭州、苏州、无锡5个核心城市排名处于网络中心的前列,扬州、南通、泰州、舟山等周边城市相对靠后,这与区域经济发展过程的"吸虹效应"有关,随着区域经济一体化程度的加深,中心城市会向周边地区提供服务与经济辐射,完善整个长三角城市群网络体系。     

全球升温1.5℃与2.0℃情景下长江中下游地区极端降水的变化特征

基于长江中下游地区1961~2100年区域气候模式COSMO-CLM(CCLM)模拟与1961~2005年气象站观测的逐日降水数据,通过统计计算年降水量、强降水量、暴雨日数和极端降水贡献率4个极端降水指数,研究全球升温1.5℃与2.0℃情景下,长江中下游地区极端降水的时空变化特征。结果表明:(1)全球升温1.5℃情景下,年降水量相对于1986~2005年减少5%,强降水量、暴雨日数和极端降水贡献率分别增加7%、33%和4%;概率密度曲线表明,年降水量均值下降,强降水量、暴雨日数和极端降水贡献率均值上升,极端降水方差增大;年降水量、强降水量和暴雨日数在空间上表现为南部增加北部减少,极端降水贡献率则相反。(2)全球升温2.0℃情景下,年降水量下降3%,强降水量、暴雨日数和极端降水贡献率分别上升15%、46%和15%;年降水量均值稍有减少且方差稍有上升,强降水量、暴雨日数和极端降水贡献率均值和方差明显增加;年降水量减少区域位于长江主干以北,强降水量、暴雨日数和极端降水贡献率表现为绝大部分地区增加的空间变化特征。(3)全球升温由1.5℃至2.0℃时,年降水量、强降水量、暴雨日数和极端降水贡献率分别增加3%、7%、10%和11%;随升温幅度的增加极端降水均值和方差上升;极端降水呈增加态势的范围扩大。因此,努力将升温控制在1.5℃对降低极端降水的影响具有重要意义。