An assessment of how distance and diesel oxidation catalyst will impact thermal decomposition behaviors of particles

Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, C_xH_y fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm^?1 was only detected without a DOC, while the NO₂ peak at 1634 cm^?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less C_xH_y fragments were seen in the second-stage.     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

关于改善石家庄市空气质量的建议

针对电力和供热导致石家庄市空气污染严重的问题，结合该市目前的电力和供热现状，提出了减少污染的措施及建议，希望对改善该市空气质量起到促进作用。     

齐鲁石化热电厂废水回用方案的实施及问题分析

针对目前水资源短缺状况，以齐鲁石化热电厂为例提出了利用生活污水，养鱼场排水、锅炉排污水以及化学反洗水作循环冷却水补充水的优化方案，并就废水田用方案的实施及运行中发现的问题进行了分析与探讨。     

超声波处理石化厂剩余活性污泥

采用超声波处理石化污水处理厂的剩余活性污泥。介绍了超声波对污泥的作用机理，初步研究了超声波处理污泥的影响因素。大功率超声波可以降解生物污泥，释放出其中的有机物。小功率超声波能够改善污泥的膨胀特性、提高污泥沉淀特性和脱水能力、降低污泥的含水率，达到减量的目的。经超声波处理并简单过滤的污泥滤液，COD达到4200mg／L左右，污泥含水率由94％降至85％左右。     

贫燃条件下汽车尾气中NOx催化净化研究进展

汽车尾气排放的NOx(主要是NO)是城市大气的主要污染源之一。本综述了近l0年来贫燃条件下NOx催化转化为N2的催化剂研究进展。这些方法包括HC-SCR、NO直接催化分解、NOx吸附-还原等。讨论了不同催化剂的性能影响因素。新的负载材料MFI、MCM-41、SAPO-34的应用增强了催化剂的性能。双功能催化剂由于两种活性位的协同作用表现出较高的活性和选择性。新的纳米结构概念催化剂NOx吸附还原中发现有广泛应用。介绍了上述催化脱除NOx的各种机理并指出了今后研究的方向。     

COLD WATER PATCHES IN WARM STREAMS: PHYSICOCHEMICAL CHARACTERISTICS AND THE INFLUENCE OF SHADING1

ABSTRACT: Discrete cold water patches within the surface waters of summer warm streams afford potential thermal refuge for cold water fishes during periods of heat stress. This analysis focused on reach scale heterogeneity in water temperatures as influenced by local influx of cooler subsurface waters. Using field thermal probes and recording thermistors, we identified and characterized cold water patches (at least 3°C colder than ambient streamflow temperatures) potentially serving as thermal refugia for cold water fishes. Among 37 study sites within alluvial valleys of the Grande Ronde basin in northeastern Oregon, we identified cold water patches associated with side channels, alcoves, lateral seeps, and floodplain spring brooks. These types differed with regard to within floodplain position, area, spatial thermal range, substrate, and availability of cover for fish. Experimental shading cooled daily maximum temperatures of surface waters within cold water patches 2 to 4°C, indicating a strong influence of riparian vegetation on the expression of cold water patch thermal characteristics. Strong vertical temperature gradients associated with heating of surface layers of cold water patches exposed to solar radiation, superimposed upon vertical gradients in dissolved oxygen, can partially restrict suitable refuge volumes for stream salmonids within cold water patches.     

西江年最高水位的神经网络预报模型

对西江洪水发生的特征进行分析表明，洪水发生频率高，具有明显阶段性特征，并与流域面雨量密切相关。利用前期环流场、海表温度（SST）场及环流特征量资料选择初选预报因子，然后对初选预报因子作EOF分解构造综合预报因子，结合人工神经网络方法建立了西江年最高水位预报模型，并对预报模型进行独立样本试验。结果表明，该预报模型对历史样本拟合精度高，试报效果明显好于传统的逐步回归模型，可在汛期预测业务中应用。     

大空间中热隐患的可视化监测

在无人值守的情形下,实现对大型建筑空间内发热物体、火灾等热隐患的智能监测是非常必要的,笔者基于已有的研究成果,讨论了大空间热隐患监测中,高温目标的可视化甄别和温度场的可视化测量原理。利用CCD(电荷耦合器件)的近红外响应特性(800~1200nm)、短波段内单调发射率函数、非相关滤色片构造和归一化数据处理模式等关键技术,使得常见的CCD图像监控设备实现了高温热隐患的非接触、可视化智能监测(即包括高温目标的可视化甄别以及温度场的可视化测量),改进的设备有望推广应用。