我国典型细颗粒物排放源单颗粒质谱特征对比研究

针对现有污染源单颗粒质谱成分谱较少且缺乏对比总结的问题,本论文收集了工艺过程源、扬尘源、机动车尾气源、燃煤源和生物质燃烧源的单颗粒质谱图数据,使用聚类算法分析了各源类单颗粒物的主要化学组成特征的差异性.结果表明工艺过程源和燃煤源颗粒物均含有OC类、矿物质类、EC类、重金属类、富钾/左旋葡聚糖/硫酸盐硝酸盐类、OCEC类,但各颗粒类型的占比有明显差异,燃煤源中EC类占比明显高于工艺过程源而重金属类占比低于工艺过程源.生物质燃烧源主要由OC类、其他有机物类、富钾/左旋葡聚糖/硫酸盐硝酸盐类和OCEC类组成.扬尘颗粒的主要类型为矿物质类.从单颗粒化学组成上看,工艺过程源排放的有机颗粒中OC常与SO₄^2-内混,元素碳颗粒中EC与NO₃^-或SO₄^2-内混.燃煤源排放的碳质颗粒中EC、OC成分往往与NO₃^-和SO₄^2-或者单独与SO₄^2-...     

He mass spectrometry for very low-level measurement of organic tritium in environmental samples

The design, setup and performance of a mass spectrometric system for the analysis of low to very low-level tritium in environmental samples are described. The tritium concentration is measured indirectly by the ³He ingrowth from radioactive decay after complete initial degassing of the sample. The analytical system is fully computer-controlled and consists in a commercial helium isotope mass spectrometer coupled with a high vacuum inlet system. A detection limit of 0.15 Bq/kg is routinely obtainable for sample sizes of 20 g of water equivalent and an accumulation time of three months. Larger samples (and/or longer accumulation time) can be used to obtain lower detection limits. In addition to the benefit of a lower detection limit, another advantage of this non-destructive method lies in the simplicity of the analytical procedure which strongly limits the risk of contamination. An inter-comparison was successfully performed with the conventional beta counting technique on lyophilized grass samples, in a range of tritium concentrations of environmental interest. It shows that the ³He mass spectrometry method yields results that are fully consistent with the conventional liquid scintillation technique over a wide range of tritium concentrations.     

萃取－同步荧光光谱法测定大气飘尘中苯并（a）芘

提出用浓Ｈ２ＳＯ４从大气飘尘样品的环己烧提取液中一次萃取后，用同步荧光光谱测定苯并（ａ）芘的方法。选用△λ为２０ｎｍ时可获最佳效果，用浓硫酸萃取的时间仅１ｍｉｎ，苯并（ａ）芘在浓硫酸相中１ｈ内稳定，样品加标的回收率为８５％，其它多环芳烃化合物在５３０—６００ｎｍ的测定波长范围不干扰苯并（ａ）芘的测定。用乙酰化滤纸层析－荧光分光光度的统一方法作为对比对实际样品进行了测定，结果与后者的偏差在±１５％以内，分析周期可缩短２４ｈ。     

冷原子吸收法测定痕量汞的研究

用自制的冷原子汞蒸气发生装置和样品吸收管,研究了以SnCl_2为还原剂,冷原子吸收分光光度法连续测定汞的适宜条件.检出限为0.45ng/ml,汞量在0～80ng/ml范围内,符合比尔定律;连续测定浓度为20ng/m的汞溶液,相对标准偏差为1.8%;测定实际水样中的痕量汞,其回收率为97.0%～100.8%.     

邻苯二甲酸二甲酯的紫外光-H2O2降解机制研究

为研究邻苯二甲酸二甲酯(DMP)在紫外光(UV)-H2O2体系下的光降解机制,利用质谱仪鉴定了目标化合物的降解产物,并借此推测其可能的降解途径.结果表明,在UV-H2O2的体系中,10 mg.L-1的DMP在90 min内的降解率达到92.3%,溶液pH值由初始的6.50降至4.98.通过GC/MS、LC/MS分析,DMP在UV-H2O2降解过程中的产物有六类,并且推断出DMP的两条侧链同时发生水解作用,生成的邻苯二甲酸可以异构为更加稳定的对苯二甲酸.此外,DMP还可以发生苯环取代、侧链缩合成环等反应,最后,在.OH的作用下,DMP及其芳香族中间产物发生开环反应,苯环被破坏,生成多种小分子有机酸,并进一步矿化为CO2和水.     

饮用水中超痕量镉的蒸气发生：原子荧光光谱法测定

研究了在特制测Ｃｄ固体试剂存在的水溶液中，Ｃｄ与ＫＢＨ４反应生成挥发性物种，以无色散原子荧光光谱法测定饮用水中超痕量Ｃｄ的分析方法，ＣＤＳＲ－１能巧妙地调节反应体系的ＰＨ值，使其达到最佳测定ＰＨ范围，且能提高挥发性物种发生率，方法的灵敏度可提高１－２数量级，方法线性范围为０－５μｇ／Ｌ，最低检出浓度为０．０８μｇ／Ｌ；精密度实验的变异系数为１．３％；回收率为９３．０％－１０６．０％。     

Analysis of heavy metals in ecstasy tablets by electrochemical methods

Trace amounts of heavy metals have been analysed by electrochemical techniques in ecstasy tablets obtained from different police seizures in Spain. Lead, cadmium, copper and zinc were determined by differential-pulse anodic stripping voltammetry at a hanging mercury drop electrode, whereas nickel and cobalt were determined by adsorptive differential-pulse cathodic stripping voltammetry from their dimethylglyoxime complexes, M(DMG)₂. The performance of the procedure was compared with electrothermal atomic absorption spectrometry. The procedure was applied to the determination of these elements in nine ecstasy samples, finding that Zn is the element present in the highest concentration, ranging from 0.3 to 200?mg?kg^?1, Ni, Cu appear below 15?mg?kg^?1 and Pb below 8?mg?kg^?1, while Cd and Co levels were always lower than 0.51?mg?kg^?1.     

Synthesis of 2,3-dihydroxynaphthalene-functionalized Amberlite XAD-4 resin: Applications for the separation and preconcentration of trace metal ions prior to their determination by inductively coupled plasma atomic emission spectrometry

A simple, sensitive column solid-phase extraction procedure for separation and preconcentration of Cu(II), Ni(II), Co(II), and Cd(II) in spiked and natural water samples using 2,3-dihydroxynaphthalene-functionalized Amberlite XAD-4 (XAD-4-DHN) chelating resin prior to their determination by inductively coupled plasma atomic emission spectrometry was discussed. The optimum experimental parameters such as pH, volume of sample and eluent, flow-rates of uptake and stripping, and sorption capacity of the chelating resin, were evaluated. The effect of the electrolytes and the cations on the preconcentration of metal ions was also investigated. The chelating resin could be reused for more than 20 cycles of sorption–desorption without any significant change (<1.0%). Recoveries obtained from this method range from 96 to 102% with R.S.D of 2.50 (n = 4). The detection limits for Cu(II), Ni(II), Co(II), and Cd(II) were found to be 1.9, 0.9, 1.2 µg, and 1.4 µg L^?1, respectively. The proposed method was applied for the determination of Cu(II), Ni(II), Co(II), and Cd(II) in spiked, tap water, and river water samples.     

高分辨气相色谱/高分辨质谱法测定南极样品中有机氯农药

建立了同位素稀释-高分辨气相色谱/高分辨质谱法(HRGC/HRMS)测定南极土壤、苔藓和地衣样品中23种有机氯农药的分析方法.样品经冷冻干燥、研磨处理后用正己烷∶二氯甲烷(1∶1,V∶V)混合溶剂进行加速溶剂萃取(ASE),萃取液经硅胶-氧化铝层析柱和C18小柱净化后,进HRGC/HRMS检测分析.样品中目标物定量采用平均相对响应因子法,6点标准曲线响应因子的相对标准偏差(RSD)≤20%,方法的线性范围为0.4—800μg·L-1,回收率在62%—101%之间.实际样品分析结果表明,23种OCPs的加标回收率为40%—100%,在土壤、苔藓和地衣样品中的检出限(LODs)分别为0.024—5.01、0.2—12.2、0.020—13.7 pg·g-1,可以满足南极环境样品中有机氯农药的检测分析.     

Enrichment of elements in industrial waste incineration bottom ashes obtained from three different types of incinerators,as studied by ICP-AES and ICP-MS

The elemental composition of the industrial waste incineration bottom ash (IWIBA) samples collected from three different types of incinerator with different kinds of wastes were compared. The major-to-ultratrace elements in the IWIBA samples were determined by inductively coupled plasma atomic emission spectrometry (ICP-AES) and inductively coupled plasma mass spectrometry (ICP-MS). As a result, ca. 40 elements in the concentration range from milligrams per gram to submicrograms per gram could be determined with relative standard deviations of less than 5%. The IWIBA sample from petrochemical wastes contained lower concentrations of the elements, because fewer mineral constituents were contained in the input waste materials. On the contrary, the elemental concentrations in the IWIBA sample from industrial solid wastes provided the highest values for most elements, while the elemental compositions of the IWIBA sample from food wastes were similar to those of municipal solid waste incineration bottom ash. In addition, it was found from the analytical results that the levels of various heavy metals such as Cr, Mn, Fe, Ni, Cu, As, Zr, Mo, Sb, Ba, and Pb were higher in the IWIBA samples than in municipal solid waste incineration bottom ash. The enrichment factors of the elements in the IWIBA samples were estimated from the analytical results to compare the elemental distributions in incineration bottom ashes in relation to their mining influence factors, which are the indices for human use of the elements.