萃取法分离回收不锈钢酸洗污泥硫酸浸出液中的重金属

采用非皂化P204和皂化P204萃取剂对不锈钢酸洗污泥的硫酸浸出液进行萃取。在浸出液pH为0.80、非皂化P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取时间为5 min的条件下,Fe~(3+)萃取率达99.64%,Cr~(3+)和Ni~(2+)萃取率为3.98%和6.99%,一次萃余液pH为0.64。采用皂化P204对除Fe~(3+)后的一次萃余液进行萃取,在P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取剂皂化率为60%、一次萃余液pH为1.50、萃取时间为5 min的条件下,Ni~(2+)萃取率为93.12%,Cr~(3+)萃取率为20.69%,二次萃余液pH为2.63。     

钙钛矿型催化剂催化湿式氧化处理煤气化废水纳滤浓缩液

采用溶胶-凝胶法制备了Mn掺杂钙钛矿型催化剂LaFexMn1-xO3,并以其为催化剂催化湿式双氧水氧化处理煤气化废水纳滤浓缩液。采用XRD,SEM,FTIR技术对催化剂进行了表征。表征结果显示：制备的催化剂均具有标准的钙钛矿型结构,其中,LaFe0.9Mn0.1O3的结构稳定,比表面积大。实验结果表明：制备的催化剂中LaFe0.9Mn0.1O3的催化活性最高,且稳定性好,连续使用5次后催化活性未见明显减弱;在H2O2投加量3.0 g/L、n（H2O2）∶n（LaFe0.9Mn0.1O3）=12∶1、反应温度160 ℃、反应压力1 MPa、浓缩液pH 3、反应时间60 min的最优条件下,COD、UV254和TOC的去除率分别达到80.9%、95.2%和68.0%,BOD5/COD由0.02提升至0.40,可生化性大幅提高。     

Comparative evaluation of sizing of metal hydride (MH) hydrogen storage tank filled with different alloys

This study presents a comparative analysis of sizing of metal hydride tank filled with different alloys. Alloys include solid solutions and intermetallic compounds of the generic families AB₅, AB₂, AB, A₂B. The effects of the different alloys on the sizing of metal hydride hydrogen storage tanks are complicated and depend on many factors. In this paper, a thermoeconomic optimization analysis with a simple algebraic formula was presented for the estimation of optimum metal hydride tank surface area for heat transfer enhancement. The optimum area of the metal hydride tank filled with commercially available different alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) was evaluated and compared by the developed method. The optimum net savings and the value of payback were determined for four alloys. It is found that mathematical model can be employed for the determination of optimum metal hydride tank design and increasing net savings according to alloy types. The optimum areas of the tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) were calculated as 0.136, 0.130, 0.133, and 0.173 m², respectively. The optimum net savings for tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) are about 461.0, 409.3, 419.6, and 979.6 $ and the values of payback are about 1.98, 2.1, 2.17, and 1.37 years, respectively. Excessive area of the metal hydride tank would not be as economical as the optimum tank area. Thermal management of metal hydride tank must be designed for optimum points calculated at which maximum savings occur.     

Environment contamination by mycotoxins and their occurrence in food and feed: Physiological aspects and economical approach

The contamination of food and feed by mycotoxins as toxic metabolites of fungi is a risk not only for consumers resulting in various embarrassment regarding health status and well-being, but also for producers, companies and export market on the ground of economic losses and ruined stability of economic trade. As it is given in historical evidence, the contamination of food by mycotoxins is a topic as old as a history of mankind, finding some evidence even in the ancient books and records. Nowadays, the mycotoxins are used in modern biotechnological laboratories and are considered an agent for targeting the specific cells (e.g., defected cells to eliminate them). However, this promising procedure is only the beginning. More concern is focused on mycotoxins as abiotic hazard agents. The dealing with them, systematic monitoring, and development of techniques for their elimination from agricultural commodities are worldwide issues concerning all countries. They can be found alone or in co-occurrence with other mycotoxins. Thus, this review aims to provide widened information regarding mycotoxins contamination in environment with the consequences on health of animals and humans. The inevitability for more data that correctly determine the risk points linked to mycotoxins occurrence and their specific reactions in the environment is demonstrated. This review includes various symptoms in animals and humans that result from mycotoxin exposure. For better understanding of mycotoxin's impact on animals, the sensitivities of various animal species to various mycotoxins are listed. Strategies for elimination and preventing the risks of mycotoxins contamination as well as economical approach are discussed. To complete the topic, some data from past as historical evidences are presented.     

丝藻对含钼废水中MoO_4~(2-)的吸附特性及机制研究

研究了丝藻对含钼废水中MoO2-4的吸附作用。分别考察了初始pH、吸附时间、温度、投加量以及竞争离子等5个因素对吸附过程的影响,并应用吸附热力学和动力学方法对吸附机制进行了探讨。结果表明,丝藻在初始pH 1、吸附时间40min、投加量为1.0g以及30℃条件下,对含钼废水中MoO2-4的去除率达82%,平衡吸附量为0.657 0mg/g。PO3-4对MoO2-4的吸附具有较强的拮抗作用,平衡吸附量下降至0.380 0mg/g,SiO4-4对MoO2-4的拮抗作用相对较弱,而SO2-4对MoO2-4的吸附却有一定的协同作用。丝藻对MoO2-4的吸附等温数据更符合Langmuir吸附等温模型,准二级动力学方程拟合的吸附动力学过程相关性较高,20、25℃下的R2都在0.99以上。说明丝藻吸附MoO2-4属于化学吸附,受化学反应速率控制,且丝藻可以应用于含钼废水治理领域。     

火电灰渣场自然恢复下灰渣养分及重金属含量研究

对自然恢复下4类不同年代样地的灰渣养分含量及重金属含量进行研究,通过对比分析发现,有机质、全氮、全钾、全磷含量随着自然恢复时间的增加呈现递增的趋势,全磷含量在各恢复阶段与对照样地之间并不存在显著差异(P0.05)。pH随着恢复时间的增加呈现递减的趋势。对灰渣综合质量指数进行研究发现,自然恢复长期、中期、短期与自然恢复初期对比均有显著提高(P0.05),且随着自然恢复时间的增加灰渣综合质量指数逐渐提高。对灰渣场锌、铅、铜3种重金属研究后发现,在自然恢复下随着时间的增加,灰渣中重金属含量均呈现递减的趋势。     

Comprehensive Environmental Investigation at Former Industrial/Petroleum Underground Storage Tank Sites in Long Beach,CA: A Forensic Perspective

Two industrial sites were investigated based on years of available hydrogeologic information and monitoring data for soil and groundwater. Collected data were forensically evaluated using age-dating and fingerprinting methods. The previous business uses of the project sites were as a gas station, laundry/dry-cleaning service, and car wash with petroleum underground storage tanks (USTs). As a result, these sites were exposed to a number of toxic contaminants at relatively high concentrations. Source control was necessary for successful remediation and the ultimate removal of the remaining compounds from these industrial sites. Although contaminated soil around the source was excavated during the remedial action and the high concentrations of contaminants were reduced, typical groundwater contaminants such as petroleum hydrocarbons as gasoline (TPH-G), benzene, toluene, ethylbenzene, xylenes (BTEX), and oxygenates including methyl tert-butyl ether (MTBE), diisopropyl ether (DIPE), ethyl tert-butyl ether (ETBE), tert-amyl methyl ether (TAME), and tert-butyl alcohol (TBA) were persistently found at the studied sites around the source points. The plume and concentration of contaminants had changed their shapes and strength for all monitoring periods. Thus, additional source control seems to be a requirement for the complete removal of source contamination, which must be ascertained with groundwater and soil monitoring on a regular time base. For the study sites, monitored natural attenuation was relatively feasible for the long-term plan; however, it did not offer a perfect remediation solution for an ultimate goal because of residual toxic compounds that might have affected the surrounding residential areas at higher concentrations than their health limits. Therefore, as a remediation strategy, the combination of clean-up technology and natural attenuation with monitoring activities are more highly recommended than either clean-up or natural attenuation used separately.     

Geogenic Distribution of Arsenic (As) and Antimony (Sb) in Soils of the Murcia Region in Spain

The objective of this study was to determine the As and Sb contents in soils from the Murcia Region of Spain and the possible relationship between the mineralogical composition, soil properties, and As and Sb concentrations. In this study, 490 samples were selected from areas with different characteristics in order to study As and Sb variability. Results show that As and Sb concentrations are positively correlated with the phyllosilicate and quartz content but negatively correlated with the calcite content. The generic reference level (GRL) for these elements was determined according to the Spanish legislation. Established GRL values vary according to the established mineralogical groups, suggesting that GRL has to be determined considering the lithological characteristics of the study area.     

建筑垃圾对雨水径流中Cu的吸附特性

以砖混建筑垃圾为研究对象,采用人工模拟雨水,通过静态和动态吸附实验研究了不同粒径粒级建筑垃圾对雨水径流中Cu的吸附效果。结果表明,准二级动力学模型比准一级动力学模型能更好地描述建筑垃圾对Cu的吸附过程;Freundlich等温模型能较好地拟合其等温吸附过程;不同粒径粒级建筑垃圾均对雨水径流中的Cu具有较好的净化效果,去除率均超过90%,粒径粒级越小,对Cu的净化效果越好,但其渗透性能越差;建筑垃圾的粒径粒级对Cu的吸附平衡时间、吸附速率和吸附量具有重要影响,粒径粒级2.36~4.75 mm的建筑垃圾对Cu的平衡吸附速率和平衡吸附量最大,分别为4.1μg/min和12.4μg/g。     

新制备生物炭的特性表征及其对石油烃污染土壤的吸附效果

生物炭作为一种绿色环保的功能材料因其在污水处理和污染土壤修复方面具有显著效果而受到极大关注.采用红外光谱、元素分析仪及微孔分析对不同温度(200、300、400、500和600℃)条件下制备的木屑和麦秆生物炭进行特性表征,并采用制备的生物炭净化石油污染土壤,分别考察了污染物性质、生物质原料和热解温度对其净化效果的影响.结果表明,随着热解温度的增高,生物炭芳香化程度增加,极性降低,微孔结构逐渐发育,表面积增大.加入生物炭33 d后,污染土壤中总石油烃及其组分烷烃的浓度比对照略有降低,而PAHs浓度下降显著.随着热解温度升高,2种生物炭对PAHs的吸附强度均逐渐增大,芳香度增高、表面积增大是强吸附的主要原因.2种生物炭在400℃及以下温度制备时对PAHs的吸附强度为:木屑生物炭＞麦秆生物炭;而400℃以上温度制备的生物炭吸附强度则相反,即麦秆生物炭＞木屑生物炭,说明生物炭原料对其吸附强度也具有显著影响.