Petrophysical analysis to investigate the effects of carbon dioxide storage in a subsurface saline aquifer at Ketzin, Germany (CO2SINK)

To test the injection behaviour of CO₂ into brine-saturated rock and to evaluate the dependence of geophysical properties on CO₂ injection, flow and exposure experiments with brine and CO₂ were performed on sandstone samples of the Stuttgart Formation representing potential reservoir rocks for CO₂ storage. The sandstone samples studied are generally fine-grained with porosities between 17 and 32% and permeabilities between 1 and 100 mD.Additional batch experiments were performed to predict the long-term behaviour of geological CO₂ storage. Reservoir rock samples were exposed over a period of several months to CO₂-saturated reservoir fluid in high-pressure vessels under in situ temperature and pressure conditions. Petrophysical parameters, porosity and the pore radius distribution were investigated before and after the experiments by NMR (Nuclear Magnetic Resonance) relaxation and mercury injection. Most of the NMR measurements of the tested samples showed a slight increase of porosity and a higher proportion of large pores.     

Effects of low concentration biodiesel blend application on modern passenger cars. Part 1: Feedstock impact on regulated pollutants, fuel consumption and particle emissions

Five biodiesels from different feedstocks (rapeseed, soy, sunflower, palm, and used fried oils) blended with diesel at 10% vol. ratio (B10), were tested on a Euro 3 common-rail passenger car. Limited effects (−2% to +4%) were observed on CO₂ emissions. CO and HC emissions increased between 10% and 25% on average, except at high speed - high power where emissions were too low to draw conclusions. NOx emissions increased by up to 20% for two out of the five blends, decreased by up to 15% for two other blends, and remained unchanged for one blend. Particulate matter (PM) was reduced for all blends by up to 25% and the reductions were positively correlated with the extent of biodiesel saturation. PM reductions are associated with consistent reductions in non-volatile particle number. A variable behaviour in particle number is observed when volatile particles are also accounted.     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.     

Atmospheric particle characterization, distribution, and deposition in Xi'an, Shaanxi Province, Central China

Physical characterization and chemical analysis of settled dusts collected in Xi’an from November 2007 to December 2008 show that (1) dust deposition rates ranged from 14.6 to 350.4 g m⁻² yr⁻¹. The average deposition rate (76.7 g m⁻² yr⁻¹) ranks the 11th out of 56 dust deposition rates observed throughout the world. The coal-burning power was the major particle source; (2) on average (except site 4), ∼10% of the settled dusts having size <2.6, ∼30% having size <10.5, and >70% having size <30 μm; (3) the concentrations for 20 out of 27 elements analyzed were upto 18 times higher than their soil background values in China. With such high deposition rates of dusts that contain elevated levels of toxic elements, actions should be taken to reduce emission and studies are needed to assess the potential impacts of settled particles on surface ecosystem, water resource, and human health in the area.     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

A Two-Stage Particle Swarm Optimization Algorithm for MPPT of Partially Shaded PV Arrays

The power-voltage (P-V) characteristic curves of a PV array are nonlinear and have multiple peaks under partially shaded conditions (PSCs). This paper proposes a novel maximum power point tracking (MPPT) method for a PV system with reduced steady-state oscillation based on a two-stage particle swarm optimization (PSO) algorithm. The grouping method of the shuffled frog leaping algorithm (SFLA) is incorporated in the basic PSO algorithm (PSO-SFLA), ensuring fast and accurate searching of the global extremum. An adaptive speed factor is also introduced into the improved PSO to further enhance its convergence speed. Test results show that the proposed method converges in less than half the time taken by the conventional PSO method, and the power is improved by 33% under the worst PSCs, which confirms the superiority of the proposed method over the standard PSO algorithm in terms of tracking speed and steady-state oscillations under different PSCs.     

The role of sorption and bacteria in mercury partitioning and bioavailability in artificial sediments

This study compared the relative importance of three types of sorption (organic matter-particle, mercury-organic matter and mercury-particle) in controlling the overall mercury partitioning and bioavailability in sediments. We found that all three types of sorption were important for both inorganic mercury (Hg) and methylated mercury (MeHg). Mercury-particle sorption was more important than mercury-fulvic acid (FA) sorption in increasing the mercury concentrations with increasing aging. Bioavailability (quantified by gut juice extraction from sipunculans) was mainly controlled by mercury-particle sorption, while FA-particle and mercury-FA sorption were not as important, especially for MeHg. Bacterial activity also increased the partitioning of Hg or MeHg in the sediments and was further facilitated by the presence of organic matter. The bioavailability of Hg or MeHg from sediments was only slightly influenced by bacterial activity. This study highlights the importance of sorption from various sources (especially mercury-particle sorption) as well as bacteria in controlling the partitioning and bioavailability of Hg or MeHg in sediments.     

Particle-size-fractioned transfer of dioxins from sediments to water columns by resuspension process

Particle-size-fractioned transfer of dioxins from sediments to water columns by resuspension process was investigated, using supernatant samples obtained from shaking experiments of sediment-water pairs simulating natural disturbances. The concentrations (dry-matter mass basis) of individual compounds (Cfraction) in two particle size fractions (0.1-1 and 1-10 μm) in the supernatants were generally slightly higher than those in the original sediment (Csed). Cfraction/Csed ratios ranged from 0.45 to 5.9 (median 1.5) without consistent differences among congener groups or consistent correlations against the number of chlorine atoms. The dioxin concentrations in the water column associated with the remaining sediment particles can therefore be estimated by those in the original sediment and by the concentration of suspended sediment particles in the water. The concentration of each compound in the remaining sediment particles (mostly 0.1-10 μm in size) can be roughly estimated by multiplying the concentration in the original sediment by 1.5.     

烟草烟雾对室内空气颗粒物浓度的影响

采用电称冲击低压系统(ELPI)将无烟室和吸烟室内的空气颗粒物(0.03～10.00 μm)分成12级,对其粒子数和质量浓度进行测定.结果表明,吸烟室PM0.03～10.00的日平均粒子数和质量浓度分别是无烟室的1.50、1.13倍.烟草烟雾对室内颗粒物粒子数的影响集中在0.03～1.00 μm粒径段;对室内颗粒物质量浓度的影响表现为双模态结构,峰值分别在0.20～0.70、5.00～8.20 μm粒径段.烟草烟雾颗粒物的粒子数和质量浓度随烟雾消散时间的增加而减少,粒径越小,减小的越明显;烟草烟雾颗粒物在室内消散缓慢,会在长时间内造成影响,应引起足够关注.     

垃圾填埋场微生物气溶胶粒径分布研究

为了了解垃圾填埋场微生物气溶胶粒径分布规律,在北京市某垃圾卫生填埋场填埋区、渗滤液处理区、生活区分别选定监测点,利用安德森六级微生物采样器,对填埋场空气微生物进行了系统的定点取样、测定和分析。研究结果表明,空气细菌粒径分布均为第Ⅰ级(>8.2 μm)最高,填埋区空气细菌粒径呈偏态分布,渗滤液处理区、生活区分别在第Ⅳ级和第Ⅲ级出现第2个峰值。携带细菌的可吸入微粒在渗滤液处理区比例最大。空气真菌与放线菌均在第Ⅳ级分布最高,携带真菌和放线菌的可吸入粒子的比例显著大于细菌(P<0.05)。填埋区不同作业时段空气微生物粒径在各级分布比例基本一致。填埋区细菌气溶胶中值直径为5.7 μm,渗滤液处理区为3.7 μm,生活区为5.3 μm,显著大于真菌气溶胶和放线菌气溶胶的中值直径(P<0.05)。