大型浮顶储罐雷击事故分析及防雷技术研究

通过对典型大型浮顶储罐雷击事故分析,总结了这些事故的共性问题。结合浮顶储罐雷击形式及雷电火花放电研究,分析了大型浮顶储罐雷击火灾事故的机理。岚山输油站在等电位连接、一次密封形式结构等方面进行技术改造,经过验证这些措施有效减少了大型浮顶储罐火灾事故的发生。     

低温柴油吸收工艺在高温油品储罐罐顶废气净化中的应用

采用罐区减排措施和低温馏分油吸收-脱硫工艺处理高温油品罐罐顶废气,在处理气量43.0~384.5 m3/h,柴油流量10~20 m3/h,吸收柴油温度10~15℃条件下,废气经过净化后,硫化氢和有机硫化物去除率大于97.2%,净化气体非甲烷总烃浓度小于8.35 g/m3,均低于GB20950-2007《储油库大气污染物排放标准》和GB 16297-1996《大气污染物综合排放标准》中相关污染物的限值。     

重质油储罐固定式泡沫灭火系统设计优化研究

通过重质油储罐的实体火灭火试验,获得了氟蛋白泡沫液和水成膜泡沫液的供给强度与灭火时间对应关系数据,确定了每种泡沫液扑救重质油储罐火灾的最低泡沫供给强度;以10 000 m3固定顶重质油储罐为例进行了泡沫系统设计计算,将优化设计方案与原有设计方案进行了对比,主要变化是泡沫发生器数量从4只提高至6~8只,泡沫主管线管径从DN200提高至DN250,泡沫消防泵流量也相应提高。优化后的储罐泡沫灭火系统提高了泡沫灭火能力,提升了系统的可靠性,降低了储罐火灾风险。     

自然贮存环境下某型控制舱贮存寿命评估

目的评估自然贮存环境下某型控制舱贮存寿命。方法针对历年统计的控制舱成败型、不完全故障数据,假设其服从指数分布族、Weibull分布族、极值分布族、对数正态分布族,结合工程实际处理异常数据、"倒挂"数据,采用极小x2估计对分布函数的参数进行估计,采用极小x2检验对各分布函数的合理性进行验证,计算"服从不同自由度下的x2分布随机变量"检验的拟合优度。结果得到了控制舱贮存可靠性分布函数。结论通过统计的故障数据,验证了所提出数学模型评估方法的适用性和正确性,得到了在置信度为0.90、可靠度为0.95条件下控制舱的自然贮存寿命。     

海潮引起的海底承压含水层系统中地下水位的波动——海底弱透水层的弹性储水效应

研究了由潜水含水层、在海底延伸的承压含水层和介于其间的弱透水层构成的滨海含水层系统中,弱透水层的弹性储水以及含水层的海潮荷载效应对承压含水层中的地下水位的影响.研究结果表明,当海底弱透水层延伸足够长时,它的弹性储水对承压含水层中的海潮引起的水头波动有增强作用.     

Comparative evaluation of sizing of metal hydride (MH) hydrogen storage tank filled with different alloys

This study presents a comparative analysis of sizing of metal hydride tank filled with different alloys. Alloys include solid solutions and intermetallic compounds of the generic families AB₅, AB₂, AB, A₂B. The effects of the different alloys on the sizing of metal hydride hydrogen storage tanks are complicated and depend on many factors. In this paper, a thermoeconomic optimization analysis with a simple algebraic formula was presented for the estimation of optimum metal hydride tank surface area for heat transfer enhancement. The optimum area of the metal hydride tank filled with commercially available different alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) was evaluated and compared by the developed method. The optimum net savings and the value of payback were determined for four alloys. It is found that mathematical model can be employed for the determination of optimum metal hydride tank design and increasing net savings according to alloy types. The optimum areas of the tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) were calculated as 0.136, 0.130, 0.133, and 0.173 m², respectively. The optimum net savings for tanks filled with four alloys (LaN₅, Ti_0,98Zr_0,02V_0,43Fe_0,09Cr_0,05Mn_1,5, TiFe, Mg₂NiH₄) are about 461.0, 409.3, 419.6, and 979.6 $ and the values of payback are about 1.98, 2.1, 2.17, and 1.37 years, respectively. Excessive area of the metal hydride tank would not be as economical as the optimum tank area. Thermal management of metal hydride tank must be designed for optimum points calculated at which maximum savings occur.     

陕西省油松混交林木质残体储量与腐烂特征

木质残体是油松针阔混交林的重要组成部分,具有多种的生态功能,对生态系统的稳定和发展有着不可忽视的作用。以陕西省黄龙山林区为研究区域,设置1 hm2(100 m×100 m)的固定样地,研究典型油松针阔混交林木质残体的储量组成、优势树种的空间关系、腐烂特征及密度与含水量,研究结果表明:(1)研究区油松针阔混交林内木质残体的总储量为10.73 t·hm–2,倒木是林分内木质残体的主要来源。在径级组成结构上,径级20 cm以上的木质残体储量占总储量的绝大部分。腐烂等级中,以腐烂等级Ⅱ与腐烂等级Ⅲ的木质残体贮量最多;(2)利用线性模型模拟该林分木质残体的分解密度与含水量,其拟合结果显示木质残体的密度随着腐烂等级的增加而呈现下降趋势,而含水量则随着腐烂等级的增加而呈现升高的趋势;(3)林分内主要研究树种(油松、白桦和山杨)之间在小空间尺度上呈负关联,大尺度下呈正关联,顶级树种与先锋树种间达到互利共生,群落具有较大稳定性。林分内种间竞争的结果将为地带性顶级树种油松代替白桦与山杨等先锋树种。天然油松针阔混交林木质残体的贮量组成及腐烂特征反映了该区森林群落演替后期阶段木质残体的结构特征,本文的研究结果为我国黄土高原针阔混交林生态系统的管理和保护以及可持续经营提供科学依据。     

基于SD和CLUE-S模型的区域土地利用变化对土壤有机碳储量影响研究

土地利用/土地覆被变化改变土壤呼吸条件,进而对土壤有机碳储量变化产生影响,而土壤有机碳储量则是影响农业可持续发展和全球碳平衡领域的重要因素。以上海市崇明岛为例,运用系统动力学模型(System Dynamics Model)预测2020、2030年土地利用需求变化,结合CLUE-S模型(Conversion of Land Use and its Effects at Small region extent Model)得出各种用地类型的空间分布,并引用碳密度法估算三种发展幕景下土地利用变化对土壤有机碳储量的影响。结果表明:2030年三种发展幕景土壤有机碳储量分别为:低速发展幕景为3 093.03×106kg,惯性发展幕景为3 079.47×106kg,高速发展幕景为3 059.81×106kg;研究期内土壤有机碳储量呈现缓慢下降趋势,但人类活动对其扰动较小;SD和CLUE-S耦合模型可以从时间和空间两方面对土壤有机碳储量进行模拟,具有可行性;建议通过加强城镇用地集约利用、农田保护、林地建设来减少人为活动对土壤有机碳储量的影响。     

Comprehensive Environmental Investigation at Former Industrial/Petroleum Underground Storage Tank Sites in Long Beach,CA: A Forensic Perspective

Two industrial sites were investigated based on years of available hydrogeologic information and monitoring data for soil and groundwater. Collected data were forensically evaluated using age-dating and fingerprinting methods. The previous business uses of the project sites were as a gas station, laundry/dry-cleaning service, and car wash with petroleum underground storage tanks (USTs). As a result, these sites were exposed to a number of toxic contaminants at relatively high concentrations. Source control was necessary for successful remediation and the ultimate removal of the remaining compounds from these industrial sites. Although contaminated soil around the source was excavated during the remedial action and the high concentrations of contaminants were reduced, typical groundwater contaminants such as petroleum hydrocarbons as gasoline (TPH-G), benzene, toluene, ethylbenzene, xylenes (BTEX), and oxygenates including methyl tert-butyl ether (MTBE), diisopropyl ether (DIPE), ethyl tert-butyl ether (ETBE), tert-amyl methyl ether (TAME), and tert-butyl alcohol (TBA) were persistently found at the studied sites around the source points. The plume and concentration of contaminants had changed their shapes and strength for all monitoring periods. Thus, additional source control seems to be a requirement for the complete removal of source contamination, which must be ascertained with groundwater and soil monitoring on a regular time base. For the study sites, monitored natural attenuation was relatively feasible for the long-term plan; however, it did not offer a perfect remediation solution for an ultimate goal because of residual toxic compounds that might have affected the surrounding residential areas at higher concentrations than their health limits. Therefore, as a remediation strategy, the combination of clean-up technology and natural attenuation with monitoring activities are more highly recommended than either clean-up or natural attenuation used separately.     

渗滤液回灌对填埋垃圾含水率的影响研究

文章通过模拟实验研究了不同的渗滤液回灌频率、回灌量和回灌速率对压实密度不同的垃圾的含水率的影响。研究表明,由于通道流的存在和影响,渗滤液的产生时间提前于填埋垃圾达到其有效贮水率的时间;渗滤液回灌频率越高、回灌量越大、回灌速率越慢、垃圾体温度越低、垃圾压实密度越高,则填埋垃圾的有效贮水率越大、含水率越高。在实施渗滤液回灌操作时,须综合考虑滤液回灌频率、回灌量、回灌速率、垃圾温度和垃圾压实密度等影响因素。