Efficient removal of Cr(VI) by a 3D Z-scheme TiO2-ZnxCd1-xS graphene aerogel via synergy of adsorption and photocatalysis under visible light

Efficient and robust photocatalysts for environmental pollutants removal with outstanding stability have great significance. Herein, we report a kind of three dimensional (3D) photocatalyst presented as Z-scheme heterojunction, which combining TiO 2 and Zn x Cd 1- x S with graphene aerogel to contrast TiO 2 -Zn x Cd 1- x S graphene aerogel (TSGA, x = 0.5) through a moderate hydrothermal process. The as-prepared Z-scheme TSGA was used to remove aqueous Cr(VI) via a synergistic effect of adsorption and visible light photocatalysis. The adsorption equilibrium can be reached about 40 min, then after about 30 min irradiation under visible light (wavelength ( λ) > 420 nm) the removal rate of Cr(VI) almost reached 100%, which is much better than the performance of pristine TiO 2 and Zn 0.5 Cd 0.5 S, as well as TiO 2 graphene aerogel (TGA) and Zn 0.5 Cd 0.5 S graphene aerogel (SGA). The virulent Cr(VI) was reduced to Cr(III) with hypotoxicity after photocatalysis on TSGA, meanwhile the as-synthesized TSGA presented a good stability and reusability. The reduced graphene oxide (rGO) sheets between TiO 2 and Zn 0.5 Cd 0.5 S played a role as charge transfer mediator, promoting the photoinduced electrons transfer and photocatalysis ability of TSGA was enhanced significantly. Hence,such photocatalyst exhibits a potential application on removing heavy metals with high efficiency and stability from polluted aqueous environment.     

纤维增强气凝胶复合材料高温结构转变及热稳定性研究

目的研究高温受热条件下纳米复合隔热材料的结构转变特征及热稳定性。方法采用扫描电镜、X射线衍射仪、红外光谱仪及热重仪等检测方法。结果纤维增强气凝胶材料从室温到650℃存在连续的质量损失,从室温到放热前,质量损失为1.66%;365℃开始出现放热,温度升至398℃时达到峰值,整个放热过程对应质量损失约为1.3%;从435℃放热结束开始到650℃的质量损失为1.46%。经过400℃热处理后,试样比表面积从268m~2/g增加到437m~2/g;当试样热处理温度达到600℃时,试样的比表面积明显随之降低至198m~2/g。结论 SiO_2气凝胶复合材料以无定形结构为主,存在少量的二氧化钛晶体。在400℃左右,SiO_2气凝胶结构中硅甲基Si—CH_3发生氧化,产生明显的放热峰,之后硅羟基Si—OH之间发生缩聚反应,使600℃热处理后气凝胶中Si—O—Si网络骨架强度有所提高。未处理的纤维增强气凝胶材料试样上气凝胶纳米颗粒构成的块体较为良好地包裹在玻璃纤维表面,而经过600℃的高温热处理1 h后,块体气凝胶脱离了光滑的纤维表面,气凝胶纳米粒子发生收缩,致使材料比表面积下降。     

基于铁锰泥的除砷吸附剂性能比较及吸附机理

为解决反冲洗铁锰泥粉末吸附剂（BSPA）使用后难以泥水分离问题,将除铁锰水厂生物滤池产生的反冲洗泥制成颗粒吸附剂（GA）和磁性粉末吸附剂（MPA）,并对BSPA、GA和MPA的除砷性能进行了比较,通过SEM、TED、XRD、BET、FTIR等技术对3种材料进行了表征,寻找3种吸附剂之间除砷性能差异的根源.结果表明,BSPA、GA和MPA对As （V）的最大吸附容量分别为40.980,5.048,8.694mg/g,改性后的吸附材料GA和MPA对砷的吸附能力下降.BSPA是一种以纤铁矿为主的无定形结构混合物,并混有针铁矿和结晶度差的水铁矿,GA的XRD图谱中出现石英晶体和少量赤铁矿晶体的衍射峰,而MPA的主要成分为结晶程度较高的磁赤铁矿.3种材料中均存在有利于吸附的含羟基官能团.BSPA、MPA和GA的比表面积分别为253.150,238.660,43.803m²/g.物相改变且结晶程度增加、表面羟基减少和比表面积降低是导致GA和MPA的砷吸附容量比BSPA低的主要因素.     

染化废水厌氧生物处理技术的研究

鉴于厌氧微生物对偶氮染料的还原裂解作用，开发了以易降解工业有机废水作为外加碳源的染化废水厌氧生物处理的新技术．试验结果表明：在进水ＣＯＤ３１００—３５００ｍｇ／Ｌ，ＣＯＤ总／ＣＯＤ染化比值４０，ＨＲＴ３．０ｄ下，ＣＯＤ去除率＞８０％，最低染化ＣＯＤ去除率＞４５％，色度去除率＞８５％；实验证实，在厌氧处理过程中，染料组分的结构已发生了明显的变化；反应器内的污泥大多呈颗粒状；污泥活性和工艺性能可控制工艺运行参数得以维持．     

Acid resistance of methanogenic bacteria in a two-stage anaerobic process treating high concentration methanol Wastewater

In this study, the two-stage upflow anaerobic sludge blanket (UASB) system and batch experiments were employed to evaluate the performance of anaerobic digestion for the treatment of high concentration methanol wastewater. The acid resistance of granular sludge and methanogenic bacteria and their metabolizing activity were investigated. The results show that the pH of the first UASB changed from 4.9 to 5.8 and 5.5 to 6.2 for the second reactor. Apparently, these were not the advisable pH levels that common methanogenic bacteria could accept. The methanogenic bacteria of the system, viz. Methanosarcina barkeri, had some acid resistance and could still degrade methanol at pH 5.0. If the methanogenic bacteria were trained further, their acid resistance would be improved somewhat. Granular sludge of the system could protect the methanogenic bacteria within its body against the impact of the acidic environment and make them degrade methanol at pH 4.5. The performance of granular sludge was attributed to its structure, bacteria species, and the distribution of bacterium inside the granule. Translated from Acta Scientiae Circumstantiae, 2004, 24(4): 633–636 [译自: 环境科学学报]     

升流式厌氧污泥床筛分强度数学模型研究

通过对升流式厌氧污泥床的流动分析，提出了用离散数Ｄ定量地表示筛分强度。通过实验和回归分析，建立了Ｄ与水力负荷（Ｌ）和沼气沼气容积产量（Ｇ）的数学关系：Ｄ＝０．００３３Ｌ＋０．０４５Ｇ＋０．０７３。当Ｄ在０．０８８－０．０９５之间，用生活污水作基质，成功地培养出了颗粒污泥。     

Mechanisms of granular activated carbon anaerobic fluidized-bed process for treating phenols wastewater

ＩｎｔｒｏｄｕｃｔｉｏｎＢｅｆｏｒｅｔｈｅ 1 980ｓｃｏｎｖｅｎｔｉｏｎａｌｔｒｅａｔｍｅｎｔｐｒｏｃｅｓｓｅｓｏｆｐｈｅｎｏｌｓｗａｓｔｅｗａｔｅｒａｒｅｓｏｌｖｅｎｔｅｘｔｒａｃｔｉｏｎ ,ｐｈｙｓｉｃａｌａｄｓｏｒｐｔｉｏｎ ,ｃｈｅｍｉｃａｌｏｘｉｄａｔｉｏｎａｎｄａｅｒｏｂｉｃｂｉｏｌｏｇｉｃａｌｐｒｏｃｅｓｓ.Ａｍｏｎｇｔｈｅｂｉｏｌｏｇｉｃａｌｕｎｉｔｐｒｏｃｅｓｓｅｓａｃｔｉｖａｔｅｄｓｌｕｄｇｅｐｒｏｃｅｓｓｉｓｍａｉｎｏｎｅ.Ａｆｔｅｒｔｈｅ 1 980ｓａｎａｅｒｏｂｉｃｂｉｏｌｏｇｉｃ…     

On the influence of sand-wind on atmospheric environment

The authors seek, through tests on simulated sand samples in a wind tunnel and analysis of minerals combination and trace elements, to discover the environmental implications of flying-up, falling-down and concentration variation as a function of natural wind speed and direction, distance of movement, range and extent of influence on the atmospheric environment, of micro-granular components on the ground surface in the Keerqin desert area in northwest Liaoning Province of China.     

镧、铈对厌氧颗粒污泥产甲烷的Hormesis效应及其动力学研究

间歇培养条件下研究了单一稀土元素镧(La3 )和铈(Ce3 )在不同浓度水平下对厌氧颗粒污泥活性及其动力学行为的影响.结果表明,La3 和Ce3 对厌氧颗粒污泥比产甲烷活性有促进作用的浓度范围均为0.01～0.1 mg·L-1,促进作用浓度峰值均为0.05mg·L-1,最大促进百分比分别为10.35%和20.79%;La3 和Ce3 对SMA(比甲烷活性)的半抑制浓度分别为5mg·L-1和1000mg·L-1,La3 较易对污泥产生抑制作用.米-门方程可以用来描述厌氧消化过程中甲烷发酵阶段的动力学行为,稀土元素La3 和Ce3 投加至反应系统后,提高了甲烷发酵过程的动力学常数Vmax和半饱和常数Ks.