Identification of relevant micropollutants in Austrian municipal wastewater and their behaviour during wastewater treatment

The European Union has defined environmental quality standards (EQSs) for surface waters for priority substances and several other pollutants. Furthermore national EQSs for several chemicals are valid in Austria. The study investigated the occurrence of these compounds in municipal wastewater treatment plant (WWTP) effluents. In a first screening of 15 WWTPs relevant substances were identified, which subsequently were monitored in 9 WWTPs over 1 year (every 2 months). Out of 77 substances or groups of substances (including more than 90 substances) 13 were identified as potentially relevant in respect to water pollution and subjected to the monitoring, whereas most other compounds were detected in concentrations far below the respective EQS for surface waters and therefore not further considered. The preselected 13 compounds for monitoring were cadmium (Cd), nickel (Ni), copper (Cu), selenium (Se), zinc (Zn), diuron, polybrominated diphenyl ethers (PBDEs), di(ethyl-hydroxyl)phthalate (DEHP), tributyltin compounds (TBT), nonylphenoles (NP), adsorbable organic halogens (AOX) and the complexing agents ethylenediaminetetraacetic acid (EDTA) as well as nitrilotriacetic acid (NTA). In the effluents of WWTPs the concentrations of the priority substances Cd, NP, TBT and diuron frequently exceeded the respective EQS, whereas the concentrations for DEHP and Ni were below the respective EQS. The effluent concentrations for AOX, EDTA, NTA, Cu, Se and Zn frequently are in the range or above the Austrian EQS for surface waters. Besides diuron and EDTA all compounds are removed at least partially during wastewater treatment and for most substances the removal via the excess sludge is the major removal pathway. For the 13 compounds which were monitored in WWTP effluents population equivalent specific discharges were calculated. Since for many compounds no or only few information is available, these population equivalent specific discharges can be used to assess emissions from municipal WWTPs to surface waters as well as to make a first assessment of the impact of a discharge on surface waters chemical status. Comparing discharges and river pollution on a load basis, the influence of diffuse sources becomes obvious and therefore should also be taken into consideration in river management.     

磷酸铵镁沉淀法预处理垃圾渗滤液

探讨了用磷酸铵镁沉淀法预处理垃圾渗滤液时,沉淀剂种类、pH值、物质摩尔配比和反应时间等因素对氨氮去除效果的影响。得出了处理氨氮浓度为2 677.34 mg/L的垃圾渗滤液时,在兼顾所用镁盐量尽量低和处理出水氨氮或磷酸盐的残留量都比较低的较佳实验条件为:沉淀剂种类为:MgSO4.7H2O和Na2HPO4.12H2O,反应时间为20 min,pH=9.5,n(Mg)∶n(P)∶n(N)=1.3∶1.15∶1.0。在较佳实验条件下,垃圾渗滤液的NH3-N去除率为97.05%,处理出水PO34--P含量为8.35 mg/L,NH3-N含量为75.86 mg/L。对所得沉淀物进行了成分分析和X-衍射光谱、扫描电镜表征,表明大部分沉淀物为磷酸铵镁物质。     

反渗透膜处理维生素C凝结水的最优工艺条件

针对维生素C生产工艺中产生的凝结水产量大、处理成本高、存储运输困难和营养物质含量偏低等问题,采用反渗透技术对VC凝结水进行处理。实验建立小试规模反渗透膜处理装置,采用无量纲化多元回归分析方法,分析了操作条件指标与渗透水评价指标两套指标体系之间的关系,定量评价了各个操作条件指标对渗透水评价指标的整体影响程度,并在此基础上研究了最佳操作条件的工艺参数。结果表明：建立的无量纲化多元回归分析方法切实有效,在正交实验设计水平范围内,压力、pH和回流比均是多目标系统的影响因子,操作条件指标对渗透水评价指标的整体影响程度大小顺序为：压力〉pH〉回流比〉温度,且各自影响程度所占比例分别为43．02％、29．01％、25．07％和2．89％。各个操作因子对多指标系统的影响是独立的。在只考虑系统收益而不考虑膜污染的情况下,最佳操作条件分别为：温度r=30．65,压力P=1．5MPa,回流比r=0．78,pH=7．475。     

水环境中腐殖酸与镉离子结合作用的影响因素

通过测定不同化学条件下腐殖酸与镉离子作用后的游离态镉离子浓度及其结合率,研究各因素对腐殖酸与镉离子作用的影响。研究结果表明,pH值、离子强度、投加镉离子总浓度、腐殖酸浓度和反应温度均影响腐殖酸与镉离子的结合。pH值在4.5~6.5范围内,随pH值升高,腐殖酸与Cd²⁺的结合率增大,游离态Cd²⁺浓度减少。溶液的离子强度增大对结合反应有抑制作用。投加Cd²⁺总浓度的增大会导致结合态Cd²⁺浓度和游离态Cd²⁺浓度逐渐增加,而其结合率逐渐减小。腐殖酸浓度逐渐增大,使Cd²⁺和腐殖酸的结合率逐渐增大。在20℃~50℃范围内时,随反应温度升高,游离态Cd²⁺浓度逐渐减小,其结合率逐渐增加。     

基于AHP的可听噪声影响因素权值分析

影响超高压输电线路可听噪声的因素众多,对影响可听噪声的因素进行合理分析确定其对可听噪声影响的权重是进行可听噪声预测和合理有效降低可听噪声的前提。对影响可听噪声的因素进行分析并运用层次分析法（AnalyticHierarchyProcess,AHP）对影响可听噪声的主要因素进行加权分析,以定量的形式确定影响因素的相对重要度。结果表明,应用层次分析法确定的可听噪声影响因素权重符合实际,准确性较高,为可听噪声选择主要影响因素用于预测及有效降低可听噪声提供参考依据。     

膜曝气生物膜反应器生物膜影响因素分析

膜曝气生物膜反应器（MABR）是一种利用透气膜进行曝气,可以实现同步硝化反硝化的污水生物处理新工艺。本文阐述了膜曝气生物反应器生物膜的原理和特点,总结了国内外在该领域的研究成果,重点介绍了C／N、氧气压力、流速、生物膜厚度、温度和pH对生物膜性能的影响。     

流动注射法测定水中阴离子表面活性剂的探讨

本文采用流动注射分析技术在线测定水中阴离子表面活性剂,使用的仪器为德国BRAN＋LUEBBE公司自动分析仪。方法在0.050～0.400mg/L范围内,可以获得较好的线性方程,相关系数〉0.9990,检出限为0.015mg/L,水样的回收率在92%～109%,此方法符合水质测定阴离子表面活性剂的要求。并对影响阴离子表面活性剂测定的因素进行探讨。     

我国电子废物污染现状及环保利用浅析

通过分析与电子废物回收处理密切联系的工艺技术、规划管理和各种外部环境等因素,剖析我国电子废物处理产业面临的障碍,并提出解决建议。     

电源变压器温升试验中（绕组法）的影响因素及不确定度的评估

本文中探讨的是根据绕组法计算电源变压器绕组温升的试验方法,以及对整个试验过程中环境、仪器设备、仪表、人为因素所引起的误差等对最终试验结果的影响,并对其测量不确定度进行评估。     

考虑人为因素的可靠性评估

统计数据表明,系统的可靠运行不可忽略人为误操作造成的故障,该故障发生率有时甚至超过设备本身导致的系统故障发生率。将人为因素与设备自身因素造成的系统故障进行对比,分析人为因素造成系统故障后的特点,可得出人为因素的可靠性参数。根据解析法和模拟法的相关理论计算考虑人为因素的可靠性指标,可以看出考虑人为因素的计算结果更加符合实际运行特点,便于相关人员采取对策,保障系统的安全运行。