循环流化床锅炉床温控制方法

就目前电厂循环流化床锅炉运行中存在的床温波动问题，讨论了导致床温波动的因素，并针对性地提出了控制床温的一些措施。     

新疆宝浪油田污水达标回注技术应用

新疆宝浪油田污水处理原来采用外排方式,严重污染了周边环境。为此,通过对处理工艺进行的改进,对分散自控系统的升级改造及对处理药剂进行了重新筛选。改造后终端出口水质的悬浮物由200 mg/L下降到3.93 mg/L,去除率为96%,含油量由200 mg/L降为0.79 mg/L,去除率为99%,含铁为3.9 mg/L,细菌总数为4.5个/mL,硫酸盐还原菌为4.5个/mL,处理后的污水水质达到了《碎屑岩油藏注水水质推荐指标及分析方法》标准回注要求。     

供水管线震害量化参数--渗漏面积的估算方法

为了分析管线破坏状态对震后供水管网功能的影响，首先需要对管线的震害状态进行量化。建议用管线渗漏面积标定管线的破坏状态。在管线震害分析和理论计算的基础上，提出了震后管线渗漏面积的计算方法，为进一步进行供水管网抗震分析和设计提供了研究基础。     

黄土高原地区生态建设的关键问题

从黄土高原地区水土保持生态建设的实际情况出发,结合历史经验教训,探讨了生态建设与农业发展、农民脱贫致富的关系.指出生态环境问题归根结底是人的问题,减少人类对生态环境的破坏和干扰,因地制宜地进行植被建设和生态恢复,激励广大农民自觉参与生态建设对黄土高原地区水土保持生态建设成败至关重要.     

长江上游重庆段近20 a降水时空变化特征

全球气候变暖背景下,中国的降水分布日趋复杂,气象灾害造成的损失巨大。为满足防灾减灾与水资源管理的数据支撑需求,基于长江上游重庆段近20 a降水数据,利用线性回归、M-K非参数检验等方法,探究降水的时间变化趋势与空间分异特征。结果表明：近20 a重庆市年降水量在875.6—1348.2 mm。时间上,春、秋两季呈明显增多的趋势,其中3月最显著。降水在14 a时间尺度的周期过程线中波动最强,是第一主周期。空间分布上,呈西低东高的特点,在渝西和长江河谷地区降水相对偏少,主要受重庆地形的影响;渝西和渝东北地区秋季降水显著增多。研究结果可为长江流域旱涝灾害防治、水资源开发利用及经济社会可持续发展提供数据支撑,同时可为植被修复与生态廊道保障提供参考。     

1994年江淮伏旱及其影响研究

利用江谁地区18个站点1951～1995年6～8月降水量资料,用Z指数建立了历年夏季旱涝序列,着重对1994年江淮伏旱及其对农业、水资源的影响进行了分析评述,获得了一些有意义的结论。     

荆江分洪区1998年洪水转移调查分析

对荆江分洪区１９９８年洪水期间安全转移的调查表明,叶然有分洪预案,但实际转移时仍出现了相当程度的拥挤与混乱。完善分洪转移的组织与管理,已成为分洪区居民１９９８年转移后关注的焦点,分洪区居民普遍表现出对分洪洪水情不甚了解,通过各种方式开展有关洪水的宣伟,提高区内居民的防洪意识,是荆江分洪区未来防洪减灾的重点工作之一,由于是国家为保护更重要的地区而主动分洪。对分洪区历分洪蒙受的损失给预某种形式的补偿已     

原状黄土的反压饱和法试验研究

含水量是黄土液化特性研究中的一个至关重要的参数,对原状黄土进行充分饱和是饱和黄土动三轴试验中一个不可回避的课题。以WF公司生产的WF12440型空心圆柱扭剪仪为实验平台,运用反压饱和法,对室内原状黄土进行了饱和试验研究。该仪器提供3种不同加压方式增加围压和反压(孔压),即手动加压、自动加压和线性持续加压,通过检测孔隙压力系数B值是否达到0.95以上来判断黄土是否完全饱和。试验表明,即便是初始饱和度较低的原状黄土,也可以采用反压饱和法,在较短的时间内使孔压系数B值达到0.95以上,实现完全饱和,具体可以采用线性连续加压方式;初始压力差,即围压和反压之差一般可设为10 kPa,起始围压也设为10 kPa,太大或太小都会对试样造成破坏;如果孔压在1分钟内的变化值小于围压和反压之间压力差的5%,则认为孔压稳定,即可进行B值检测。     

Impact of leakage location and downwind storage tank on the gas dispersion in a typical chemical tank storage area

Toxic gas leakage in a tank area can have catastrophic consequences. Storage tank leakage location (particularly for high leakage) and downwind storage tanks potentially influence gas diffusion in tank areas. In this study, we developed a numerical and experimental method to investigate the impact of a high leakage location and downwind storage tank on gas diffusion based on three (1.05H, 0.90H, and 0.77H, H was the tank height, 22m) leakage field experiments on the leeward side of storage tank, which have been not conducted before. The experiments revealed an unexpected phenomenon: the maximum ground concentration first decreased and then increased with increasing leakage height. The simulations illustrated that the differences in micrometeorological conditions caused the maximum ground concentration of gas emitted from the roof to be higher than that emitted from the tank wall near the storage tank height. The downwind storage tank 1) had little influence on the entire diffusion direction but altered the local diffusion pattern; 2) reduced the maximum ground concentration (∼18.7%) and the distance from the emission source (approximately a storage tank diameter); and 3) had strong influences on the concentration, velocity, turbulence, and pressure on the leeward side. The concentration negatively correlated with the velocity, pressure, and turbulence in the middle of the two storage tanks on wind centerline. Our results can improve understanding of gas dispersion in tank areas and provide references for mitigating loss and protecting lives during emergency response processes.     

Effect of particle size on CO adsorption and thermodynamic analysis

The liquid nitrogen adsorption method was used to characterize the pore structure of non-cohesive coal in the 061,404 working face of the Lingxin coal mine. The amount of specific surface area of micropores in the sample continuously rose as particle sizes reduced. The volumetric method was used to measure the CO isothermal adsorption curves of three samples (sample I, 0.425–0.25 mm, sample II, 0.18–0.25 mm, and sample III, 0.15–0.18 mm). The experimental results were fitted by the Langmuir model. According to the experimental results, it was conducive to CO adsorption with the conditions of high pressure and low-temperature. The decrease in grain diameter increased the number and volume of micropores in the sample, which improved the adsorption capacity of the sample. In addition, according to the adsorption data, the CO adsorption thermodynamics of three samples were analyzed, including surface potential (Ω), Gibbs free energy change (ΔG) and entropy change (ΔS). The results demonstrated that CO adsorption by coal was a spontaneous process. Sample III has the most substantial adsorption capacity, whereas the sample I has the weakest adsorption capacity.