测定固体废物中总铬的前处理方法的探索

本文完善了电热板消解方法,增加了微波消解法.并将两者进行比对试验,实验结果表明对浸出液中总铬进行前处理消解时,电热板与微波消解法都适用,两种方法之间不存在明显的系统误差,准确度、精密度都符合质控要求.     

沂蒙山区不同覆被棕壤理化特征对径流溶解态氮磷输出的影响

以沂蒙山区的棕壤为例,利用野外原位模拟降雨试验,在分析荒草地、侧柏林、金银花、山楂园和花生地等5种典型覆被下棕壤坡地径流溶解态氮(DN)、磷(DP)输出特征的基础上,探讨了不同土地覆被类型下棕壤主要理化性质差异对径流DN、DP输出的影响.结果表明,在降雨强度(70 mm·h-1)、地形和植被覆盖度等条件较为一致的情况下...     

Safety and reliability assessment of external corrosion defects assessment of buried pipelines—soil interface: A mechanisms and FE study

Due to local liquid accumulation (AL) in the low-lying section of the buried natural gas pipeline, external corrosion will occur at the interface between the pipeline and the soil. External corrosion will produce pit defects, which will reduce the bearing capacity of the pipeline and affect the normal operation of the pipeline. In addition, corrosion group defects can interact with each other. Thus, the service life of the pipeline is seriously affected. In this work, a case of local corrosion failure of the pipeline caused by liquid accumulation on-site is presented. The importance of this work is verified by experiment and field excavation. Besides, based on the Mises-Stress yield criterion, nonlinear analysis was carried out with the finite element method (FEM). The effects of internal pressure, corrosion pit defect size, internal and external wall corrosion, corrosion pit group, and different types of volumetric corrosion pit defects on the failure of L360QS steel pipe were analyzed with consideration of the effects of axial and circumferential zones of corrosion pits. These correlations have not been seen in previous studies. The FE results make up for the disadvantage that the corrosion is simplified to equal depth corrosion in the code, which will underestimate the residual strength of the actual corroded pipeline and lead to unnecessary repair or replacement. The results provide a reference for failure analysis and strength evaluation of buried L360QS steel pipe with corrosion defect.     

复配型表面活性剂协同无机盐润湿煤尘性能研究*

为有效提高雾化降尘效率,以长焰煤为例,从接触角、表面张力静态试验和粒径测定、喷雾降尘动态试验角度切入,探究不同类型表面活性剂与无机盐的协同关系,进而优选出降尘效果最佳的配比方案。研究结果表明:阴与阴、阴与非、非与非离子复配型表面活性剂与无机盐之间均存在显著协同效应,且通过正交试验可确定协同效果最优的3组配方及其最佳浓度;对比清水,3组配方的平均粒径均有所减小,降尘效率均有大幅提升。综合优选出的最佳配比为质量分数0.08%的仲烷基磺酸钠、0.04%的曲拉通X-100和0.04%的氯化钙复合配制的溶液,该方案的全尘降尘效率为92.55%,比清水提升79.95%;呼尘降尘效率为91.27%,比清水提升82.36%。     

Effect of solid contents on the controlled shear stress rheological properties of different types of sludge

Controlled shear stress (CSS) test was used to study the effect of solid contents on the corresponding rheological parameters for sludge. Three types of sludge with or without conditioning, including activated sludge (AS), anaerobic digested sludge (ADS), and water treatment residuals (WTRs), were collected for the CSS test. Results showed that the yield stress and the cohesion energy of the sludge networks were improved with increased total suspending solid (TSS) contents in most cases. For the conditioned AS/ADS and the raw WTRs, exponential law was observed in the relationships between cohesion energy of material networks or yield stress and the TSS contents, whereas for the conditioned WTRs, only exponential law dependence was found between the parameters of shear modulus or critical strain and the TSS contents.     

海洋卡盾藻（香港株）溶血活性特征研究

研究了海洋卡盾藻香港株（Chattonella marina,Hong Kong strain,CMHK）在不同生长阶段和营养条件下的溶血活性特征.根据海洋卡盾藻的生长曲线,分别收集对数生长期、稳定期、衰亡期的藻细胞进行溶血毒性的测定;采用不同营养元素结构的培养基对CMHK进行培养,对不同培养条件下的藻细胞进行溶血活性...     

制浆造纸废水对水生生物急性毒性研究

目前我国工业废水排放的监督和管理主要以理化监测为主,而理化分析并不能实际反映出水污染源对水体中受害生物的综合毒害强度。该研究同时采用鱼类急性毒性试验、溞类急性毒性试验、发光细菌急性毒性试验和藻类生长抑制试验测定制浆造纸排放废水的生物毒性大小,根据上述毒性实验所测定的半数效应的体积百分比浓度,筛选出对该行业废水最为敏感的毒性试验方法和试验生物,同时结合毒性单位法和废水中的常规污染物浓度与特征污染物对该排放废水进行了综合评价。试验结果表明:该制浆造纸废水对斑马鱼的96 h LC50为33.24%、33.33%和32.96%,属中毒;对大型溞的48 h LC50为27.01%和37.47%,属中毒;对青海弧菌Q67的15 min EC50远远小于10%,属高毒或剧毒;对斜生栅藻的96 h EC50为50%~100%,属低毒。可见,发光细菌毒性试验方法对制浆造纸废水最为灵敏;同时测定4类生物急性毒性的方法为建立我国重点废水排放行业的生物毒性监测方法体系和适合不同污染源废水的试验生物目录库奠定了基础;虽然部分制浆造纸废水的理化指标已经达标,但是其生物毒性较强,这说明采用生物毒性监测配合理化监测方法监测水污染源排放的废水,才能更深刻了解污染物对水生态环境的实际影响,水生生物毒性试验是化学试验的必要补充。     

HDPE土工膜长期性能稳定性的研究进展

垃圾填埋场底部高密度聚乙烯(HDPE)土工膜会因氧化降解而使防渗性能降低,对环境带来二次污染风险,因此,HDPE膜的长期稳定性是值得关注的问题,但国内相关研究甚少。HDPE膜的降解过程可分为3个阶段,主要受自身性质、温度、接触介质和衬垫结构等因素的影响。文章重点综述了国外研究HDPE膜长期稳定性的试验方法,归纳了相关的数学模型,并根据存在的问题提出了建议。室内试验一般采用老化试验,包括浸泡试验和模拟试验,二者均能加快HDPE膜的老化进程。前者一般将试样完全浸泡于研究介质中试验,试验值较为保守;后者将样品置于模拟的衬垫构造中试验,结果更接近实际。数学模型采用Arrhenius模型,精度和所需参数取决于老化试验,现阶段大部分计算结果较片面,完善试验是后续工作的重点。     

铸铝合金不同厚度膜层微弧氧化防腐蚀性能试验研究

针对某型铸铝合金的不同热处理状态、不同厚度的微弧氧化膜的防腐蚀性能进行了960 h的盐雾对比试验。结果表明,对于该型铸铝合金T7热处理状态防腐蚀能力优于T5;微弧氧化处理能明显提高该型铸铝合金防腐蚀能力,经不同厚度微弧氧化处理的该型铸铝合金,腐蚀深度无显著差异;在相同面积区域内,腐蚀损伤的程度有明显的不同,50～70μm的微弧氧化膜防腐蚀性能最好。     

装备试验分析研究与管理监督

装备试验种类多、任务重,实际工作中存在许多模糊认识与做法。从试验的概念入手,理清、辨析了几种重要试验,分析研究了各种试验的特点,给出了具有实践应用意义上的试验原理、程序和方法,在此基础上对试验进行了相应的管理与监督。