雨天硫酸盐化速率样品扩散分析

选择采样期不同降雨天数的碱片,测定余边的硫酸盐化速率含量,其结果为：采样期全月无雨时,余边上的硫酸盐均未检出;半月以上至全月有雨时检出率为１００％,检出量占样品量的２．７０～１５．９５％。经扩散试验,查清了余边上的硫酸盐主要是有效面积上采集的样品的扩散,并提出了相应的修正方法。     

The removal of lignin and phenol from paper mill effluents by electrocoagulation

This study aims to investigate the treatment of paper mill effluents using electrocoagulation. Removal of lignin, phenol, chemical oxygen demand (COD) and biological oxygen demand (BOD) from paper mill effluents was investigated at various current intensities by using different electrodes (Al and Fe) and at various electrolysis times (1.0, 2.5, 5.0 and 7.5min). It was observed that the experiments carried out at 12V, an electrolysis time of 2min and a current intensity of 77.13mA were sufficient for the removal of these pollutants with each electrode. The removal capacities of the process using an Al electrode were 80% of lignin, 98% of phenol, 70% of BOD, and 75% of COD after 7.5min. Using an Fe electrode the removal capacities were 92%, 93%, 80% and 55%, respectively. In addition, it was found that removal of lignin, phenol, BOD and COD increased with increasing current intensity. In the experiments carried out at different current intensities, higher removal can be explained through a decrease in intra-resistance of solution and consequently an increase at the transfer speed of organic species to electrodes. It was also found that Al electrode performs higher efficiency than Fe electrode except for COD removal. However, the time required for removal of BOD was more than that of COD. The results suggest that electrocoagulation could be considered as an effective alternative to paper mill effluents treatment.     

Life cycle assessment of waste paper management: The importance of technology data and system boundaries in assessing recycling and incineration

The significance of technical data, as well as the significance of system boundary choices, when modelling the environmental impact from recycling and incineration of waste paper has been studied by a life cycle assessment focusing on global warming potentials. The consequence of choosing a specific set of data for the reprocessing technology, the virgin paper manufacturing technology and the incineration technology, as well as the importance of the recycling rate was studied. Furthermore, the system was expanded to include forestry and to include fossil fuel energy substitution from saved biomass, in order to study the importance of the system boundary choices. For recycling, the choice of virgin paper manufacturing data is most important, but the results show that also the impacts from the reprocessing technologies fluctuate greatly. For the overall results the choice of the technology data is of importance when comparing recycling including virgin paper substitution with incineration including energy substitution. Combining an environmentally high or low performing recycling technology with an environmentally high or low performing incineration technology can give quite different results. The modelling showed that recycling of paper, from a life cycle point of view, is environmentally equal or better than incineration with energy recovery only when the recycling technology is at a high environmental performance level. However, the modelling also showed that expanding the system to include substitution of fossil fuel energy by production of energy from the saved biomass associated with recycling will give a completely different result. In this case recycling is always more beneficial than incineration, thus increased recycling is desirable. Expanding the system to include forestry was shown to have a minor effect on the results. As assessments are often performed with a set choice of data and a set recycling rate, it is questionable how useful the results from this kind of LCA are for a policy maker. The high significance of the system boundary choices stresses the importance of scientific discussion on how to best address system analysis of recycling, for paper and other recyclable materials.     

A decision framework for possible remediation of contaminated sediments in the River Kymijoki, Finland

Background, aim, and scope  The paper describes the spatial contamination of the River Kymijoki, South-Eastern Finland, and the coastal region of the Gulf of Finland with PCDD/Fs and mercury. The findings of ecotoxicologial and human health studies are also reported, including environmental and human risk assessments. Sediments from the River Kymijoki, draining into the Gulf of Finland, have been heavily polluted by the pulp and paper industry and by chemical industries. A wood preservative, known as Ky-5, was manufactured in the upper reaches of the river between 1940 and 1984 causing severe pollution of river sediments with polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF). Moreover, the sediments have been polluted with mercury (Hg) from chlor-alkali production and the use of Hg as a slimicide in pulp and paper manufacturing. Materials and methods  An extensive sediment survey was conducted as well as sediment transport modeling, toxicity screening of sediment invertebrates, and a survey of contaminant bioaccumulation in invertebrates and fish. Studies on human exposure to PCDD/Fs and the possible effects on hypermineralization of teeth as well as an epidemiological study to reveal increased cancer risk were also conducted. An assessment of the ecological and human health risks with a null hypothesis (no remediation) was undertaken. Results  The sediment survey revealed severe contamination of river and coastal sediments with PCDD/Fs and Hg. The total volume of contaminated sediments was estimated to reach 5 × 10⁶ m³ and hot spots with extremely high concentrations (max 292,000 ng g⁻¹ or 1,060 ng I-TEQ g⁻¹ d.w.) were located immediately downstream from the pollution source (approximately 90,000 m³). Sediment contamination was accompanied by changes in benthic assemblages, but direct effects were masked by many factors. The fish showed only slightly elevated PCDD/F levels in muscle, but orders of magnitude higher in the liver compared with reference freshwater sites and the Baltic Sea. The concentrations in human fat did not reveal high human exposure in the Kymijoki area in general and was lower than in sea fishermen. The relative risk for total cancer among farmers was marginally higher (RR = 1.13) among those living close to the river, compared with farmers living further away, and the possibility of increased cancer risk cannot be ruled out. A conservative risk assessment revealed that the present probability of exceeding the WHO upper exposure limit of 4 pg WHO-TEQ kg⁻¹ d⁻¹ for PCDD/Fs and DL-PCBs was 6%. The probability of exceeding the WHO limit value of 0.23 μg kg⁻¹ d⁻¹ for methyl mercury was estimated to be notably higher at 62%. Based on these studies and the estimated risks connected with different remediation techniques a general remediation plan with cost benefit analysis was generated for several sub-regions in the river. Dredging, on-site treatment, and a close disposal of the most contaminated sediments (90,000 m³) was suggested as the first phase of the remediation. The decision regarding the start of remediation will be made during autumn 2008. Conclusions  The sediments in the River Kymijoki are heavily polluted with PCDD/Fs and mercury from earlier chlorophenol, chlor-alkali, and pulp and paper manufacturing. A continuous transport of contaminants is taking place to the Gulf of Finland in the Baltic Sea. The highly increased PCDD/F and Hg levels in river sediments pose an ecotoxicological risk to benthic fauna, to fish-eating predators and probably to human health. The risks posed by mercury exceed those from PCDD/Fs and need to be evaluated for (former) chlor-alkali sites and other mercury releasing industries as one basis for remediation decision making. Recommendations and perspectives  The studies form the basis of a risk management strategy and a plan for possible remediation of contaminated sediments currently under consideration in the Southeast Finland Regional Environment Centre. It is recommended that a detailed restoration plan for the most seriously contaminated areas should be undertaken. Based on current knowledge, the restoration of the whole river is not feasible, considering the current risk caused by the contaminated sediment in the river and the costs of an extensive restoration project. The experiences gained in the present case should be utilized in the evaluation of PCDD/F- and mercury-contaminated sites in other countries. The case demonstrates that the historic reservoirs are of contemporary relevance and should be addressed, e.g., in the national implementation plans of the Stockholm Convention. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Dioxin formation in pulp and paper mills of India

Samples of effluents, sludge, pulp, final products (paper) and soil were collected from the identified pulp and paper mills in India. The samples were analysed for 2,3,7,8-tetrachloro-dibenzo-p-dioxin (2,3,7,8-TCDD) and other dioxin congeners and precursors. Pulp and paper mills using chlorine for the bleaching process showed the presence of 2,3,7,8-TCDD in effluent samples. In the effluent and pulp samples from mills where chlorine dioxide was used as a bleaching agent, the 2,3,7,8-TCDD congener ranged from below the detection limit 0.05 to 0.12 ngL⁻¹/ngg⁻¹. The relative standard deviation of reproducibility and the percent recovery of 2,3,7,8-TCDD were 2.07 and 82.4% in pulp and 2.8 and 92% in effluent, respectively. The 1,3,6,8-TCDD was the only other major dioxin congener found in the treated and untreated effluent and sludge samples. However, dichlorobenzene, trichlorophenyl, and hexachlorobiphenyl were detected in all samples. The formation of dioxins can be minimised by replacing chlorine with chlorine dioxide in bleaching processes in pulp and paper mills.     

三氧化钨光催化法脱色处理化纤厂废水

以WO3粉体作为催化剂对化纤厂废水采用光催化氧化法进行脱色处理,讨论了光催化氧化法的反应机理,以及化纤厂废水的pH值、光催化剂的投入量、光照时间各因素对废水色度去除率的影响。实验结果表明：WO3粉体的投入量为1．000g／L,pH值为3．00时,利用300W高压汞灯光照7h后,废水试样的吸光度由0.596降低至0．020,色度去除率达到96．6％。     

亚铵法制浆造纸厂中段废水处理技术分析研究

通过对采用两级气浮做预处理 ,生物硫化床串联接触氧化做深度处理的治理技术的分析研究 ,结合废水处理工程实例 ,说明了用两级串联气浮 +硫化床 +接触氧化工艺处理造纸中段水技术切实可靠 ,该治理工艺对处理亚铵法麦草制浆造纸中段废水有较强的针对性和可行性。     

Co-composting of Paper Mill Sludge and Hardwood Sawdust Under Two Types of In-Vessel Processes

Abstract

Recycling of organic residues by composting is becoming an acceptable practice in our society. Co-composting dewatered paper mill sludge (PMS) and hardwood sawdust, two readily available materials in Canada, was investigated using uncontrolled and controlled in-vessel processes. The composted materials were characterized for total C and N, water-soluble, acid-hydrolyzable, and non-hydrolyzable N, extractable lipids, and by Fourier Transform Infrared (FT-IR) spectrophotometry. In the controlled scale process, the loss of organic matter was approximately 65% higher than in the uncontrolled process. After undergoing initial fluctuations in N fractions during the first two days of composting, by the end of the process, concentrations of water-soluble N decreased while those of acid-hydrolyzable and nonhydrolyzable N increased in the controlled process, whereas in the uncontrolled process, water-soluble N increased, but N in the other two fractions decreased continuously, indicating that the biochemical transformations of organic matter were not completed. Data on extractable lipids and FT-IR spectra suggest that the compost produced from the controlled process was bio-stable after 14 days, while the uncontrolled process was not stabilized after 18 days. In addition, FT-IR data suggest the biological activity during composting centered mainly on the degradation of aliphatic structures while aromatic structures were preserved. The co-composting of the PMS and hardwood sawdust can be successfully achieved if aeration, moisture, and bio-available C/N ratios are optimized to reduce losses of N.     

化学需氧量在造纸废水中分布规律及采样点位的优化

目前对造纸废水的监测通常采取随机取样,很少考虑污染物在废水中的分布情况,所以取得的样品很难反映污染物的实际排放情况。为此,通过对某造纸厂排废废水中化学需氧量分布夫妻及采样点位的优化研究。     

造纸工业总排水及漂白废水中AOX监测方法的研究

运用TOX测定仪对造纸工业废水及漂白废水中AOX(可吸附有机卤素)测定;水样用硝酸调pH＜2后,以双根活性炭玻璃填充柱连续吸附;将吸附有机物的活性炭在氧气流中燃烧热解、用微库仑法测定其卤化氢.样品前处理比现行活性炭振荡吸附法样品及试剂用量少、快速、重现性好.方法测定浓度下限为3.73μg/L.