A numerical investigation of fluid-structure coupling of 3 MW wind turbine blades

In this paper, computational modeling is created for 3 MW wind turbine blade using the software Solidworks, and the computations are carried out using Workbench for the fluid–structure interaction of blades due to both the rated and the extreme wind load. The methods developed are applied to the simulation of the NREL Phase VI wind turbine blades, and validation against published data is presented. Moreover, the static structural analysis for wind turbine rotor is performed using Mechanical APDL. The results show that the maximum values of stress reach 458 MPa and 76.9 MPa due to the rated and extreme wind load, respectively, which are lower than 78.3 MPa, the flexural strength of Swancor 2511-A epoxy resin for blade material.     

Particulates and Metallic Elements Monitoring at Two Sampling Sites (Harbor,Airport) in Taiwan

This study characterized the dry deposition flux and dry deposition velocity (Vd) of metallic elements attached on particulate matter. Specifically, large particles (>10 μm), coarse particles (10 μm～2.5 μm), and fine particles (<2.5 μm) were studied at the Gong Ming Junior High School (Taichung Airport) and Taichung Harbor sampling sites in central Taiwan. Ambient air samples were collected to determine total suspended particulate matter (TSP), dry deposition plate (DDP), Vd, coarse particulate matter (PM_2.5–10) and fine particulate matter (PM_2.5), and metallic elements concentrations at the Airport and Taichung Harbor sites between June 17, 2013, and November 14, 2013. The results revealed that the average TSP, DDP, Vd, PM_2.5–10, and PM_2.5 particulate at the Airport were 54.55 (μg/m³), 902.25 (μg/m²-min), 17.11 (m/sec), 0.003 (μg/m³), and 0.010 (μg/m³), respectively; while these values at Taichung Harbor were 63.66 (μg/m³), 539.69 (μg/m²-min), 9.94 (m/sec), 0.003 (μg/m³), and 0.014 (μg/m³), respectively. In addition, the results showed that the average Cu and Pb concentrations were higher than Cr, Ni, and Cd for both the airport and harbor sampling sites. Furthermore, Cr, N, Cu, Cd, and Pb had the highest average concentrations versus those reported for other study areas, with one exception: The results obtained in Kacanik, Kosovo, during 2005. The average metallic elements concentrations order was Cu > Pb > Cr > Ni > Cd.     

Respiration induced by substrate and bacteria diversity after application of diuron,hexazinone, and sulfometuron-methyl alone and in mixture

Abstract

After application, herbicides often reach the soil and affect non-target soil microorganisms, decreasing their population, diversity or affecting metabolic activity. Therefore, laboratory studies were performed to evaluate the effects of diuron, hexazinone and sulfometuron-methyl alone and mixed upon carbon transformation by soil microorganisms in clayey and sandy soils and the effect on bacterial diversity and structure. Control treatment without herbicide application was also performed. Sub-samples from the control and herbicide treatments (10?g – in triplicate) were collected before herbicide application and 7, 14, 28 and 42?days after treatment (DAT), then 1?mL of ¹⁴C-glucose solution was applied. The released ¹⁴CO₂ was trapped in 2?M NaOH solution and the radioactivity was analyzed by liquid scintillation counting (LSC), 12?h after glucose application. The effect of herbicides on bacterial diversity was evaluated by T-RFLP. The experiment was conducted in a complete randomized design. Hexazinone did not affect ¹⁴CO₂ evolution. Diuron showed a greater ¹⁴CO₂ evolution in sandy and clayey soil, while sulfometuron-methyl led to an increase in sandy soil, at 42 DAT. A greater evolution of carbon was observed in the treatment with herbicide mixture in sandy soil, compared with the same treatment in clayey soil or control. However, the herbicide mixture application did not affect the soil biological activity measured by the respiration rate induced by substrate. On the other hand, the herbicide mixtures affected the bacterial diversity in both soils, being the strongest effect to diuron and sulfometuron-methyl in clayey soil and hexazinone in sandy soil.     

Application of chemometric analysis based on physicochemical and chromatographic data for the differentiation origin of plant protection products containing chlorpyrifos

The aim of this study was to investigate the similarities and dissimilarities between the pesticide samples in form of emulsifiable concentrates (EC) formulation containing chlorpyrifos as active ingredient coming from different sources (i.e., shops and wholesales) and also belonging to various series. The results obtained by the Headspace Gas Chromatography–Mass Spectrometry method and also some selected physicochemical properties of examined pesticides including pH, density, stability, active ingredient and water content in pesticides tested were compared using two chemometric methods. Applicability of simple cluster analysis and also principal component analysis of obtained data in differentiation of examined plant protection products coming from different sources was confirmed. It would be advantageous in the routine control of originality and also in the detection of counterfeit pesticides, respectively, among commercially available pesticides containing chlorpyrifos as an active ingredient.     

Information presentation compatibility in a simple digital control panel design: eye-tracking study

Various designs of typical digital control panels were analyzed experimentally from both the effectiveness and efficiency points of view. Subjects performed information comparison tasks aimed at keeping vehicle velocity at the same level. The experiment involved two versions of speedometers for displaying current and target velocities (clock-face and digital). The stimuli were also differentiated by the target velocity value (20, 50 and 80?km/h) and the correct response type (increase or decrease). Subjects’ performance results along with the eye-tracking data were qualitatively and quantitatively analyzed for all 24 experimental conditions.     

Cross-correlation between the controlled collision environment and real-world motor vehicle collisions: Evaluating the protection of the thoracic side airbag

Objective: Thoracic side airbags (tSABs) were integrated into the vehicle fleet to attenuate and distribute forces on the occupant's chest and abdomen, dissipate the impact energy, and move the occupant away from the intruding structure, all of which reduce the risk of injury. This research piece investigates and evaluates the safety performance of the airbag unit by cross-correlating data from a controlled collision environment with field data.

Method: We focus exclusively on vehicle–vehicle lateral impacts from the NHTSA's Vehicle Crash Test Database and NASS-CDS database, which are replicated in the controlled environment by the (crabbed) barrier impact. Similar collisions with and without seat-embedded tSABs are matched to each other and the injury risks are compared.

Results: Results indicated that dummy-based thoracic injury metrics were significantly lower with tSAB exposure (P <.001). Yet, when the controlled collision environment data were cross-correlated with NASS-CDS collisions, deployment of the tSAB indicated no association with thoracic injury (tho. MAIS 2+ unadjusted relative risk [RR] = 1.14; 90% confidence interval [CI], 0.80–1.62; tho. MAIS 3+ unadjusted RR = 1.12; 90% CI, 0.76–1.65).

Conclusion: The data from the controlled collision environment indicated an unequivocal benefit provided by the thoracic side airbag for the crash dummy; however, the real-world collisions demonstrate that no benefit is provided to the occupant. This has resulted from a noncorrelation between the crash test/dummy-based design taking the abstracting process too far to represent the real-world collision scenario.     

The territorial dimension of environmental sustainability in Italy along the urban–rural continuum

Single territories contribute in different ways to the transition towards a more environmentally sustainable development (SD), according to their structural features. This study returns a multi-dimensional picture of the territorial divides of environmental sustainability across Italy, analysing how it correlates with rurality, with a focus on the urban–rural continuum. Italy represents an interesting case study because of its peculiar territorial urban–rural structure. We first assess the environmental sustainability targets across Italian NUTS 3 regions and their capital cities using two composite sustainability indexes, by referring to both standard values (i.e. conforming to legislation) and optimum values (i.e. desired values). Then, we investigate the relationship between environmental sustainability and rurality. Results suggest that a positive link between the two exists, being stronger at city level. Among major policy implications, the environmental dimensions of territorial cohesion should be integrated more strongly in key European policies to reach a more balanced SD.     

Managing Forests for Increased Regional Water Yield in the Southeastern U.S. Coastal Plain

With growing populations fueling increased groundwater abstraction and forecasts of greater water scarcity in the southeastern United States, identifying land management strategies that enhance water availability will be vital to maintaining hydrologic resources and protecting natural systems. Management of forested uplands for lower basal area, currently a priority for habitat improvement on public lands, may also increase water yield through decreased evapotranspiration (ET). To explore this hypothesis, we synthesized studies of precipitation and ET in coastal plain pine stands to develop a statistical model of water yield as a function of management strategy, stand structure, and ecosystem water use. This model allowed us to estimate changes in water yield in response to varying management strategies across spatial scales from the individual stand to a regional watershed. Results suggest that slash pine stands managed at lower basal areas can have up to 64% more cumulative water yield over a 25‐year rotation compared to systems managed for high‐density timber production, with the greatest increases in stands also managed for recurrent understory fire. Although there are important uncertainties in the magnitude of additional water yield and its final destination (i.e., surface water bodies vs. groundwater), this analysis highlights the potential for management activities on public and private timber lands to partially offset increasing demand on surface and groundwater resources.     

Ecosystem services in infrastructure planning – a case study of the projected deepening of the Lower Weser river in Germany

We consider how ecosystem services can be incorporated into water infrastructure planning by studying the projected deepening of the Lower Weser river channel in Germany. We recalculate the project's benefit–cost ratio by integrating the monetary value of changes in different ecosystem services, as follows: (1) the restoration costs of a mitigation measure for a loss in fresh water supply for agricultural production in the estuary region, (2) the costs of a loss in habitat services, transferring the willingness to pay from a contingent valuation study to the area assessed in the environmental impact assessment, and (3) the benefits of emissions savings induced by more efficient shipping, taking a marginal abatement cost approach. We find that including monetary values for ecosystem service changes leads to a substantial drop in the benefit–cost ratio. On this basis, we argue for a reform of the standard cost–benefit analysis to facilitate more complete welfare assessments.