超声对净水沉淀污泥絮体特性及对污泥回流效能的影响

为解决污泥回流强化混凝技术存在的有毒有害物质积累的问题,取净水沉淀污泥经超声预处理后进行回流试验,考察超声作用后净水沉淀污泥絮体特性的变化及其对回流效能的影响.结果表明:超声作用后污泥溶液的温度升高,絮体粒径减小,长时间作用后粒径可降至几个mm,且粒径与声能密度呈现相关性;1,5W/mL的超声处理后,絮体Zeta电位降低,比表面积增大,10,15W/mL的超声处理后絮体Zeta电位升高,比表面积有所下降;低声能密度(1W/mL)超声处理后污泥回流可强化混凝效果,30min超声作用后污泥回流的浊度、UV254和CODMn去除率分别提高了2.7%、23.12%和10.02%,长时间高声能密度(15W/mL)超声波处理污泥回流后混凝效果反而恶化.超声技术对污泥回流后污染物的去除率有一定的提高,但超声时间和声能密度必须很好控制.     

中国造纸业物质代谢演化特征

造纸业是与国民经济和社会发展关系密切并具有可持续发展特点的重要基础原材料产业.为了解中国造纸业资源消耗及环境污染变化趋势,基于经济系统造纸业物质流分析（EW-MFA）方法原理,建立了中国造纸业物质代谢分析模型,定量分析2005~2017年中国造纸业物质输入/输出、代谢强度和循环利用率等演化特征.结果表明,2005~2017年中国造纸业的物质输入与输出总体呈下降趋势,水的贡献占比高达90%以上.近年来,随着造纸业原料结构的不断优化,非木材制浆的比例从42%下降至13%,主要被废纸制浆为主,木材制浆为辅的方式所取代,单位纸产品的资源消耗量得以大幅降低.2017年吨纸及纸板直接物质输入为26 t,较2005年的79 t下降了67%,其中新鲜水消耗量下降了约69%.水资源循环利用率大幅上升,2017年水循环率高达77%.目前,纸及纸板的生产越来越依赖于国内废纸和进口木材的投入,两者占比分别由2005年的21%和9%上升至2017年的60%和31%.然而,国内废纸回收率仍处于较低水平,需通过加强回收体系建设、提高居民回收意识等措施以缓解限制废纸进口造成的原料供应紧缺.     

中外垃圾土体渗透系数试验对比分析

从试验数据、试验方法 2个方面总结归纳了关于现有垃圾填埋场渗透系数的国内外试验,并且通过对比国内外渗透系数的一系列试验成果,分析了国内外渗透系数试验在基础数据、试验方法多样性方面的优劣。以此为基点,对未来国内岩土工程发展方向提出了建议。     

Internal cycle modeling and environmental assessment of multiple cycle consumer products

Dynamic annual flow models incorporating consumer discard and usage loss and featuring deterministic and stochastic end-of-cycle (EOC) return by the consumer are developed for reused or remanufactured products (multiple cycle products, MCPs), including fast and slow cycling, short and long-lived products. It is shown that internal flows (reuse and overall consumption) increase proportionally to the dimensionless internal cycle factor (ICF) which is related to environmental impact reduction factors. The combined reuse/recycle (or cycle) rate is shown capable for shortcut, albeit effective, monitoring of environmental performance in terms of waste production, virgin material extraction and manufacturing impacts of all MCPs, a task, which physical variables (lifetime, cycling frequency, mean or total number of return trips) and conventional rates, via which environmental policy has been officially implemented (e.g. recycling rate) cannot accomplish. The cycle rate is shown to be an increasing (hyperbolic) function of ICF. The impact of the stochastic EOC return characteristics on total reuse and consumption flows, as well as on eco-performance, is assessed: symmetric EOC return has a small, positive effect on performance compared to deterministic, while early shifted EOC return is more beneficial. In order to be efficient, environmental policy should set higher minimum reuse targets for higher trippage MCPs. The results may serve for monitoring, flow accounting and comparative eco-assessment of MCPs. They may be useful in identifying reachable and efficient reuse/recycle targets for consumer products and in planning return via appropriate labelling and digital coding for enhancing environmental performance, while satisfying consumer demand.     

Effect of leachate recirculation on mesophilic anaerobic digestion of food waste

The effects of using untreated leachate for supplemental water addition and liquid recirculation on anaerobic digestion of food waste was evaluated by combining cyclic water recycle operations with batch mesophilic biochemical methane potential (BMP) assays. Cyclic BMP assays indicated that using an appropriate fraction of recycled leachate and fresh make up water can stimulate methanogenic activity and enhance biogas production. Conversely increasing the percentage of recycled leachate in the make up water eventually causes methanogenic inhibition and decrease in the rate of food waste stabilization. The decrease in activity is exacerbated as the number cycles increases. Inhibition is possibly attributed to accumulation and elevated concentrations of ammonia as well as other waste by products in the recycled leachate that inhibit methanogenesis.     

Comparisons of four categories of waste recycling in China's paper industry based on physical input-output life-cycle assessment model

Waste recycling for paper production is an important component of waste management. This study constructs a physical input-output life-cycle assessment (PIO-LCA) model. The PIO-LCA model is used to investigate environmental impacts of four categories of waste recycling in China’s paper industry: crop straws, bagasse, textile wastes and scrap paper. Crop straw recycling and wood utilization for paper production have small total intensity of environmental impacts. Moreover, environmental impacts reduction of crop straw recycling and wood utilization benefits the most from technology development. Thus, using crop straws and wood (including wood wastes) for paper production should be promoted. Technology development has small effects on environmental impacts reduction of bagasse recycling, textile waste recycling and scrap paper recycling. In addition, bagasse recycling and textile waste recycling have big total intensity of environmental impacts. Thus, the development of bagasse recycling and textile waste recycling should be properly limited. Other pathways for reusing bagasse and textile wastes should be explored and evaluated. Moreover, imports of scrap paper should be encouraged to reduce large indirect impacts of scrap paper recycling on domestic environment.     

大连实施垃圾分类回收积极推进垃圾资源再生利用产业化

大连在全国率先创建新型垃圾分类回收体系,实现废旧物资回收与垃圾分类回收在同一个垃圾分类回收站内完成,有利于各类废物资源集中收集、分类回收、资源化利用或处理,彻底改革了我国传统落后的废旧物资回收与垃圾收集处理方式,为废旧物资与垃圾资源再生与循环利用提供了保障条件,也为垃圾处理产业化奠定了坚实的基础。     

废旧商品回收体系建设要略初探

国务院总理温家宝召开国务院常务会议,部署建立完整的先进的废旧商品回收体系,指出,中国废旧商品回收体系很不完善,不仅影响废物利用,而且极易造成环境污染,建立完整、先进的回收、运输、处理、利用废旧商品回收体系已刻不容缓。作为再生资源回收行业的主力军,供销社在废旧商品回收体系建设中如何应对并开展工作,对此进行了全面的探讨。     

我国电子垃圾回收存在的问题与解决途径

介绍了我国电子垃圾回收利用存在的问题与现状、国外可供借鉴的经验,以及电子垃圾分类情况,最后提出我国电子垃圾再生利用的产业化发展方向。     

机床再制造产业发展国际比较及其启示

机床再制造属于节能环保型新兴产业,我国的机床再制造产业发展与发达国家相比有着较大差距。通过对国内外机床再制造产业发展现状进行比较,寻求促进产业发展的途径,提出了自主创新、优质品牌和两化融合等三大战略,以及注重调整产业结构、有效开展技术创新、着力提升生产水平、切实加强品牌建设、积极开拓营销渠道和全面实施节能环保等六大举措。