反渗透技术在小便池废水回用中的试验研究

首先将自配模拟尿液稀释不同的倍数后进行反渗透处理,确定了适宜的操作压力和合理的稀释倍数,然后用实际的人体尿液进行验证试验,经反渗透处理后,BOD5去除率达到98.3%、氨氮去除率达到97.7%、电导率降低了96.1%,产水投碱和二氧化氯后可达到城市杂用水水质标准(GB/T18920-2002)的要求,回用作冲厕用水。最后指出了值得关注的研究方向,以期能为小便池废水的循环利用提供一定的参考。     

河口近岸水体中颗粒态重金属的潮周期变化

对长江口崇明东滩近岸水体中颗粒态重金属的潮周期变化特征及其影响机制进行了研究.结果表明,受粒度影响,底层水体中颗粒态Cu、Pb、Fe、Mn、Zn、Cr、Al的总量分别高出表层沉积物的184%、99%、56%、62%、147%、50%和45%,其中Cu、Pb、Fe、Mn、Zn、Al可还原态部分在底层水体悬浮颗粒物中的含量也明显高出表层沉积物的2～3倍,但与重金属总量相比,上述元素的可还原态部分所占比例与表层沉积物相差不大.在5次潮汐循环过程中,颗粒态重金属均在涨潮初期、高平潮前后及落潮末期出现较高含量.这种变化主要与水动力条件有关,当水体流速增大时,从底部沉积物再悬浮起来的颗粒态重金属对水体中的永久性悬浮颗粒起了很大的稀释效应.水体中的盐度、DO及pH等环境因子对潮周期内颗粒态重金属的变化影响不大.     

逆转录-聚合酶链反应(RT-PCR)技术同时检测水中多种肠道病毒

建立了一种利用通用引物RT-PCR技术检测水中肠道病毒的方法.利用脊髓灰质炎病毒1～3型,柯萨奇病毒B3型作为参考病毒株,根据肠道病毒RNA5′非编码区中具有高度同源性的序列来设计通用引物.比较了M-MLV酶和AMV酶的逆转录效果,AMV酶能够成功地从地表水和生活污水中逆转录病毒RNA,更适于实际应用.对比研究了PCR过程中的退火温度,c(Mg2＋)等因素对RT-PCR检测结果的影响,选择退火温度55　℃,c(Mg2＋)为2　mmol/L的反应条件,优化了RT-PCR检测方法.通过检测水样中接种的连续稀释的病毒,确定了该检测方法的灵敏度为38　CCID₅₀.考察人工污染的地表水、污水、二级处理出水样品发现,检测灵敏度基本一致.该方法可应用在实际环境的肠道病毒检测中.      

反渗透在环境工程中的应用

阐述了反渗透膜的分离机理(氢键理论,优先吸附-毛细管流动模型,溶解-扩散模型,等),反渗透膜技术在环境工程(重金属废水,垃圾渗滤液和印染废水处理)中的应用,以及膜集成工艺处理废水的概况,并对反渗透膜技术的研究和发展方向进行了展望。     

基于ISO14067的长江上游某水电项目碳足迹分析

以长江上游某大型水电站为案例,根据国际标准化组织碳足迹量化标准(ISO14067)评价流程,对该水电站全生命周期(建设阶段,运行维护阶段,退役阶段)碳足迹进行估算,并着重考虑了蓄水前后水库温室气体通量差异。研究以碳足迹系数和能源回收率作为指标进行评价,结果表明生命周期碳足迹为5 417.0万t CO_(2eq),碳足迹系数为7.0~13.1 g CO_(2eq)/kW·h,中位值为9.4 g CO_(2eq)/kW·h,该水电站项目能源回收率达236.4。与各种能源电站以及国内外同类型水电站相比较,该水电站碳足迹明显较低,且能源回收率显著较高,说明以该水电站为代表的我国西南水电具有显著的优质性,大力开发水电能有效节能减排,明确了生命周期评价方法对于水电站碳足迹评估的适用性。     

Coupling of the Water Cycle with Patterns of Urban Growth in the Baltimore Metropolitan Region,United States

Regional municipal water plans typically do not recognize complex coupling patterns or that increased withdrawals in one location can result in changes in water availability in others. We investigated the interaction between urban growth and water availability in the Baltimore metropolitan region where urban growth has occurred beyond the reaches of municipal water systems into areas that rely on wells in low‐productivity Piedmont aquifers. We used the urban growth model SLEUTH and the hydrologic model ParFlow.CLM to evaluate this interaction with urban growth scenarios in 2007 and 2030. We found decreasing groundwater availability outside of the municipal water service area. Within the municipal service area we found zones of increasing storage resulting from increased urban growth, where reduced vegetation cover dominated the effect of urbanization on the hydrologic cycle. We also found areas of decreasing storage, where expanding impervious surfaces played a larger role. Although the magnitude of urban growth and change in water availability for the simulation period were generally small, there was considerable spatial heterogeneity of changes in subsurface storage. This suggests that there are locally concentrated areas of groundwater sensitivity to urban growth where water shortages could occur or where drying up of headwater streams would be more likely. The simulation approach presented here could be used to identify early warning indicators of future risk.     

The determination and matching analysis of pinch point temperature difference in evaporator and condenser of organic rankine cycle for mixed working fluid

Exergo-economic analysis of the pinch point temperature difference (PPTD) in both evaporator and condenser of sub-critical organic Rankine cycle system (ORCs) are performed based on the first and second laws of thermodynamics. Taking mixture R13I1/R601a as a working fluid and the annual total cost per net output power Z as exergo-economic performance evaluation criterion, the effects of PPTD in evaporator ΔT_e, and the PPTD ratio of condenser to evaporator y, on the exergo-economic performance of ORCs are analyzed. Moreover, how some other parameters influence the optimal PPTD in evaporator ΔT_e,opt and the optimal PPTD ratio of condenser to evaporator y_opt are also discussed. It has been found that the exergo-economic performance of ORCs is remarkably influenced by ΔT_e and y, and there exists ΔT_e,opt and y_opt. In addition, ΔT_e,opt and y_opt are affected by heat transfer coefficient ratio of condenser to evaporator ß, the temperature of working fluid at dew point in condenser T_1a, and composition of R13I1/R601a: larger ß and T_1a lead to lower ΔT_e,opt and y_opt; by contraries, larger mass fraction of R13I1 makes ΔT_e,opt and y_opt increase, and y_opt increases linearly. The effects of the temperature of working fluid at bubble point in evaporator T_3a, mass flow rate of exhaust flue gas m_g, and inlet temperature of exhaust flue gas T_gi on ΔT_e,opt and y_opt are very slight. For comparison, three additional working fluids, namely R601a, R245fa, and 0.32R245fa/0.68R601a, are also taken into account.     

Experimental investigation of a 250-kW turbine organic Rankine cycle system for low-grade waste heat recovery

An organic Rankine cycle (ORC) is generally used for converting low-grade heat into electricity. In this study, an extensive literature survey was conducted to identify current research gaps on experimental ORC systems. Specifically, there is limited experimental data and limited details on thermal and expander efficiencies of ORC systems. In order to address these gaps, the objective of this study included developing a turbine ORC with a power output exceeding 50 kW and thermal efficiency exceeding 8% for a heat source temperature < 120°C. The experimental results indicated that the system achieved a net power output of 242.5 kW and a thermal efficiency of 8.3% (the highest value for a turbine ORC system for the heat source temperature below 120°C). Thus, the study addressed the gaps identified in the research area of ORCs.     

基于LCA的废旧资源循环利用节能减排效果评估模式与方法研究——以吉林省某钢铁企业为例

促进废旧资源循环利用是加快推进我国生态文明建设,完成节能减排目标的必然选择。本文基于生命周期评价模式,从微观企业层面入手,构建产品全生命周期基准流程,引入能量输入与环境输出参数,建立废旧资源循环利用节能减排效果量化核算模型,评估再生产品的节能减排经济成效,并以吉林省某钢铁企业为例,评估"废钢-电炉"短流程和"铁矿石-高炉-转炉"长流程的能源、环境、成本差异,辨识影响废钢再循环节能减排效果的主要因素和重要环节。结果显示,再生钢铁全生命周期与原生钢铁全生命周期相比,节能588.48kgce/t,节能率为84%;主要污染物中SO2减排率最高,达92%;CO2总减排1 180.92 kg/t,减排率为67%;总成本却高出198元/t。其中,炼铁工序的节能量和减碳量最大,烧结工序SO2、NOx和烟(粉)尘减排量最大,焦化工序COD和氨氮减排量最大,回收、加工处理、炼钢环节节能量和减碳量以及SO2、NOx和烟(粉)尘减排量均为负。成本方面,再生钢铁生产成本高于原生钢铁308元/t,虽然再生钢铁由于污染减排可节省56元/t的排污费并获取54元/t的碳交易收益,但都不足以扭转电炉炼钢费用较高的现状。因此,国家应在电炉炼钢方面给予钢企及相关企业适当的财税扶持政策,在电价方面给予钢企一定的优惠或补贴,并完善废钢回收加工体系等,以促进废钢循环利用。基于LCA的废旧资源循环利用节能减排效果评估可以实现对产品生命周期全过程的资源、环境、成本的优化管理。     

Two-echelon closed-loop supply chain deterministic inventory models in a batch production environment

This paper considers a two-echelon closed-loop supply chain consisting of a manufacturer and a remanufacturer at the upper echelon and a retailer at the lower echelon. The retailer faces a constant demand from customers, which is satisfied through recovered and new products received from the remanufacturer and the manufacturer, respectively. The manufacturer produces the product with finite rate, whereas the recovery of returned product is instantaneous at the remanufacturer. We develop three models to determine the optimal production-inventory policy of the players for minimizing the joint total cost of the system. In the first model, the retailer receives the product in batches from the manufacturer and the remanufacture simultaneously, whereas in the second and third models, the batches are received alternatively. In the third model, however, the procurement of raw material at the manufacturer is also considered. Numerical illustration is presented to examine the impact of certain key parameters.