萃取法分离回收不锈钢酸洗污泥硫酸浸出液中的重金属

采用非皂化P204和皂化P204萃取剂对不锈钢酸洗污泥的硫酸浸出液进行萃取。在浸出液pH为0.80、非皂化P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取时间为5 min的条件下,Fe~(3+)萃取率达99.64%,Cr~(3+)和Ni~(2+)萃取率为3.98%和6.99%,一次萃余液pH为0.64。采用皂化P204对除Fe~(3+)后的一次萃余液进行萃取,在P204体积分数为25%、萃取剂与浸出液体积比为1∶2、萃取剂皂化率为60%、一次萃余液pH为1.50、萃取时间为5 min的条件下,Ni~(2+)萃取率为93.12%,Cr~(3+)萃取率为20.69%,二次萃余液pH为2.63。     

固相萃取-气相色谱法测定饮用水中甲基汞

根据巯基棉在一定酸性条件下能定量吸附甲基汞的原理,利用多通道并联的固相萃取装置,采用气相色谱(ECD)方法测定饮用水中痕量甲基汞,考察了水样pH值对回收率的影响.方法在0.050 mg/L～1.00 mg/L范围内线性良好,当采样体积为1.0 L时,检出限为0.03 ng/L,标准样品与实际水样平行测定的相对标准偏差均...     

固相萃取-气相色谱法测定水样中马拉硫磷残留

采用C-18小柱萃取、毛细管柱分离、气相色谱氢火焰离子化检测器（FID）测定水样中的马拉硫磷,检测限为0．12μg／L。试验了样品流量和洗脱剂对回收率的影响,结果表明样品流量为6mL／min、二氯甲烷作洗脱剂时,回收率较好。测定蒸馏水、地下水和河水样品,相对标准偏差〈2．2％。加标回收率在79．0％-109％之间。     

Determination of Au(III) and Pd(II) ions by flame atomic absorption spectrometry in some environmental samples after solid phase extraction

A simple and sensitive solid phase extraction method was developed for simultaneous separation and preconcentration of gold and palladium ions with N-(4-methylphenyl)-2-{[(4-phenyl-5-pyridine-4-yl-4H-1,2,4-triazol-3-yl)thio]acetyl}hydrazine carbo thioamide complex on Amberlite XAD-1180 resin before their determination by flame atomic absorption spectrometry. Some analytical parameters such as HNO₃ concentration of the sample solution, amount of complexing agent, sample volume, eluent type and volume, effects of foreign ions and adsorption capacity of the resin were investigated for quantitative recovery of gold and palladium ions. The effects of some anions and cations were also examined. Under optimum conditions, the detection limits for gold and palladium ions were found to be 0.29 and 0.19 μg L^?1, respectively. The preconcentration factor for gold and palladium was 250. After being validated by standard addition and analysis of standard reference material, the procedure was successfully applied to the analysis of sea and stream water, anodic slime, gold ore, soil and electronic waste.     

不同市场结构组合下稀土最优开采路径研究

本文从价格视角将我国稀土市场结构的变化历程划分为不同阶段,分别从理论和现实视角上探讨了在国际、国内都是完全竞争市场,国际市场垄断、国内市场完全竞争,国际市场完全竞争、国内市场垄断,国际、国内都是垄断市场条件下稀土最优开采路径及最优耗竭时间,并通过设定参数判断其相对大小关系。发现在一定的假设条件下,开采前期当国内和国际市场都是完全竞争时,稀土最优开采量是最大的;当国内和国际市场都是垄断时,稀土最优开采量是最小的;其他两种市场情况下稀土最优开采量居于中间,当国际市场是稀土的主要消费地时,国际竞争-国内垄断市场情况下稀土最优开采量大于国际垄断-国内竞争市场情况下稀土最优开采量,反之,国际垄断-国内竞争市场情况下稀土最优开采量大于国际竞争-国内垄断市场情况下稀土最优开采量。     

Mechanical and toxicological evaluation of concrete artifacts containing waste foundry sand

The creation of metal parts via casting uses molds that are generally made from sand and phenolic resin. The waste generated after the casting process is called waste foundry sand (WFS). Depending on the mold composition and the casting process, WFS can contain substances that prevent its direct emission to the environment. In Brazil, this waste is classified according to the Standard ABNT NBR 10004:2004 as a waste Class II (Non-Inert). The recycling of this waste is limited because its characteristics change significantly after use. Although the use (or reuse) of this byproduct in civil construction is a technically feasible alternative, its effects must be evaluated, especially from mechanical and environmental points of view. Thus, the objective of this study is to investigate the effect of the use of WFS in the manufacture of cement artifacts, such as masonry blocks for walls, structural masonry blocks, and paving blocks. Blocks containing different concentrations of WFS (up to 75% by weight) were produced and evaluated using compressive strength tests (35 MPa at 28 days) and toxicity tests on Daphnia magna, Allium cepa (onion root), and Eisenia foetida (earthworm). The results showed that there was not a considerable reduction in the compressive strength, with values of 35 ± 2 MPa at 28 days. The toxicity study with the material obtained from leaching did not significantly interfere with the development of D. magna and E. foetida, but the growth of the A. cepa species was reduced. The study showed that the use of this waste in the production of concrete blocks is feasible from both mechanical and environmental points of view.     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。     

环境试验设备参数测量──沙尘试验设备

沙尘试验设备参数的测量,目前没有相关的标准和指导文件。本文给出沙尘试验设备参数测量的一般方法,主要介绍了一种沙尘浓度测量方法。     

海上平台采油工艺设计浅析

文章通过实例,简要阐述了滩海、浅海、深海三种开发模式的特点、主要工艺及其适用性。指出各自存在的问题,并提出相应的建议,为海上勘探开发提供借鉴。     

Genotoxicity of sediment extracts of the Berre lagoon (France)

To evaluate the genotoxic risk that contaminated sediment could constitute for benthic organisms, three contaminated (VA, VC and VN) and one uncontaminated (RN) sediment samples were collected in the Berre lagoon (France). Potentially bioavailable contaminants in sediments were obtained using sediment extraction with synthetic seawater adjusted to pH 4 or pH 6, simulating the range of pH prevailing in the digestive tract of benthic organisms. The genotoxic activities of these extracts were evaluated by three short-term bioassays: the Salmonella mutagenicity test using the Salmonella typhimurium strain TA102, the alkaline comet assay and the micronucleus assay on the Chinese Hamster Ovary cells CHO-K1. Results of the Salmonella mutagenicity assay detected a mutagenic response for RN extract at pH 6, and for VA extract at pH 4. Results of the comet and micronucleus assays detected low genotoxic/clastogenic activities for VA and VC extracts at pH 6 and higher activities for RN, VA and VC extracts at pH 4. To identify if metals (Al, Fe, Mn, As, Cd, Co, Cr, Cu, Hg, Ni, Pb and Zn) were involved in these genotoxic activities, their concentrations were determined in the extracts, and their speciation was assessed by thermodynamic calculations. Results showed that extracts from sites VA, VC and VN generally presented the highest trace metal contents for both extractants, while the site RN presented lower trace metal contents but the highest Fe and Mn contents. Thermodynamic calculations indicated that Fe, Mn, As and in a lower extend Co, Ni and Zn were mainly present under free forms in extracts, and were consequently, more likely able to induce a genotoxic effect. Results globally showed no correspondence between free metal contents and genotoxic activities. They suggested that these positive results could be due to uncharacterized compounds, acting as direct genotoxic agents or enhancing the genotoxic properties of analyzed metals.