太湖流域典型城镇水环境芳香胺类污染特征

利用固相萃取-气相色谱/串联质谱法(SPE-GC-MS/MS),对太湖流域上游城镇常州武南地区的地表水体和典型排放源中的4种芳香胺类污染物(AAs)进行连续2年监测,综合分析了2018～2019年间AAs的污染及浓度特征.结果表明,武南地区河网中目标AAs的总浓度范围为相似文献   

聚合氯化铝-腐殖酸(PACl-HA)絮体的物理与分形特征研究

采用低温急速冷冻-真空干燥技术制备了PACl-HA絮体的粉末样品,研究了这些样品的物理与分形特征.结果表明,PACl-HA絮体具有无定形结构,主要组成元素为C、O、Al,所含特征官能团保留了絮体组成原料的一些特征;絮体的BET比表面积为130～161 m²·g^-1,BJH累积吸附孔体积为0.38～0.52 cm³·g^-1,BJH脱附平均孔径为7.7～9.6nm,PSD峰值对应孔径8.4～11.2nm.PACl-HA絮体具有自相似性的粗糙表面,呈现多尺度分形特征;图象法和N₂吸附/脱附等温线法确定的表面分形维数Ds分别为2.03～2.26、2.24～2.37,前者的分形尺度大约处于23～390nm之间,主要属于絮体外表面尺度,而后者的分形特征尺度区间的下限大约为0.2nm,属于孔表面尺度;另外,对同一絮体,N₂吸附法和脱附法确定的孔表面分形维数不同.热力学模型计算出的D_s远大于3,与Sahouli等的研究不符.     

铝件表面处理废水治理所得化学污泥的再生利用研究

对混凝法处理铝件表面处理废水治理所得化学污泥再生利用进行了研究,得到了适宜的操作条件.结果表明,用浓硫酸溶解污泥的最佳用量为0.14～0.16 mL/g湿污泥,湿污泥的溶解率可达90%,铝的溶出率也可达95%以上.把污泥的溶解液作混凝剂回用于印染废水的混凝处理也取得了良好的效果,其COD去除率≥80%,脱色率≥90%.实现了资源的二次利用,改善了作业环境,获得了较好的经济效益和社会效益.     

图象法确定底泥颗粒物的表面分形维数(Ds)

研究了不同标度下底泥颗粒物的表面分形特征.结果表明,底泥颗粒的表面在几个nm到几个μm之间一般都具有多重分形特征,而且在不同的标度范围内表面分形维数(Ds)具有一定的差异,在100-102量级之间,随图象分辨率的增大,相应的Ds一般呈变小的趋势.SEM图象计算出的Ds为2.32-2.42,AFM图象计算出的Ds为2.00-2.46,它们是是纯粹几何意义上的表面粗糙特征的描述.     

好氧颗粒污泥膜生物反应器污泥性状研究

采用厌氧-好氧运行方式的颗粒污泥膜生物反应器（GMBR）,连续运行近120　d表现出良好的有机物去除及同步硝化反硝化能力.对GMBR中污泥粒径分布变化研究表明,GMBR中污泥浓度的增加主要是由于粒径0.18～0.45　mm的小颗粒污泥及小于0.18　mm的絮状污泥的增加造成的,粒径大于0.45　mm的颗粒污泥能够基本稳定维持其颗粒形态,反应器运行末期,GMBR中颗粒污泥（粒径大于0.18　mm的污泥）含量稳定在污泥总量的60％～65％以上.污泥表面电荷量随着污泥组成形态的变化电负性逐渐增加,80　d后稳定在-0.42～-0.80　meq·g^-1之间.污泥表面电荷的负电性增加主要是由小于0.45　mm的污泥造成的,其中小于0.18　mm的絮状污泥对其影响最大.并且,污泥粒径越大污泥表面负电荷量越少,两者具有较好的线性关系.另外,GMBR中SVI稳定在60～90 mL/g之间,并且随着污泥表面电荷负电性的增加污泥SVI值增加,两者之间具有一定的相关性.     

混合重金属对硝化颗粒污泥毒性作用的析因实验研究

分别测定了Cu2 、Zn2 和Cd2 对硝化颗粒污泥的单一毒性,采用析因实验研究了二元和三元重金属混合体系对硝化颗粒污泥的联合毒性.结果表明,Cu2 、Zn2 和Cd2 的2 h半抑制浓度EC50分别为95.23、62.11和12.48 mg/L,由析因实验所得的响应曲面模型具有较好的优度(其R2＞0.95),能够对混合体系的联合毒性很好地进行预测,析因实验可以用于环境领域混合体系联合毒性的研究.     

响应面法优化酸性玫瑰红B光催化氧化的影响参数

利用中心组合设计和响应面分析方法对影响UV/TiO2光催化降解酸性玫瑰红B的主要因素(初始pH值、K2S2O8浓度、TiO2浓度)进行分析.其中初始pH值、K2S2O8浓度和TiO2浓度的高、低水平分别为4-5.6,26-36mg·l-1和0.53-1.87mg·l-1,分析参数为脱色率的变化.通过使用Design-Expert 5软件可得到1个2次响应曲面模型,最佳的初始pH值、K2S2O8浓度和TiO2浓度分别为4.69,29.73mg·l-1和1.18 mg·l-1,脱色率达到最大(94.21%).     

肘部支撑在视频显示终端作业过程中对背部和右手表面肌电影响的Meta分析

本文主要探讨肘部支撑在视频显示终端作业过程中对背部和右手表面肌电的影响。采用Meta分析方法对以往研究资料进行筛检及汇总分析。结果发现：左右侧斜方肌的最大自主收缩百分比（MVC％）分别下降了0．83％（95％CI-1．00％--0．66％）和0．61％（95％CI-0．78％～-0．43％）,对于右手食指伸指肌而言,其影响并不具有显著性。可以认为肘部支撑是一种比较简单而且有效的预防措施。     

Water quality characteristics along the course of the Huangpu River （China）

Huangpu River is about 114.5 km from upriver Dianfeng to downriver Wusong,near the estuary of the Yangtze River.It plays a key role in supplying water for production,life,shipment and irrigation.With the industrial development,the pollution of the Huangpu River has become serious recently.The biological oxygen demand (BOD),total nitrogen (TN),total phosphorus (TP),oil,phenol and suspended solids (SS) were lower in the upstream sites than in the downstream sites,indicating pollutants being input along its course. Water quality was the worst in the Yangpu site,near the center of Shanghai City.Dissolved oxygen (DO) content was less than 2 mg/L in the site of Yangpu in July.Among relations between thirteen characteristics,relations between BOD,DO,TN,TP,NH_4~ -N, NO_3~--N and the count of total bacteria or Escherichia coli were significant and interdependent.Inner relationships between these main characteristics in the Huangpu River were studied.High nutrient concentration led to growth of microorganisms,including E.coli. Degradation of organic matters and respiration of bacteria made oxygen concentration decreased in the water body,and DO was a key factor for nitrification-denitrification process of nitrogen.In the Yangpu site,DO was decreased to less than 3.0 mg/L with BOD higher than 7.5 mg/L in May and July.Low DO concentration will decrease nitrification rate.Nitrification need at higher DO value than other organic substrate oxidation.Consequently,river water contains low NO_3~--N values with high amounts of TN and NH_4~ -N there.This will block the self-purification of surface water,by decreasing the rate of nitrification-denitrification transformation process in the water body.     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.