静电布袋复合式除尘器及其应用

介绍了静电布袋复合式除尘器的结构、材料及除尘原理;布袋除尘器在不同工况下的除尘效率、附加脱硫率、阻力和排放浓度等参数的测试结果;利用布袋除尘器改造静电除尘器时的改造方案、运行中应注意的问题.     

污水污泥间壁热干燥实验研究

研究了污泥间壁热干燥的工艺过程,分析了其工艺参数、冷凝水水质和产生的污染气体,探讨了有机物水解机理.结果表明,污泥含水率与停留时间呈负指数函数相关.收集到的干燥冷凝水属高浓度有机废水,其总有机碳（TOC）、挥发性有机酸（VFA）和氨氮（NH₃-N）浓度均很高,pH值保持在9～9.5.干燥冷凝水中挥发性有机酸和氨氮来源于2部分：低温110 ～130℃时,主要发生蛋白质的水解,生成有机酸和氨氮;高温140～150℃时,主要发生脂肪类的水解,生成有机酸.干燥温度低于150 ℃时,污泥间壁热干燥过程无污染气体产生.     

Effects of nitrate concentration in interstitial water on the bioremediation of simulated oil-polluted shorelines

Nutrient addition has been proved to be an effective strategy to enhance oil biodegradation in marine shorelines.To determine the optimal range of nutrient concentrations in the bioremediation of oil-polluted beaches,nitrate was added to the simulated shoreline models in the initial concentration of 1,5 and 10 mg/L.Whenever the NO3-N concentration declined to 70% of its original value, additional nutrients were supplemented to maintain a certain range.Results showed adding nutrients increased the oil biodegradation level,the counts of petroleum degrading bacteria(PDB)and heterotrophic bacteria (HB),and the promoted efficiency varied depending on the concentration of nitrate.Oil degradation level in 5 mg/L(NO_3-N)group reached as much as 84.3% accompanied with the consistently highest counts of PDB;while in 1 mg/L group oil removal efficiency was only 35.2%,and the numbers of PDB and HB were relatively low compared to the other groups supplemented with nutrients.Although counts of HB in the 10 mg/L group were remarkable,lower counts of PDB resulted in poorer oil removal efficiency (70.5%) compared to 5 mg/L group.Furthermore,it would need more NO_3-N(0.371 mg)to degrade 1 mg diesel oil in the 10 mg/L group than in the 5 mg/L group(0.197 mg).In conclusion, Nitrate concentration in 5 mg/L is superior to 1 and 10 mg/L in the enhancement of diesel oil biodegradation in simulated shorelines.     

Urban Energy Efficiency from Cities in China and Policy Implications

Using 1995-2006 panel data for 210 cities, this article firstly measures total factor energy efficiency for Chinese cities with constant return to scale data envelopment analysis model,and then describes the features of regional differences. The results show that the changing trend displays four "reversed U" shapes. A turning point of widening gap occurred among cities in 2000 and there was a certain convergence among four regions. Urban energy efficiency level is unstable. Cities with low efficiency and high energy input will be the focus of energy-saving and reducing emissions. According to Tobit model, resource endowment, temperature, industrial structure, technology level and variety of policy factors should be treated differently in different situations.     

重庆村镇住宅热湿环境现状及评价

通过对重庆地区村镇住宅的实地调研和村镇典型住宅温湿度连续监测,获得了重庆地区村镇住宅的主要围护结构形式以及典型房屋2010年1～9月的室内热湿环境状况,并利用重庆地区自然通风适应性热舒适性评价模型进行了分析。结果表明：现有墙体热工性能最好的是180红砖内外水泥砂浆抹灰外贴瓷砖形式,测试房屋冬季室内最低温度为83℃,最高相对湿度为962%,夏季室内最高温度为344℃,最高相对湿度为99%。监测数据中相对湿度大于70%的时数占总测试时数的93%。住宅围护结构的冷热抵御能力和湿舒适湿卫生条件都很差。采暖季节室内达到舒适只有2 d,空调季节有58 d,村镇地区围护结构冬季保温要求比夏季隔热显得更为突出     

焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

热真空试验系统温度均匀度试验研究

热真空试验是航天器研制过程中非常重要的一项试验,作为满足热真空试验必不可少的工具,好的热真空试验系统可以保证试验件在不失真的情况下试验,使试验受控,而热真空试验系统温度均匀度不好,会造成过试验或欠试验的产生。文中以某型热真空试验设备为例,通过试验研究分析其温度均匀度,可以提高热真空试验的精度。     

Comparative study on performances of a heat-pipe PV/T system and a heat-pipe solar water heating system

The heat-pipe solar water heating (HP-SWH) system and the heat-pipe photovoltaic/thermal (HP-PV/T) system are two practical solar systems, both of which use heat pipes to transfer heat. By selecting appropriate working fluid of the heat-pipes, these systems can be used in the cold region without being frozen. However, performances of these two solar systems are different because the HP-PV/T system can simultaneously provide electricity and heat, whereas the HP-SWH system provides heat only. In order to understand these two systems, this work presents a mathematical model for each system to study their one-day and annual performances. One-day simulation results showed that the HP-SWH system obtained more thermal energy and total energy than the HP-PV/T system while the HP-PV/T system achieved higher exergy efficiency than the HP-SWH system. Annual simulation results indicated that the HP-SWH system can heat the water to the available temperature (45°C) solely by solar energy for more than 121 days per year in typical climate regions of China, Hong Kong, Lhasa, and Beijing, while the HP-PV/T system can only work for not more than 102 days. The HP-PV/T system, however, can provide an additional electricity output of 73.019 kWh/m², 129.472 kWh/m², and 90.309 kWh/m² per unit collector area in the three regions, respectively.     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.     

Energy efficiency and appliance’s characteristics considered prior to purchase: Differences and similarities between the United Kingdom,Germany, Portugal,Greece, Poland,Spain and Italy

This article reports country differences in the consumer’s most considered characteristics when choosing electrical appliances, including but not restricted to the energy efficiency aspect. A survey was performed to store customers from 7 countries: the United Kingdom; Germany; Portugal; Greece; Poland; Spain; Italy. Results showed consistency between countries in the top three characteristics considered: cost; quality; and a balance between price and quality. Differences were found for reported environmental attitudes and behaviours, purchase motives, and store employees evaluation. The results may support national policies and store level energy efficiency interventions. Specifically, they can provide input for store employee’s training, in persuading customers towards the purchase of energy efficient appliances.