Identification of perfluoroalkyl acid sources in Swiss surface waters with the help of the artificial sweetener acesulfame

Anthropogenic perfluorinated compounds (PFCs), especially the perfluoroalkyl acids (PFAAs) are ubiquitously found in surface waters around the globe. Emissions from households, industries and also atmospheric transport/deposition are discussed as the possible sources. In this study, these sources are evaluated using Switzerland as the study area. Forty-four surface water locations in different rivers and an Alpine lake were investigated for 14 PFAAs, four precursors and acesulfame, an artificial sweetener used as a population marker. Concentrations of individual PFAAs were generally low, between 0.02 and 10 ng/L. Correlation analysis showed that some PFAAs concentrations correlated well with population and less with catchment area, indicating that emissions from population, i.e., from consumer products, is the most important source to surface waters in Switzerland. The correlation with the population marker acesulfame confirmed this observation but highlighted also a few elevated PFAA levels, some of which could be attributed to industrial emissions.     

新型结构ABR的设计与水力特性研究

针对ABR自身的缺点,设计出一种新型结构的ABR.该反应器为双层结构,共有5部分组成,各部分容积各不相同.该反应器的设计思想是将ABR与生物滤池以及活性炭吸附等工艺相联合.这种设计能够最大程度地发挥各工艺的优势,进而达到更好的处理效果.通过脉冲响应实验对该反应器的水力特性进行研究,得出不同水力停留时间(HRT)下的停留...     

水力条件对复合人工湿地处理城市受污染河水效果的影响

通过对水力负荷、水力停留时间等水力条件的控制,观察其对复合垂直上行流人工湿地处理城市受污染河水效果的影响.一年多来的运行结果表明:水力条件对复合垂直上行流人工湿地去除其他污染物的影响显著,但对总氮去除的影响不大.水力停留时间的延长可提高总磷、氨氮、COD的去除效果;随着水力负荷的增加,总磷、氨氮、COD去除率都有所增加...     

垂直流人工湿地水力学特性研究

通过示踪剂实验从停留时间分布（RTD）曲线及其统计特征值等方面对垂直流人工湿地的水力学特性进行了定性和定量的分析。研究表明水流在垂直流人工湿地中的流动是一种非理想的不均匀流动,存在一定的死区和水流的扩散;垂直流人工湿地较大的死区率与其表面布水的不均匀性有关,这也可能是其死区率大于表流人工湿地的最主要的原因。实验还表明,进水流量对垂直流人工湿地停留时间分布影响较大,随着进水流量的增加,平均停留时间减小,但标准平均停留时间增大,死区率减小;当进水流量为15L／h（水力负荷为620mm／d）时,水流在湿地中的散度最大,水流更接近全混流,不利于污染物的降解。     

pH、盐度对微生物还原硫酸盐的影响研究

采用厌氧生物处理工艺,研究了在不同盐度下pH连续降低对硫酸盐还原和有机物去除率的影响。实验结果表明,硫酸盐还原菌有很强的适应pH变化的能力,在pH值达到4以下仍有60％的硫酸盐去除率。NaCl浓度由4g／L增加到50g／L抑制了各厌氧菌的活性,导致硫酸盐和有机物去除率的下降,但硫酸盐还原菌耐受性高于产甲烷菌等其他厌氧菌,在NaCl浓度为50g／L下,硫酸盐去除率能达到50％,而有机物去除率则低于30％。qRT—PCR表明了系统菌落中SRB随着环境的变化情况与化学指标结果相一致,该反应器体系中SRB在整个厌氧菌群落中只占了很小部分。     

盐城市区环境空气污染原因分析及对策建议

通过对盐城市区建成空气自动监测站来的数据分析,简要说明了盐城市区环境空气质量下降的原因,并提出了改善城市大气污染的建议措施。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.     

Substituting missing data in compositional analysis

Multivariate analysis of environmental data sets requires the absence of missing values or their substitution by small values. However, if the data is transformed logarithmically prior to the analysis, this solution cannot be applied because the logarithm of a small value might become an outlier. Several methods for substituting the missing values can be found in the literature although none of them guarantees that no distortion of the structure of the data set is produced. We propose a method for the assessment of these distortions which can be used for deciding whether to retain or not the samples or variables containing missing values and for the investigation of the performance of different substitution techniques. The method analyzes the structure of the distances among samples using Mantel tests. We present an application of the method to PCDD/F data measured in samples of terrestrial moss as part of a biomonitoring study.     

Engineered nanomaterials in rivers--exposure scenarios for Switzerland at high spatial and temporal resolution

Probabilistic material flow analysis and graph theory were combined to calculate predicted environmental concentrations (PECs) of engineered nanomaterials (ENMs) in Swiss rivers: 543 river sections were used to assess the geographical variability of nano-TiO₂, nano-ZnO and nano-Ag, and flow measurements over a 20-year period at 21 locations served to evaluate temporal variation. A conservative scenario assuming no ENM removal and an optimistic scenario covering complete ENM transformation/deposition were considered. ENM concentrations varied by a factor 5 due to uncertain ENM emissions (15%-85% quantiles of ENM emissions) and up to a factor of 10 due to temporal river flow variations (15%-85% quantiles of flow). The results indicate highly variable local PECs and a location- and time-dependent risk evaluation. Nano-TiO₂ median PECs ranged from 11 to 1′623 ng L⁻¹ (conservative scenario) and from 2 to 1′618 ng L⁻¹ (optimistic scenario). The equivalent values for nano-ZnO and nano-Ag were by factors of 14 and 240 smaller.