基于均匀分布的滑坡数值模拟参数取值概率研究--以甘肃黑方台黄土滑坡为例

针对数值模拟参数选取主观性强、量化难度大的问题,在高精度无人机地形数据的基础上,通过对11起滑坡案例进行了407组参数反演实验,对结果准确度定量评价后,得到基于Massflow数值软件关键参数λ0的分布范围,进而运用小样本极大似然估计理论,分析区间边界长度对反演精度的影响,最终提出基于均匀分布的参数取值概率模型,并选用案例验证该模型的准确性。结果表明:地形约束会导致反演过程中所需的内聚力减小,反演获得的11组最优λ0的极差和方差分别为0.29、0.01,在置信度为95%下,极大似然法得到区间边界估计长度仅为0.0998,表明参数λ收敛性较好;反演过程中质心滑动距离ψ准确度优于堆积面积重叠率η,在λ0±0.05的范围,参数估计区间内任意值对模拟误差影响较小,评价指标ψ、η与λ0对应案例的相对误差不超过15%;所选案例验证了在置信度为95%下,以反演得到的最优参数区间边界中点构建概率分布函数的可行性和准确性,研究方法可为单体滑坡数值模拟风险评价提供理论支撑。     

西安咸阳国际机场污水排放口潜在滑坡稳定性分析

对西安咸阳国际机场污水排放口潜在滑坡的工程地质勘察结果表明,该滑坡处于极限平衡状态。采用B ish-op法参数反演和直快剪试验结果,分别用二维、三维极限平衡法和二维、三维有限元法,对该滑坡进行稳定性计算。结果表明:有限元法(二维、三维)的计算结果偏大,二维极限平衡法的计算结果最小;极限平衡法(二维、三维)与二维有限元法宜选取试验结果的大值平均值,三维有限元法则取试验结果的小值平均值较为合理。最后,根据三维有限元法的计算结果,提出了削坡压脚的防护措施。     

通风机站风流间相互影响阻力特性研究*

为研究双风机并联机站进口、出口风流相互影响的机站局部阻力特性,构建机站通风局部阻力计算的数学模型,同时运用相似原理建立双风机并联通风机站实验模型,并佐以数值模拟对比验证,分析计算不同风机间距的无量纲数A、不同扩散器结构参数条件下的综合影响系数Kc。结果表明:A与Kc具有二次函数关系,且存在较优的A,使得Kc值最小;Kc值随着L/Df增加而线性减小。研究结果有利于Kc的选取,为高效率通风机站结构设计提供技术及数据支撑。     

Study on explosion risk of aluminum powder under different dispersions

This paper mainly studied the influence of particle size distribution on the explosion risk of aluminum powder under the span of large particle size distribution. The measurement was carried out with the 20 L explosion ball and the Hartmann tube. The statistical analysis was used to analyze the relevance between the parameters of explosion risk and the particle size parameters. Test results showed that with the increase of particle size, the sensitivity parameter increases and the intensity parameter deceleration decreases. The effect of particle size change on MEC and MIE of small particle size aluminum powder is relatively small but greater impact on Pm and (dP/dt)m. The small particle size components greatly increasing the sensitivity of the explosion and accelerating the rate of the explosion reaction; while the large particle size component contributes to the maximum explosion pressure. D_3,2 particle size dust determines the risk of aluminum powder explosion.     

Characterization of Ti powders mixed with TiO2 powders: Thermal and kinetic studies

The fire and explosion risks of metal powders admixed with solid inertants have been extensively investigated for many years. However, it remains unclear why such solid mixtures have high potential fire and explosion risk even when mixed with high percentages of non-combustible solids. This paper investigates how to interpret these risks, from a microscopic perspective, with thermal and kinetic parameters including initial ignition temperature, mass unit exothermic energy, activation energy and risk index of spontaneous combustion. The results show that the initial ignition temperature based on TG (Thermogravimetry) analysis is related to ignition sensitivity, and increased with percentage of admixed solid inertant. The unit mass exothermic energy based on DSC (Differential scanning calorimetry) analysis is related to flame spread velocity. Activation energy and the risk index of spontaneous combustion can be used to explain the reactivity and spontaneous combustion hazard, respectively, of metal powders. We conclude that thermal and kinetic parameters may provide another way to describe the fire and explosion risk of combustible powders, especially for nano metal powders due to the laboratory safety in the normative tests for explosion parameter determination.     

Selecting Species for Marine Assessment of Radionuclides Around Amchitka: Planning for Diverse Goals and Interests

Considerable attention has been devoted to selecting bioindicator species as part of monitoring programs for exposure and effects from contaminants in the environment. Yet the rationale for selection of bioindicators is often literature-based, rather than developed with a firm site-specific base of data on contaminant levels in a diverse range of organisms at different trophic levels in the same ecosystem. We suggest that this latter step is an important phase in the environmental assessment process that is often missing. In this paper we address the problem of how to select a wide range of species representing different trophic levels that serve as a basis for selecting a few species suitable as bioindicators. We illustrate this with our assessment of radionuclides on Amchitka Island, Alaska. We propose a multi-stage process for arriving at the list of available species that includes review of literature, review by experts experienced in the area, review by interested and affected parties, selection of trophic levels or groups for analysis, arraying of possible species, and selection of species within each trophic level group for sample collection. We first had to identify all likely species, then narrow our focus to those we could collect and analyze. In all cases, review includes suggestions for possible target species with justifications. While this method increases the up-front costs of developing bioindicators for an ecosystem, it has the advantage of providing information for selection of species that will be most informative in the long run, including those that are the best bioaccumulators, thus providing the earliest warning of any potential environmental consequences. Further, the recognition that a range of stakeholder's needs and interests should be included increases the utility for public-policy makers, and the potential for continued usage to establish long-term trends.     

基于GIS的乌梁素海水体富营养化状况的模糊模式识别

利用基于MATLAB 7.0实现的模糊模式识别交叉迭代模型对2006年5—10月分布于乌梁素海各水体功能区的21个水质监测点的富营养化等级进行了模糊模式识别,并在GIS技术支持下,用Arcview的空间分析功能绘制富营养化等级识别结果、对富营养化状态影响权重最大的评价指标总氮(TN)含量和富营养化状态控制元素总磷(TP)含量对应的富营养化等级水体和地表水质等级水体的空间分布月变化Grid专题图.将富营养化状态变化及其分布区域与乌梁素海同期水质监测指标浓度变化及其分布区域进行对比分析及验证.结果表明,富营养化等级识别结果的时空分布与实际情况相符,能够比较准确地反映富营养化等级定量的时空变化趋势.      

荧光法研究DNA与蒽相互作用机理

利用荧光猝灭光谱和紫外-可见吸收光谱研究了体外DNA对蒽的荧光猝灭机理.结果表明,DNA的紫外-可见光谱没有发生红移现象,通过计算分析不同温度下的荧光猝灭常数和热力学参数,结合两种光谱分析可知DNA对蒽的荧光猝灭属于动态猝灭机理.     

Denitrification potential enhancement by addition of external carbon sources in a pre-denitrification process

The aim of this study is to investigate the denitrification potential enhancement by addition of external carbon sources and to estimate the denitrification potential for the predenitrification system using nitrate utilization rate （NUR） batch tests. It is shown that the denitrification potential can be substantially increased with the addition of three external carbon sources, i.e. methanol, ethanol, and acetate, and the denitrification rates of ethanol, acetate, and methanol reached up to 9.6, 12, and 3.2 mgN/（g VSS.h）, respectively, while that of starch wastewater was only 0.74 mgN/（g VSS,h）. By comparison, ethanol was found to be the best external carbon source. NUR batch tests with starch wastewater and waste ethanol were carried out. The denitfification potential increased from 5.6 to 16.5 mg NO3-N/L owing to waste ethanol addition. By means of NUR tests, the wastewater characteristics and kinetic parameters can be estimated, which are used to determine the denitrification potential of wastewater, to calculate the denitrification potential of the plant and to predict the nitrate effluent quality, as well as provide information for developing carbon dosage control strategy.     

Thermodynamics and kinetics of cadmium adsorption onto oxidized granular activated carbon

Cadmium sorption behavior of granular activated carbon oxidized with nitric acid was systematically studied by sets of the equilibrium and time-based experiments under various conditions.The cadmium adsorption capacity of oxidized granular activated carbon enlarged with an increase in pH,and reduced with an increase in ionic strength.Experimental data were evaluated to find out kinetic characteristics.Adsorption processes were found to follow pseudo-second order rate equation.Adsorption isotherms correlate well with the Langmuir isotherm model and the maximum sorption capacity of cadmium evaluated is 51.02μmol/g.Thermodynamic parameters were calculated based on Van't Hoff equation.Equilibrium constant Kd was evaluated from Freundlich isotherm model constants,Langmnir isotherm model constants,and isotherms,respectively.The average change of standard adsorption heatΔH~0 was -25.29 kJ/mol.NegativeΔH~0 andΔG~0 values indicate the adsorption process for cadmium onto the studied activated carbon is exothermic and spontaneous.The standard entropyΔS~0 was also negative,which suggests a decrease in the freedom of the system.