等效温度曲线的数值拟合

通风空调工程中,等效温度是衡量气候舒适程度的主要指标.传统的查图法求解等效温度不仅繁琐,而且不准确.本文以等效温度为基础,在等效温度图中取值,运用Matlab拟合数据,并进行坐标变换,求解出干球温度、湿球温度及风速之间的规律,推导出等效温度的数值求解方法.经实例计算和误差分析证明,此数值解法较为准确.     

烟气羽流时空混沌行为的耦合映象格子模型研究

为研究烟气羽流的时空混沌行为,本文从烟气羽流的N-S动量方程出发,根据浮力羽流的半经验公式,对方程中相应的项进行替代、化简,然后无量纲化,得到了以烟气羽流的动量通量m为系统状态矢量的单向耦合映象格子模型.计算了不同参数变化时,耦合周期窗口的时空行为发展,并且进行了李雅普诺夫指数λ计算.分析表明,开放系统中的烟气羽流会出现形态的多重性,包括时空混沌行为.这是由于烟气羽流系统内各种非线性作用的相互影响,也就是方程粘性项、浮力项和惯性项作用强弱对比的变化,以及系统行为发展的不可逆性所导致.     

南京及邻近地区新近沉积土的动剪切模量和阻尼比的试验研究

通过对南京及其邻近地区漫滩相成因的粘土、粉质粘土、淤泥质粉质粘土、粉质粘土与粉砂互层土、粉土、粉细砂等 6类新近沉积土的自振柱试验 ,详细探讨了围压大小、剪应变水平、土的颗粒组成和结构性对这 6类新近沉积土的剪切模量G及阻尼比λ的影响。通过与Seed和Idriss建议的砂土G/Gmax～γ和λ～γ曲线变化范围的对比 ,结果表明 ,不能将粉质粘土与粉砂互层土简单地当作砂土或粉质粘土对待。通过试验和理论分析 ,给出了南京及其邻近地区 6类新近沉积土动剪切模量和阻尼比随剪应变变化的平均曲线的拟合曲线、包络线及其参数的推荐值 ,对实际工程具有一定的借鉴作用     

脉动风速功率谱与随机Fourier幅值谱的关系研究

功率谱密度函数是随机过程在频域内的重要特征量,但由于其本质上是平稳过程的频域数值特征,致使其很难全面反映原始随机过程的概率信息,这就需要从更本源的意义上考察随机过程。本文试图从Fourier随机函数的角度反映随机过程,将经典的功率谱密度函数中具有物理意义的可测变量看作随机变量,利用功率谱与Fourier幅值谱的关系,定义了随机Fourier幅值谱;以Davenport谱为例,证实当地面粗糙度服从对数正态分布、10m高度基本风速服从极值Ⅰ型分布时,可通过功率谱构造具有物理意义的随机Fourier幅值谱。通过实测风速Fourier谱与随机Fourier幅值谱的比较,证明随机Fourier幅值谱的概念具有合理性。     

沥青涂层对桩侧摩阻力影响的试验研究

采用改进直剪仪模拟桩与土之间的滑动摩擦,研究了沥青涂层对桩侧摩阻力的影响。试验结果表明,桩侧摩阻力与土的类型、法向应力有关,随着法向应力的增长,滑动摩阻力也相应增长,且增长近似呈线性关系;在一定的法向应力下,沥青涂层对减小滑动摩阻力有一定的作用,随着法向应力的增长,沥青涂层亦会导致滑动摩阻力增加。     

移动式环保公厕车防震抗风安全性研究

移动式环保公厕车工作地点范围广、环境复杂,且没有地基固定,要求其具有特别高的抗地震能力、抗风载变形能力。利用有限元仿真的方法,研究了移动式环保公厕车在不同地震载荷、风力载荷条件下的变形和应力状况,分析了地震载荷和风力载荷对移动式环保公厕车破坏程度和破坏机理,对比了单一载荷作用与复合载荷作用的区别,从而为移动式环保公厕车使用环境的选择、安全检查的合理安排等提供有力的参考依据。     

A comparative study of prognostic MM5 meteorological modeling with aircraft, wind profiler, lidar, tethered balloon and RASS data over Philadelphia during a 1999 summer episode

This study presents a comparative evaluation of the prognostic meteorological Fifth Generation NCAR Pennsylvania State University Mesoscale Model (MM5) using data from the Northeast Oxidant and Particle Study (NE-OPS) research program collected over Philadelphia, PA during a summer episode in 1999. A set of model simulations utilizing a nested grid of 36 km, 12 km and 4 km horizontal resolutions with 21 layers in the vertical direction was performed for a period of 101 h from July 15, 1999; 12 UTC to July 19, 1999; 17 UTC. The model predictions obtained with 4 km horizontal grid resolution were compared with the NE-OPS observations. Comparisons of model temperature with aircraft data revealed that the model exhibited slight underestimation as noted by previous investigators. Comparisons of model temperature with aircraft and tethered balloon data indicate that the mean absolute error varied up to 1.5 °C. The comparisons of model relative humidity with aircraft and tethered balloon indicate that the mean relative error varied from –11% to –22% for the tethered balloon and from –5% to –30% for the aircraft data. The mean relative error for water vapor mixing ratio with respect to the lidar data exhibited a negative bias consistent with the humidity bias corresponding to aircraft and tethered balloon data. The tendency of MM5 to produce estimates of very low wind speeds, especially in the early-mid afternoon hours, as noted by earlier investigators, is seen in this study also. It is indeed true that the initial fields as well as the fields utilized in the data assimilation also contribute to some of the differences between the model and observations. Studies such as these which compare the grid averaged mean state variables with observations have inherent difficulties. Despite the above limitations, the results of the present study broadly conform to the general traits of MM5 as noted by earlier investigators.     

WIND GENERATED WAVES IN LAKE OKEECHOBEE1

ABSTRACT: The study of wind generated waves is important because waves affect sediment resuspension in lakes. Measurements of wind velocity and wave elevation were made at three different stations in Lake Okeechobee. Significant wave heights were computed using a direct count from the recorded data, and verified by the root-mean-square value approach. The correlation between wind stress and significant wave height also was analyzed. The data revealed a strong correlation. In addition to field measurements, a Boussinesq-type wind-wave model was developed to simulate wind-generated, long-propagating waves. This model included the effects of wind stress and bottom viscous dissipation. Wave elevation and velocity field were evaluated numerically. A six-day simulation using 1996 wind data was conducted. Simulated significant wave heights were found to agree reasonably well with measured values. A predictive wind-wave model provides information about wind generated waves, which is used to compute bottom shear stresses required for sediment resuspension studies.     

非饱和渗流作用下土坡的数值计算分析

讨论了考虑非饱和流渗作用下的土坡的数值计算分析,采用了不同含水量对抗剪强度影响的模型,求解带有渗透力作用项的土体弹塑性平衡方程得到土坡的应力应变分布,并应用于降雨滑坡的简单算例分析。由算例分析得知,利用非饱和渗流耦合应力的弹塑性来分析非饱和渗流而引起的土体滑坡的变形和发展是可行的,并值得完善和发展。     

基于机器学习的电热防除冰表面温度变化趋势预测

针对飞机部件周期控制律电加热防除冰的应用,提出基于机器学习以预测电加热防除冰表面温度的变化趋势.依靠大型结冰风洞及其电加热防除冰控制系统完成防除冰试验,获得有效的试验数据,以通、断电周期为分割单元,将试验数据划分成验证集和训练集.根据电热防除冰过程的换热情况,构建样本的特征参数,利用机器学习的有监督学习方式,选择KNN近邻回归算法和局部线性加权回归算法预测温度变化率,再转换为温度,得到的温度变化与测量数据的线性相关性达到80％以上的高相似度结果,表明使用机器学习可快速预测电热防除冰部件的表面温度变化趋势,且不同的回归算法针对模型不同测温点位置的预测效果存在差异.