南充炼油化工总厂污水处理技改及运行综述

南充炼油化工总厂污水处理装置从2004年开始进行技术改造，于2005年8月实现了已改设施一次开车成功，各项水质指标均达到并超过设计要求。对技术改造的情况、采用的新技术新工艺做全面介绍，对装置改造后的运行效果进行分析。     

高能等离子体分解CO_2气体研究

为治理温室气体ＣＯ_２，本工作在低温常压条件下，利用超高压脉冲电晕放电产生的高能量（２０～５０ｅＶ）非平衡等离子体作用于ＣＯ_２气体分子，使ＣＯ_２分子化学结合键断裂，在定向化学反应作用下，将ＣＯ_２气体分解成单原子气体分子Ｏ_２和单质固体微粒Ｃ。ＣＯ_２分解率在９０％以上。     

New microbial electrosynthesis system for methane production from carbon dioxide coupled with oxidation of sulfide to sulfate

Microbial electrosynthesis system (MES) is a promising method that can use carbon dioxide, which is a greenhouse gas, to produce methane which acts as an energy source, without using organic substances. However, this bioelectrical reduction reaction can proceed at a certain high applied voltage when coupled with water oxidation in the anode coated with metallic catalyst. When coupled with the oxidation of HS^– to SO₄²⁻, methane production is thermodynamically more feasible, thus implying its production at a considerably lower applied voltage. In this study, we demonstrated the possibility of electrotrophic methane production coupled with HS^– oxidation in a cost-effective bioanode chamber in the MES without organic substrates at a low applied voltage of 0.2 V. In addition, microbial community analyses of biomass enriched in the bioanode and biocathode were used to reveal the most probable pathway for methane production from HS^– oxidation. In the bioanode, electroautotrophic SO₄²⁻ production accompanied with electron donation to the electrode is performed mainly by the following two steps: first, incomplete sulfide oxidation to sulfur cycle intermediates (SCI) is performed; then the produced SCI are disproportionated to HS^– and SO₄²⁻. In the biocathode, methane is produced mainly via H₂ and acetate by electron-accepting syntrophic bacteria, homoacetogens, and acetoclastic archaea. Here, a new eco-friendly MES with biological H₂S removal is established.     

Nitrate removal from aqueous solutions by magnetic cationic hydrogel: Effect of electrostatic adsorption and mechanism

Excessive nitrate(NO_3~-) is among the most problematic surface water and groundwater pollutants.In this study,a type of magnetic cationic hydrogel(MCH) is employed for NO_3~-adsorption and well characterized herein.Its adsorption capacity is considerably pHdependent and achieves the optimal adsorption(maximum NO_3~--adsorption capacity is95.88±1.24 mg/g) when the pH level is 5.2-8.8.The fitting result using the homogeneous surface diffusion model indicates that the surface/film diffusion controls the adsorption rate,and NO_3~-approaches the center of MCH particles within 30 min.The diffusion coefficient(D_s) and external mass transfer coefficient(k_F) in the liquid phase are1.15 × 10~(-6) cm~2/min and 4.5 × 10~(-6) cm/min,respectively.The MCH is employed to treat surface water that contains 10 mg/L of NO_3~-,and it is found that the optimal magnetic separation time is 1.6 min.The high-efficiency mass transfer and magnetic separation of MCH during the adsorption-regeneration process favors its application in surface water treatment.Furthermore,the study of the mechanism involved reveals that both-N~+(CH_3)_3 groups and NO_3~-are convoluted in adsorption via electrostatic interactions.It is further found that ion exchange between NO_3~-and chlorine occurs.     

铁路沿线供暖用低温空气源热泵热力性能对比研究

我国北方铁路沿线站段冬季采暖主要以燃煤锅炉为主,随着冬季雾霾现象日益严重,采用空气源热泵作为北方铁路沿线传统燃煤锅炉供暖的替代方式,对于减少能源消耗、改善大气环境具有重要意义。研究跨临界CO2热回收热泵和回热循环热泵系统2种低温空气源热泵系统,对其热力性能进行了实验和对比分析。结果表明,当环境温度不变时,随着供水温度由45℃升高至55℃,跨临界CO2热回收热泵制热量和COP均升高;随着供水温度由45℃升高至50℃,回热循环热泵制热量和COP均逐渐降低。当供水温度低于50℃时,回热循环热泵COP高于跨临界CO2热回收热泵,回热循环热泵系统的节能效果更为显著;当供水温度超过50℃时,跨临界CO2热回收热泵的性能更优。在低温环境条件下,跨临界CO2热回收热泵系统能够提供更高的供水温度,并有效提升空气源热泵的制热性能,结合我国北方铁路沿线站段的供暖需求和气候条件,提出相较于回热循环热泵系统,跨临界CO2热回收热泵系统的适用性和热力性能更为优越。     

Inherently Safer Design for low-temperature process during depressurization: An industrial case study

The exploitation of a low-quality gas field with high CO₂ concentration is more viable through liquid CO₂ produced from cryogenic distillation technology. Despite the bright potential of the technology, there are deficiencies in handling high concentration of CO₂ at low temperature and high pressure during the blowdown condition. This study focuses on the CO₂ blowdown at a cryogenic pilot plant designed to manage high concentrations of CO₂ in the feed gas, high pressures, and low temperatures. A comprehensive design review and risk assessment using Inherent Safer Design (ISD) indexes were carried out in this study. The ISD was performed to identify the current risk level, and the critical parameters that may cause solid CO₂ formation in the piping or equipment as well as to identify mitigation measures to avoid the temperature to drop below the CO₂ freezing point during blowdown. The present findings confirmed that the initial pressure and temperature, as well as CO₂ concentration are key parameters towards significant impact on blowdown conditions. Therefore, the reduction of the feed gas pressure from 80 bar to 70 bars has minimized the Joule Thomson (JT) effect during blowdown and avoided the CO₂ solid formation in the system. Moreover, the relocation of the blowdown valve at the downstream heater resulted in a higher final temperature above the CO₂ freezing point. The ISD indexes confirmed that the cryogenic facilities are inherently safer during blowdown with the mitigation measures adopted.     

Mercury in Precipitation at an Urbanized Coastal Zone of the Baltic Sea (Poland)

Wet deposition is an important source of metals to the sea. The temporal variability of Hg concentrations in precipitation, and the impact of air masses of different origins over the Polish coastal zone were assessed. Samples of precipitation were collected (August 2008–May 2009) at an urbanized coastal station in Poland. Hg analyses were conducted using CVAFS. These were the first measurements of Hg concentration in precipitation obtained in the Polish coastal zone. Since Poland was identified as the biggest emitter of Hg to the Baltic, these data are very important. In the heating and non-heating season, Hg concentrations in precipitation were similar. Hg wet deposition flux dominated in summer, when the production of biomass in the aquatic system was able to actively adsorb Hg. Input of metal to the sea was attributed to regional and distant sources. Maritime air masses, through transformation of Hg(0), were an essential vector of mercury in precipitation.     

Identifying and Evaluating a Suitable Index for Agricultural Drought Monitoring in the Texas High Plains

Drought is a complex and highly destructive natural phenomenon that affects portions of the United States almost every year, and severe water deficiencies can often become catastrophic for agricultural production. Evapotranspiration (ET) by crops is an important component in the agricultural water budget; thus, it is advantageous to include ET in agricultural drought monitoring. The main objectives of this study were to (1) conduct a literature review of drought indices with a focus to identify a simple but simultaneously adequate drought index for monitoring agricultural drought in a semiarid region and (2) using the identified drought index method, develop and evaluate time series of that drought index for the Texas High Plains. Based on the literature review, the Standardized Precipitation‐Evapotranspiration Index (SPEI) was found to satisfy identified constraints for assessing agricultural drought. However, the SPEI was revised by replacing reference ET with potential crop ET to better represent actual water demand. Data from the Texas High Plains Evapotranspiration network was used to calculate SPEIs for the major irrigated crops. Trends and magnitudes of crop‐specific, time‐series SPEIs followed crop water demand patterns for summer crops. Such an observation suggests that a modified SPEI is an appropriate index to monitor agricultural drought for summer crops, but it was found to not account for soil water stored during the summer fallow period for winter wheat.     

DPD分光光度法测定水质中余氯的方法研究

采用行业标准DPD分光光度法(HJ 568-2010)测定水中的游离余氯,验证了去掉第一点的低浓度曲线的有效性。分别比较不同的显色时间对吸光度的影响,结果表明显色时间应控制在10min以内。     

A detailed analysis of musculoskeletal disorder risk factors among Japanese nurses

INTRODUCTION: Although Musculoskeletal Disorders (MSD) represent a common occupational problem, few epidemiological studies have investigated MSD risk factors among Asian nurses, particularly those in Japan. METHOD: We administered a modified Japanese-language version of the Standardized Nordic Questionnaire to 1,162 nurses from a large teaching hospital. MSD categories focused on the neck, shoulder, upper back, and lower back regions. RESULTS: A total of 844 completed questionnaires were analyzed (response rate: 72.6%). The 12-month period-prevalence of MSD at any body site was 85.5%. MSD was most commonly reported at the shoulder (71.9%), followed by the lower back (71.3%), neck (54.7%), and upper back (33.9%). Alcohol consumption, tobacco smoking, and having children were shown to be significant risk factors, with adjusted Odds Ratios of 1.87 (95%CI: 1.17-2.96), 2.45 (95%CI: 1.43-4.35), and 2.53 (95%CI: 1.32-4.91), respectively. Workplace risk factors included manually handling patients (OR: 2.07 to 11.97) and undertaking physically laborious work (OR: 2.09 to 2.76). Nurses reporting pre-menstrual tension were 1.66 and 1.94 times more likely to suffer from lower back and upper back MSD, respectively. High mental pressure was also identified as a significant risk factor for MSD of the neck (OR: 1.53) and shoulder (OR: 2.07). IMPACT ON INDUSTRY: The complex nature of MSD risk factors identified during this study suggests that remediation strategies which focus only on manual handling tasks would probably be suboptimal in reducing MSD among nurses. Therefore, to help alleviate their considerable MSD burden, a greater emphasis will need to be placed on job satisfaction, work organization, and occupational stress, as well as the more traditional hazard reduction strategies such as manual handling, work tasks, and other occupational factors.