Effects of release pressure on the transportation characteristics in pipeline and the diffusion behaviors in enclosure space of typical gas extinguishing agent

Reducing the release pressure of fire extinguishing systems can decrease potential safety hazards in large transport airplanes. To explore whether reducing the release pressure can achieve the release effect required by the airworthiness standards or not, the transportation characteristics in the pipeline and diffusion behaviors in the enclosure space of a typical fire extinguishing agent (Halon 1301) were investigated under five release pressures in the present study. The effects of the release pressure on the degree of superheat, injection duration, jet structure, and concentration distribution of Halon 1301 were analyzed. The results show that both of the degree of superheat and the injection duration decrease with an increase in the release pressure. The supplement of bubble expansion in the fire extinguishing agent can slow down the pressure decrease in the vessel. Both of the maximum and mean values of the pipeline differential pressure increase with an increase in release pressure. The maximum value of the jet angle decreases linearly with the increase in release pressure, and the jet deflects upward owing to the effects of buoyancy. The maximum concentration value decreases with an increase in the distance from the nozzle. The maximum concentration values in the near field from the nozzle increase with an increase in the release pressure. Under five release pressures, the concentration and holding time (duration above 6% volume concentration) of Halon 1301 on the centerline of the jet meet the requirements of airworthiness provisions.     

PVC电缆火灾早期特征气体的组成分析和传感器探测

利用气体传感器对电缆绝缘过热释放的气体进行监测有望实现电气火灾早期预警,目前该技术的发展由于特征气体未得到确认而受到限制。分析了聚氯乙烯(PVC)电缆绝缘层在不同温度下释放的气体组成,并对其主要成分进行传感器测试。TG-IR和GC-MS分析表明PVC电缆绝缘层在200℃前已出现微小失重,释放出以邻苯二甲酸二辛酯(DOP)等塑化剂为主的气体。气敏测试中,商用半导体气体传感器对DOP和电缆蒸气产生较好、相似的响应性能。因此,DOP可以作为PVC电缆火灾早期的特征气体。     

湿式煤气柜施工安全措施的制订

针对正在运行的湿式煤气柜防火间距不够的位置动火建造大10倍的湿式煤气柜的实际情况,采取现场调查、安全系统分析,制订切实可行的措施,顺利完成施工任务。     

粉煤灰改性吸附材料处理沥青烟气

分析了粉煤灰改性后的物质基础 ,采用吸附法 ,利用改性粉煤灰作为吸附剂对沥青烟气进行处理 ,通过实验研究得到一定的运行参数 ,为沥青烟气的处理提供了理论依据     

固相微萃取气相色谱法测定水样中的苯胺、吡啶

应用PDMS/DVB固相微萃取探头,结合GC/FID测定水中的苯胺、吡啶.优化了萃取温度、萃取平衡时间、pH等条件.该方法对苯胺和吡啶的检测限分别为0.050、0.065 mg/L,相对标准偏差6.44%～8.67%,具有快速、准确和方便等优点.     

气质联用分析加硫酸化污泥中的有机酸

分别采用两种前处理方法分离富集加硫酸化污泥中的有机酸.方法一,利用阴离子交换树脂分离富集有机酸,在不洗脱的情况下直接和乙醇进行酯化反应,然后进行气质联用分析;方法二,利用活性炭纤维吸附型固相微萃取(ACF-SPME)的方法,顶空萃取分离后进行气质联用分析.两种方法的分析结果都未检测到酸化污泥中存在短链的有机酸,只检测到个别长链的和带苯环结构的有机酸.     

蜂窝断面内循环三相生物流化床内流动状况的数值模拟

根据蜂窝断面内循环三相生物流化床内混合液的连续性方程、动量方程和能量方程,利用Fluent软件对反应器内的流动状况进行了数值模拟.采用Fluent的前处理软件Gambit完成流化床的三维模型,利用Fluent主程序解析计算,并利用后处理软件实现计算结果的显示.模拟计算结果获得了反应器内静压力、静压差的变化规律,得到了液体循环速度、气含率沿纵向及横断面的分布.     

污泥与高浓度有机废物厌氧消化反应中的产气量

研究了高温／中温两相厌氧消化反应器系用以同时处理污泥与不同高浓度有机废物时产气及产甲烷的变化特性。结果表明，气体及甲烷主要是在第二段的中温消化反应器内产生。当中温消化反应器的有机负荷ＶＳ为１．６５￣３．１０ｋｇ／ｍ＾３ｄ时，稳态条件下的平均产气量为１．９５８￣４．０２０ｍ＾３／ｄ，气体中甲烷的平均组成为６５％￣７３％，甲烷的比产率为０．３９７￣０．５１１ｍ＾３／ｋｇＶＳ。     

Microbial reduction of sulfate injected to gas condensate plumes in cold groundwater

Despite a rapid expansion over the past decade in the reliance on intrinsic bioremediation to remediate petroleum hydrocarbon plumes in groundwater, significant research gaps remain. Although it has been demonstrated that bacterial sulfate reduction can be a key electron accepting process in many petroleum plumes, little is known about the rate of this reduction process in plumes derived from crude oil and gas condensates at cold-climate sites (mean temperature <10 degrees C), and in complex hydrogeological settings such as silt/clay aquitards. In this field study, sulfate was injected into groundwater contaminated by gas condensate plumes at two petroleum sites in Alberta, Canada to enhance in-situ bioremediation. In both cases the groundwater near the water table had low temperature (6-9 degrees C). Monitoring data had provided strong evidence that bacterial sulfate reduction was a key terminal electron accepting process (TEAP) in the natural attenuation of dissolved hydrocarbons at these sites. At each site, water with approximately 2000 mg/L sulfate and a bromide tracer was injected into a low-sulfate zone within a condensate-contaminant plume. Monitoring data collected over several months yielded conservative estimates for sulfate reduction rates based on zero-order kinetics (4-6 mg/L per day) or first-order kinetics (0.003 and 0.01 day(-1)). These results favor the applicability of in-situ bioremediation techniques in this region, under natural conditions or with enhancement via sulfate injection.