地震作用下结构失稳诱发的塌陷和地裂缝机理分析

分析了地震诱发的地表塌陷和地裂缝机制。通过地裂缝微观机理分析研究发现:(1)地震造成了大量的地裂缝和塌陷,这些破坏的出现与地震发生时造成的瞬间应力变化和结构破坏密切相关;(2)利用结构突变失稳理论来研究岩土体内部结构是可行的。当应力状态满足孔隙结构失稳判别式时,结构元的变形状态将产生一个“跳跃”;(3)地震情况下岩土体颗粒之间有效接触力的增加,使得结构的变形能增大;同时导致颗粒间连接刚度的降低,导致结构的失稳,这些变化又是在瞬间发生和完成的,这就造成了在地震发生时总是伴随着大量的裂缝和塌陷的出现。     

带压开采陷落柱突水影响因素数值模拟

为研究承压水压与煤层陷落柱位置这两种因素对陷落柱突水的影响,在分析固流耦合数学模型的基础上,利用数值模拟软件FLAC3D,以双柳矿地质条件为背景,分别对3 MPa和5 MPa承压水压下开采上、下两组煤4种情况进行模拟,分析陷落柱及其周边围岩的渗流-塑性破坏耦合场、应力场和位移场的变化.结果表明:随着工作面推进至接近陷落柱,工作面前方集中应力场与柱体周边应力场发生耦合,并出现应力集中,当水压为5 MPa开采上组煤时应力集中系数最大,最容易形成突水危险区域;当上组煤工作面距离陷落柱为30 m时,陷落柱渗流场与集中应力场开始连通,在开采下组煤时这一距离比上组煤扩大15 ～ 20 m;煤层底板随工作面推进发生压缩-膨胀周期变化,引起拉伸、剪切破坏.     

三维点云基础上排土场垮塌影响范围研究

高台阶排土场下游常分布有居民区、厂房等,一旦垮塌,后果严重,因此完善的防治与应急准备工作十分关键,而排土场垮塌影响范围的预测是这些工作的重要前提依据。为提升高台阶排土场垮塌影响范围的预测准确性,需要获取准确的地形边界基础数据。通过利用三维激光扫描仪对新建排土场及其下游地形精细扫描,对获取的三维点云数据去噪、拼接、建模等处理,生成精度更高的数字高程模型与三维实体模型。在此基础上,结合新建高台阶排土场地质勘查与设计资料,建立颗粒离散元数值模型,利用PFC3D计算高台阶排土场垮塌影响范围,并与经验公式法计算结果对比分析,结果表明排土场颗粒离散元数值模型精度符合要求,可快速、准确地计算影响范围,从而为相关部门提供科学决策依据。     

岩溶塌陷倾向性等级的KPCA-SVM预测模型

为了快速、有效地预测岩溶塌陷倾向性等级,在统计分析大量观测实例的基础上,选取岩性系数、岩体结构系数、地下水系数、覆盖层系数、地形地貌系数和环境条件系数作为特征指标。利用核主成分分析(KPCA)方法在高维空间提取岩溶塌陷影响因子的主成分,将获取的主成分作为支持向量机(SVM)的特征向量,建立基于KPCA的岩溶塌陷倾向性等级的SVM预测模型。将12组观测数据作为学习样本对模型进行训练。采用回代估计法进行回检,误判率为0。利用训练好的模型对2组待判样本进行预测。结果表明:经KPCA后指标个数减少,相关性降低,SVM运算的复杂度降低。用该模型所得预测结果的准确率为100%。     

基于偏序集的采空区塌陷危险性评价研究

针对采空区塌陷危险性评价方法中的赋权争议问题,基于偏序集理论提出偏序集评价模型。首先阐明评价指标并确定其分级标准;然后应用偏序集评价模型得到Hasse图,并通过图展现的层集信息判别采空区塌陷危险程度;最后应用该模型对大宝山矿11个采空区的塌陷程度进行判别,评价结果准确合理。研究结果表明:该模型避免了以往研究中的赋权争议问题,克服了样本量不足致使模型无法应用的问题,而且能够应用更多的赋权方法识别排序的稳定程度,体现出样本间的分层信息。     

An architectural model of spring wheat: Evaluation of the effects of population density and shading on model parameterization and performance

ADELwheat is an architectural model that describes development of wheat in 3D. This paper analyzes the robustness of the parameterization of ADELwheat for spring wheat cultivars in relation to plant population density and shading. The model was evaluated using data from two spring wheat experiments with three plant population densities and two light regimes. Model validation was done at two levels of aggregation: (a) by comparing parameterization functions used as well as parameter values to the data (leaf and tiller appearance, leaf number, blade dimensions, sheath length, internode length) and (b) by comparing ground cover (GC) and leaf area index (LAI) of simulated virtual wheat plots with GC and LAI calculated from data. A sensitivity analysis was performed by modulating parameters defining leaf blade dimensions and leaf or tiller appearance rate.In contrast to population density, shading generally increased phyllochron and delayed tiller appearance. Both at the level of the organ and at the level of the canopy the model performed satisfactorily. Parameterization functions in the model that had been established previously applied to independent data for different conditions; GC and LAI were simulated adequately at three population densities. Sensitivity analysis revealed that calibration of phyllochron and blade area needs to be accurate to prevent disproportional deviations in output.The robustness of the model parameterization and the simulation performance confirmed that the model is a complete architectural model for aboveground development of spring wheat. It can be used in studies that require simulation of spring wheat structure, such as studies on plant–insect interaction, remote sensing, and light interception.     

唐山市典型岩溶塌陷概述

本文在分析唐山市区几个典型岩溶塌陷(凤凰山公园荷花池塌陷、唐山十中塌陷、体育场岩溶塌陷)的分布规律、形成条件及影响因素的基础上,提出了综合防治措施。     

Laboratory evidence of natural remobilization of multicomponent DNAPL pools due to dissolution

Mixtures of dense non-aqueous phase liquids (DNAPLs) trapped in the subsurface can act as long-term sources of contamination by dissolving into flowing groundwater. In general, the components of higher solubility are removed more quickly, thus altering the composition of the remaining DNAPL, and possibly leading to changes in its physical properties. Through the development of a simple compositional model, Roy et al. [J. Contam. Hydrol. 2002 (59) 163] showed that preferential dissolution of a mixed DNAPL could potentially result in changes in density and interfacial tension that could subsequently lead to remobilization of an initially static DNAPL pool. The laboratory experiments presented in this next paper provide a proof-of-concept for the previously presented theory, demonstrating and quantifying this process of remobilization. In addition, the experiments provide a data set for evaluation of the model presented by Roy et al. [J. Contam. Hydrol. 2002 (59) 163]. In the four experiments, a DNAPL pool comprised of tetrachloroethene and benzene was created as an open pool overlying glass beads within a water-saturated 2-D flow box. Experiments included rectangular and triangular pools. In each of the experiments, remobilization (as breakthrough) was observed more than 2 weeks after formation of the initial pool. During each experiment, the pool height declined as mass was lost by dissolution, while sampling indicated a decrease in the mole fraction of benzene, the more soluble component. Small protuberances formed along the bottom of the pool as its composition changed with time and the displacement pressure was achieved for various pore throats. Eventually one of the protuberances extended further, forming a finger (breakthrough). In general, the pool emptied as the finger proceeded further into the beads. It was also shown theoretically and experimentally that remobilization will occur sooner for pools with a triangular (pointing down), rather than rectangular, shape. The experimental results were simulated using the model developed by Roy et al. [J. Contam. Hydrol. 2002 (59) 163]. The model matched the observations well, suggesting that it accurately represents the primary mechanisms involved with natural remobilization under the conditions of the study.     

A simplified approach to modelling underground migration of radionuclides from contaminated river sediments

Accidental releases of waste water from the first Czechoslovak nuclear power plant, A1, caused contamination of sediments of the Dudváh river, flowing into the Vah river, in Slovakia. Rather high concentrations of ¹³⁷Cs and ⁹⁰Sr (2150Bq dm⁻³ and 215Bq dm⁻³, respectively) were found in bottom sediments of a former channel of the re-engineered river body at a distance of about 250 m from a village, Siladice, with water-supply wells. In order to assess the possibility of contamination of the wells, underground migration of both radionuclides from the contaminated area was simulated using an original layered convection-diffusion model. K_d values determined in laboratory experiments were used. The analysis of the hydrological situation in the area reveals that the critical condition is a dominant horizontal groundwater flow near the water table in the direction from the Váh bank to Siladice, in the periods when the contaminated body lies under the water table. The simulation calculated under conservative conditions showed that the contamination of water-supply wells would not exceed permissible concentration limits.     

One-step estimation method and nomogram to predict safety distances of pressurized gas pipelines from blast sources

Pressurized gas pipelines may be endangered by accidental or intentional activities causing excess ground vibrations leading to failure. Thus, many papers have been published on this issue, yet most of these efforts suffer from complexity and inability to ascertain that all engaged factors are taken into account. These factors are attributed, namely, to explosion source, explosion-ground interaction, energy transfer through the ground, ground-pipeline interaction, and response of the pipeline. The deterministic method developed previously by the author has derived useful prediction mathematical formulas that can be used to calculate, either the stand-off distance of purposefully used explosives, or the maximum quantity of explosives to be used at a given distance, or the equivalent stress of a pipeline induced by an explosive charge at a given standoff distance. The method can also be applied to accidental blast events in factories or other activities. Yet, the complex formulas developed are hard to be used in the field and a simpler approach is needed to facilitate and accelerate in-field estimations. Thus, a nomogram was prepared to make the safety estimations easy and fast and taking into account all engaged critical factors starting from the explosion source through the integrity of the structure.