火灾下约束钢柱临界温度的简化计算方法

在火灾条件下,约束钢柱轴力由于升温而增加,会导致在较低的温度下发生屈曲;但屈曲后,钢柱的轴向温度膨胀得到释放,轴力下降,因此屈曲后钢柱仍能继续承栽。本文通过计算长度系数将转动约束钢柱转换为铰支钢柱,给出了一种轴向约束钢柱在火灾升温条件下的临界温度的简化计算方法——轴力放大系数设计方法。此法通过轴力放大系数将轴向约束钢柱转化为无约束钢柱,再按无约束钢柱计算得到钢柱的临界温度。用验证过的有限元模型对简化计算方法进行了验证,计算结果表明简化方法吻合较好。     

Water-soluble matter in PM2.5 in a coastal city over China: Chemical components, optical properties, and source analysis

Although marine and terrestrial emissions simultaneously affect the formation of atmospheric fine particles in coastal areas, knowledge on the optical properties and sources of water-soluble matter in these areas is still scarce. In this work, taking Qingdao, China as a typical coastal location, the chemical composition of PM_2.5 during winter 2019 was analyzed.Excitation-emission matrix fluorescence spectroscopy was combined with parallel factor analysis model to explain the component...     

不同瓦斯压力下煤体力学特性试验研究

为研究瓦斯对煤体力学特性的影响,设计不同瓦斯压力条件下煤体单轴压缩试验,研究煤样力学参数及变形特征随瓦斯压力的变化趋势,探讨瓦斯对煤体力学性质的影响机制,得出单轴压缩下煤样力学参数,并记录煤样的破坏形态.研究结果表明:随瓦斯压力增大,应力-应变曲线压实阶段增大,弹性阶段缩小,失稳破坏后曲线缓慢下降,抗压强度和弹性模量单...     

Utilization of cement kiln dust (CKD) in cement mortar and concrete—an overview

Solid waste management is one of the major environmental concerns around the world. Cement kiln dust (KKD), also known as by-pass dust, is a by-product of cement manufacturing. The environmental concerns related to Portland cement production, emission and disposal of CKD is becoming progressively significant. CKD is fine-grained, particulate material chiefly composed of oxidized, anhydrous, micron-sized particles collected from electrostatic precipitators during the high temperature production of clinker. Cement kiln dust so generated is partly reused in cement plant and landfilled. The beneficial uses of CKD are in highway uses, soil stabilization, use in cement mortar/concrete, CLSM, etc.Studies have shown that CKD could be used in making paste/mortar/concrete. This paper presents an overview of some of the research published on the use of CKD in cement paste/mortar/concrete. Effect of CKD on the cement paste/mortar/concrete properties like compressive strength, tensile strength properties (splitting tensile strength, flexural strength and toughness), durability (Freeze–thaw), hydration, setting time, sorptivity, electrical conductivity are presented. Use of CKD in making controlled low-strength materials (CLSM), asphalt concrete, as soil stabilizer, and leachate analysis are also discussed in this paper.     

Experimental study on the effect of fly ash content in cemented paste backfill on its anti-sulfate erosion

ABSTRACT

In order to study the effect of fly ash content in cemented paste backfill (CPB) on its anti-sulfate erosion, the apparent phenomenon, strength development, and hydration products change the law of CPB with different fly ash content under long-term soaking of 5% sodium sulfate solution were studied by the macrotest and microanalysis, in addition, the mechanism of CPB anti-sulfate attack was analyzed by combining with a scanning electron microscope (SEM). The results indicated that the effect of sulfate environment on the strength of fly ash cemented paste backfill (FCPB) was mainly determined by the hydration products in the FCPB at different soaking times. In the early soaking stage, the formation of ettringite (AFt) in FCPB could improve its compactness, which was conducive to improving the strength of FCPB. In the late soaking stage, there were ettringite-type erosion damage and gypsum erosion-type damage internal of the FCPB with low content fly ash, resulting in microfracture, cracking of the FCPB, and reducing the strength. CPB with an appropriate content of fly ash could improve the internal structure of the FCPB to achieve the purpose of anti-sulfate erosion.     

Radiation Effects on Blends of Poly(ε-Caprolactone) and Diatomites

Poly(-caprolactone) (PCL) was blended with diatomaceous earth (diatomite) and irradiated with -rays to introduce cross-linking between PCL molecules or both components. The unwashed diatomite containing a little of a volatile component showed high efficiency of introduction of cross-linking, whereas that with no volatile component showed low efficiency of introduction of cross-linking. Elongational viscosity, melt viscosity, and modulus of PCL/diatomite blend irradiated at various doses were significantly improved. Enzymatic degradation of the PCL/diatomite blend became faster than that of the PCL, though that of the blend irradiated became slower.     

Influences of Magnesium <Emphasis Type="Italic">tri-</Emphasis>Silicate on the Physical,Mechanical, and Degradable Properties of Ultraviolet (UV) Radiation Cured Plain Board Surface

A series of formulations were prepared with different percentages of oligomer, epoxy diacrylate (EA-1020 ), monomer, 1,6 Hexane diol diacrylate,(HDDA) and different percentages of filler (Magnesium tri-silicate, Mg₂Si₃O₈). Irgacure 369 [2-Benzyl-2-dimethyl-amine-1 (4-morpholinophenyl) butanone-1] was used in the formulations as photoinitiator. Ultraviolet (UV) cured thin polymer films were prepared from these formulating solutions on clean glass plates. Pendulum hardness (PH), gel content and macro scratch hardness (MSH) of the UV cured films were studied. One percent Mg₂Si₃O₈ containing formulation showed the premium properties. The substrates (plain board) were coated by these formulating solutions and cured under the same UV lamp at different intensities of radiation. Various properties of the coated surface such as PH, gloss, adhesion, abrasion and MSH were investigated. The base coat containing 1% Mg₂Si₃O₈ and top coat containing 48% HDDA produced the best performance among all the formulations inspected. The degradable properties in different weathering conditions on PH, gloss, adhesion, abrasion and MSH were measured. The surface cured with the optimized formulation (E) again yielded the minimum loss of the properties.     

提高节理面c和φ对岩坡开挖变形的影响

为了反映岩质边坡在节理面注浆后的变形效应,首先,通过室内试验,分析注浆前后岩体变形和破坏的全过程,以探讨其抗剪性能(粘结力c和内摩擦角φ)的变化;然后,基于理想弹塑性本构模型的Mohr-Cou-lomb准则,运用拉格朗日元数值方法(FLAC3D),对岩坡注浆前后变形效应(水平位移、垂直位移、剪应变增量)进行模拟。结果表明:注浆加固后,岩体的位移场变得均匀和连续,节理面处的较大位移受到抑制,边坡的整体性得到提高,有利于边坡的稳定性。     

Effect of Recycling on Material Properties of Glass-filled Polyethylene Terephthalate

Recycled plastics are considered low performance materials because their properties are expected to decrease drastically with recycling. The objective of this study was to characterize a 15 wt.% glass filled polyethylene terephthalate (rPET-15GF) using six recycle generations and four recycle ratios. Mechanical properties such as tensile strength, elastic modulus, and percent elongation to failure of the PET composite were determined for various recycle generations and recycle ratios. Results show that the mechanical properties of rPET-15GF decrease slightly per recycle generation. In contrast, thermal properties of rPET-15GF were not at all affected by the recycling process. This data demonstrates that recycled glass filled PET can be used effectively to fabricate components without significantly affecting their mechanical performance.     

基于SDSL传输技术的煤矿多媒体救灾系统研究

介绍一种新型的SDSL(对称性数字用户环路)数据传输技术,该技术采用对称数字用户线点对点宽带传输数字信号,在利用一对电话线进行双向对称数字信号传输时,最大传输速率可达到1.5Mb/s。应用SDSL传输技术研制出煤矿多媒体救灾系统,详细阐述煤矿多媒体救灾系统的构成、功能及特点等,该系统能够实现井下灾区多媒体信息的实时传输,解决在矿山救灾的特殊环境条件下实现灾区图像\语音实时传输到井下救援基地、地面指挥中心及国家矿山救援指挥中心的难题。