横通道通风对隧道火灾烟气蔓延影响的数值模拟研究

为探究隧道横通道通风对隧道火灾烟气蔓延的影响规律,使用火灾动力学模拟软件FDS,对不同火源位置的横通道临界风速、主隧道温度分布以及烟气层高度进行研究。研究结果表明：在一定火源功率范围内,隧道横通道临界风速与火源功率的1/3次方成正比且火源距横通道越远,临界风速越小;当火源位于交叉口,横通道使用临界风速通风时,隧道内烟气温度明显降低,烟气迅速沉降到2 m以下;当火源距离交叉口10,20 m,横通道通风会加快火源下游烟气沉降,烟气沉降速度随横通道通风速率的增大而增大;当火源位于交叉口时,烟气沉降由横通道通风对烟气的降温作用和涡旋作用共同主导,当火源位于距离交叉口10,20 m时,烟气沉降主要由涡旋作用主导。     

壳体缓释技术对带壳装药慢速烤燃反应烈度的缓解作用研究

为了研究2种典型壳体缓释技术对弹药慢速烤燃响应烈度的缓解作用,基于试验条件分别建立无缓释设计、侧壁加工应力槽和端盖加工泄压孔的带壳PBX装药慢速烤燃仿真模型,提出使用热分解反应动力学模型和燃烧反应模型模拟计算不同约束条件下带壳PBX装药从开始加热发生热分解反应到点火燃烧以及炸药与壳体耦合作用的烤燃过程的计算方法。研究结果表明：通过侧壁加工应力槽以及端盖加工泄压孔的缓释结构设计,可以有效地降低壳体破裂时炸药内部的压力及反应度,以达到缓解反应烈度的目的。     

大型碳化硅生产园区面源源强及减排指标核算

以某年产25万吨大型碳化硅园区无组织排放面源为例,提出基于多个地面站气象数据的CALPUFF模型地面浓度反推方法,优化流场模拟,使得无组织面源源强核算结果更加准确,并以环境保护目标空气质量达标为原则,核算其大气污染物减排指标,得出具体结论:园区大气污染物SO2、NOX、CO、PM10年排放量分别为449.06t、86.98t、5158.58t、115.06t;无组织排放SO2、CO及PM10的减排比例分别为63.5%、19.2%、42.44%,对应减排量分别为285.16 t/a、990.45 t/a、48.83 t/a。     

基于时序InSAR的覆砂石尾矿坝形变演化研究

为解决目前采用在尾矿坝坝体及滩面覆盖砂石进行防尘治理与闭库,但传统监测手段难以实现坝体整体监测的问题,采用时序InSAR技术对2014年10月至2018年7月的Sentinel-1A影像进行处理,提取了对应时间段内卡房尾矿坝的形变信息,并结合实地调查及尾矿坝建设资料,研究了卡房尾矿坝的时序形变演化规律。结果表明:SBAS InSAR监测到坝体出现第1次异常形变加速运动时间与坝体开始铺设砂石工程的施工时间节点完全吻合,体现SBAS InSAR技术在受人为工程影响的坝体形变监测方面具有极高的敏感性。坝体在施工结束后,坝体形变加剧趋势并未缓解,并且出现2次加速现象,分析认为是由于在坝体铺设约2 m厚的碎砂石极大地增加了坝体荷载,打破了坝体原有的应力平衡状态,且识别出雨季对坝体形变影响显著,表明铺设砂石会使得降雨在坝体中的停滞时间加长,进一步引发非雨季期间坝体形变加剧。研究结果不仅能还原坝体出现异常形变的时间与演化过程,而且还可以对引起异常形变的内在影响因素进行分析与论证,对指导尾矿坝灾害识别、分析与治理具有重要的指导意义。     

矿井巷道火灾烟流逆退数值模拟及临界风速研究

为了研究矿井发生火灾后高温烟流的蔓延规律及影响因素,利用COMSOL软件对火区进行数值模拟,建立巷道三维模型,得到火区风流速度与温度分布。通过改变边界条件,分析火风压作用下,火区烟气在不同控制风速、巷道条件作用下蔓延规律,得出不同因素与临界风速的关系,为选取合理的火灾控制风速提供理论依据。研究结果表明:火源温度一定时,巷道入口风速越低,火源下风侧高温烟流越靠近巷道顶部,随着风速增大,向巷道下部蔓延;风速较低时,在火区火风压的作用下,会产生烟流逆退现象,随着风速的增大,逆流层长度和厚度随之减小;巷道入口通风条件不变时,火区温度越高越容易产生烟流的逆退,影响范围越大;巷道高度越高、上行风坡度越小,越易发生逆退现象;不同影响因素与巷道平均温度不成正比关系,其中下行风坡度5~15°时巷道平均温度较高且易于发生烟流滚退现象,影响范围较大;火源温度、巷道条件与临界风速的数据拟合结果对预测巷道的临界风速有较好的参考价值。     

Explosion suppression of porous materials in a pipe-connected spherical vessel

To study the suppression of different porous materials on the explosion of combustible gas, some experiments were implemented. The porous materials were categorized into three kinds, including six subcategories, and the explosion suppression characteristics of the thin iron hoop, one-layer porous materials, two-layer composite porous materials, and three-layer composite porous materials were studied and analyzed. The results show that a rarefaction wave appears in the spherical vessel during the rapid development stage of combustion explosion. Further, the thin iron hoop could enhance the gas explosion intensity. And the explosion intensity suppression effect of the porous materials is obvious, the best effects of one-layer, two-layer and three-layer porous materials are from Fe–Ni 10 mm/40 PPI, Fe–Ni 10 mm/90 PPI + Al₂O₃ 10 mm/30 PPI, and Al₂O₃ 10 mm/50 PPI + Fe–Ni 10 mm/40 PPI + SiC 20 mm/20 PPI, respectively. According to the surface morphology of the porous materials, the anti-sintering ability of the three categories of porous materials follows the order of Al₂O₃ > SiC > Fe–Ni. Besides, the thickness and pore size of the combined porous material was changed, which has a great influence on the explosion pressure and the explosion intensity.     

Rainfall Interception Based on Indirect Methods: A Case Study in Temperate Forests in Oaxaca,Mexico

Rainfall interception represents the amount of water trapped in natural cover that is not drained directly to the ground. Intercepted rainfall may evaporate after a rain event, making it one of the main drivers of water balance and hydrologic regionalization. This process can be affected by factors such as climate, altitude, vegetation type, and topography. Here is a simple method of calculating rainfall interception in temperate forests using in Santa Maria Yavesia, Oaxaca, and Mexico as an illustrative study area. We used two rain gauges to measure net precipitation (N_p) under the canopy at each study site and one gauge outside the canopy to obtain gross precipitation (G_p). Throughfall (T_h) was indirectly measured using hemispherical photographs. Rainfall interception was obtained through a combination T_h and G_p and N_p. The mean rainfall interception was 50.6% in the Abies forests, 23%–40% in the coniferous‐mixed forests, and 27.4% in the broad‐leaved forests. We classified rainfall events by intensity to determine the effect of canopy structure and precipitation and found that 75% of the events were weak events, 24% were moderate events, and 1% were strong events. In addition, we found that rainfall interception was lower when the intensity of precipitation was higher. Our method can be replicated in different ecosystems worldwide as a tool for assessing the influence of rainfall interception in terms of ecological services.     

Spatial and temporal patterns and the socioeconomic impacts of landslides in the tropical and mountainous Colombian Andes

Landslides are a natural hazard that presents a major threat to human life and infrastructure. Although they are a very common phenomenon in Colombia, there is a lack of analysis that entails national and comprehensive spatial, temporal, and socioeconomic evaluations of such events based on historical records. This study provides a detailed assessment of the spatial and temporal patterns and the socioeconomic impacts associated with landslides that occurred in the country between 1900 and 2018. Two national landslide databases were consulted and this information was complemented by local and regional landslide catalogues. A total of 30,730 landslides were recorded in the 118-year period. Rainfall is the most common trigger of landslides, responsible for 92 per cent of those registered, but most fatalities (68 per cent) are due to landslides caused by volcanic activity and earthquakes. An ‘fN curve’ revealed a very high frequency of small and moderate fatal landslides in the time frame.     

单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性,利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg,对其进行阶段划分:阶段1为30℃~Tc;阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化,进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化,单轴应力为2.7 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段1和2煤导热系数随温度升高均先减小后增大,并且煤导热系数随单轴应力增大呈三次函数变化。     

不同火灾规模下隧道水幕线性喷水强度的研究

为了探究火源功率和水幕线性喷水强度对烟气特征参数和水幕阻烟隔热能力的影响,以全尺寸隧道为研究对象,采用FDS数值模拟方法,还原验证了前人使用的小尺寸模型,研究了20组工况下烟气特征参数变化的规律。研究结果表明:根据相似性原理还原后的全尺寸模型在相同工况下的模拟结果与小尺寸实验基本一致;水幕系统降低遮光率的效果随线性喷水强度增加而增强,当线性喷水强度增至一定程度时,遮光率和隔热效率无明显变化;对于中、大型规模火灾,水幕有效作用时间出现减少的情况;火源功率为5,20,30 MW的小、中、大规模的隧道火灾,综合考虑经济性和水幕效果,建议分别选择水幕的线性喷水强度为8,14,16 L/(s瘙
簚m)。