制药废水有机污染物特性分析与处理

分析了某制药企业废水生物处理站进出水中有机污染物的相对分子质量分布和气相色谱—质谱图谱,提出了根据废水水质特性有针对性地确定制药废水处理工艺的新思路.实验结果表明:进出水中的有机污染物主要是相对分子质量小于1 000的物质,且主要来源于车间5排放的COD比重大、水量小的工段废水;采用旋转蒸馏预处理法处理车间5废水,可使...     

Effects of T-2 toxin on histopathology,fatty acid and water distribution of shrimp (Litopenaeus vannamei) muscle

T-2 toxin (T-2), one of the naturally occurring mycotoxins, often accumulates in aquatic animals from contaminated feed. Shrimp (n?=?30 per group) were fed with different concentrations (0, 0.5, 1.5, 4.5 and 13.5?mg kg^?1) of T-2 for 20?days. Changes in histopathology, fatty acid and water distribution of shrimp muscle were analyzed. Histopathology of shrimp muscle showed dose-dependent marked degenerative and necrotic changes on exposure to dietary T-2. The T-2 significantly (P?<?0.05) affected the muscle fatty acid composition. ∑SFA, ∑MUFA and ∑PUFA initially decreased and then increased slowly in the high-dosed groups. C16:0, C18:1n-9 and C18:2n-6 were the main saturated fatty acid (SFA), monounsaturated fatty acid (MUFA) and polyunsaturated fatty acid (PUFA), respectively. Also, T-2 significantly affected water distribution in shrimp muscle. High doses of T-2 reduced free water content, resulting in a reduction in the water holding capacity and hence changes to the shrimp muscle quality. Collectively, these results illustrated that T-2 significantly affects the fatty acid and water distribution, and also muscle histopathology, all of which would result in a reduction in the quality and nutritional value of shrimp.     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

Microbial fuel cells: Advances in electrode modifications for improvement of system performance

There is an increasing trend to conduct the researches related to Microbial Fuel Cells (MFCs) in the recent years. Limited power output has been the major obstacle for the practical application and upscaling of MFCs. Attempts have been made on electrode modifications such as anode treatments, cathode modifications with catalysts and bio cathodes developments to produce varying degrees of improved output current depending upon the types of modifications. Power density and Coulombic efficiency have been considered as the important parameters to analyze the system performances. This paper overviews on the advances made in MFCs’ researches focusing on different types of electrodes modifications along with the involved methodology. Furthermore, the system performances of different modified MFCs are compared in terms of the power density and the Coulombic efficiency.     

Automated energy management in distributed electricity systems: An EEPOS approach

The increasing capacity of distributed electricity generation brings new challenges in maintaining a high security and quality of electricity supply. New techniques are required for grid support and power balance. The highest potential for these techniques is to be found on the part of the electricity distribution grid.

This article addresses this potential and presents the EEPOS project’s approach to the automated management of flexible electrical loads in neighborhoods. The management goals are (i) maximum utilization of distributed generation in the local grid, (ii) peak load shaving/congestion management, and (iii) reduction of electricity distribution losses. Contribution to the power balance is considered by applying two-tariff pricing for electricity.

The presented approach to energy management is tested in a hypothetical sensitivity analysis of a distribution feeder with 10 households and 10 photovoltaic (PV) plants with an average daily consumption of electricity of 4.54 kWh per household and a peak PV panel output of 0.38 kW per plant. Energy management shows efficient performance at relatively low capacities of flexible load. At a flexible load capacity of 2.5% (of the average daily electricity consumption), PV generation surplus is compensated by 34–100% depending on solar irradiance. Peak load is reduced by 30% on average. The article also presents the load shifting effect on electricity distribution losses and electricity costs for the grid user.     

区域大气环境中PM2．5／PM10空间分布研究

提出了一种利用移动监测技术研究区域大气环境中PM2.5／PM10空间分布的方法,并在2004年12月进行了宁波市全市域PM2.5／PM10空间分布的研究。数据显示：相同路径所代表的地区PM2.5和PM10具有很好的相关性,多数路径上PM2.5与PM10数据的相关系数平方在0．95以上,而不同路径上PM2.5与PM10的比值不同。文中给出了宁波市PM2.5／PM10污染的空间分布图,直观地显示出PM2.5／PM10污染的空间分布情况,突出了污染的重点点位和地区。     

烟草烟雾对室内空气颗粒物浓度的影响

采用电称冲击低压系统(ELPI)将无烟室和吸烟室内的空气颗粒物(0.03～10.00 μm)分成12级,对其粒子数和质量浓度进行测定.结果表明,吸烟室PM0.03～10.00的日平均粒子数和质量浓度分别是无烟室的1.50、1.13倍.烟草烟雾对室内颗粒物粒子数的影响集中在0.03～1.00 μm粒径段;对室内颗粒物质量浓度的影响表现为双模态结构,峰值分别在0.20～0.70、5.00～8.20 μm粒径段.烟草烟雾颗粒物的粒子数和质量浓度随烟雾消散时间的增加而减少,粒径越小,减小的越明显;烟草烟雾颗粒物在室内消散缓慢,会在长时间内造成影响,应引起足够关注.     

垃圾填埋场微生物气溶胶粒径分布研究

为了了解垃圾填埋场微生物气溶胶粒径分布规律,在北京市某垃圾卫生填埋场填埋区、渗滤液处理区、生活区分别选定监测点,利用安德森六级微生物采样器,对填埋场空气微生物进行了系统的定点取样、测定和分析。研究结果表明,空气细菌粒径分布均为第Ⅰ级(>8.2 μm)最高,填埋区空气细菌粒径呈偏态分布,渗滤液处理区、生活区分别在第Ⅳ级和第Ⅲ级出现第2个峰值。携带细菌的可吸入微粒在渗滤液处理区比例最大。空气真菌与放线菌均在第Ⅳ级分布最高,携带真菌和放线菌的可吸入粒子的比例显著大于细菌(P<0.05)。填埋区不同作业时段空气微生物粒径在各级分布比例基本一致。填埋区细菌气溶胶中值直径为5.7 μm,渗滤液处理区为3.7 μm,生活区为5.3 μm,显著大于真菌气溶胶和放线菌气溶胶的中值直径(P<0.05)。     

Approximating the distribution of recreational visits from on-site survey data

While convenient and often used, on-site surveys are biased by the fact that users who visit the site more often are proportionately more likely to be sampled. This so-called avidity or size biased sampling results in over-estimating the visitation patterns of the average user. This analysis develops a rule of thumb method that may easily be applied by recreation site managers to visitation data collected on-site in order to infer behavior of the average user of the site. The key assumption that drives the derivation is that the visitation data of users is logarithmically distributed. To evaluate the methodology, we analyze several data sets of recreational users assuming that they reflect the populations of users and from these construct hypothetical on-site samples.     

Field Trial Assessment of Biological,Chemical, and Physical Responses of Soil to Tillage Intensity,Fertilization, and Grazing

Soil microbial populations can fluctuate in response to environmental changes and, therefore, are often used as biological indicators of soil quality. Soil chemical and physical parameters can also be used as indicators because they can vary in response to different management strategies. A long-term field trial was conducted to study the effects of different tillage systems (NT: no tillage, DH: disc harrow, and MP: moldboard plough), P fertilization (diammonium phosphate), and cattle grazing (in terms of crop residue consumption) in maize (Zea mays L.), sunflower (Heliantus annuus L.), and soybean (Glycine max L.) on soil biological, chemical, and physical parameters. The field trial was conducted for four crop years (2000/2001, 2001/2002, 2002/2003, and 2003/2004). Soil populations of Actinomycetes, Trichoderma spp., and Gliocladium spp. were 49% higher under conservation tillage systems, in soil amended with diammonium phosphate (DAP) and not previously grazed. Management practices also influenced soil chemical parameters, especially organic matter content and total N, which were 10% and 55% higher under NT than under MP. Aggregate stability was 61% higher in NT than in MP, 15% higher in P-fertilized soil, and also 9% higher in not grazed strips, bulk density being 12% lower in NT systems compared with MP. DAP application and the absence of grazing also reduced bulk density (3%). Using conservation tillage systems, fertilizing crops with DAP, and avoiding grazing contribute to soil health preservation and enhanced crop production.