含裂隙岩石裂纹扩展与剪切特性的数值研究*

为研究直剪条件下含交叉裂隙岩石的裂纹扩展模式和剪切特性,基于PFC2D研究直剪条件下含裂隙岩石的裂纹扩展模式和剪切特性。研究结果表明:直剪过程可分4个阶段:Ⅰ初始平静阶段、Ⅱ裂纹单一扩展阶段、Ⅲ裂纹复杂扩展阶段、Ⅳ破坏阶段;法向应力越大,Ⅱ,Ⅲ阶段的裂纹扩展程度受到抑制;岩石中含单裂隙时,随裂隙角度α的增加,抗剪强度的变化趋势基本一致,遵循先降后增的规律;含交叉裂隙时,当主裂隙角度α=120°,150°时,抗剪强度随次裂隙角度β的增加呈先减小后增大的趋势,抗剪强度最小值均出现在β=30°;加固含裂隙岩体时,预防裂隙或者潜在破坏面两侧的岩体产生位移差,使其加固后成为1个稳固整体,是避免岩体产生裂纹导致破坏的重要手段。     

猪精液酸性N-乙酰-β-D-氨基葡萄糖苷酶的纯化及性质水

以杜洛克猪精液为材料,采用硫酸铵分级沉淀、DEAE-32阴离子交换柱层析和Sephadex G-100分子筛柱层析纯化,获得纯化倍数为27.64、比活力为1 773.25 U mg~(-1)的酸性N-乙酰-β-D-氨基葡萄糖苷酶纯酶制剂.经SDS-聚丙烯酰胺凝胶电泳法测定,纯酶两种亚基相对分子质量分别为129.13×10~3和62.24×10~3.对其酶学性质的研究结果表明,酶的等电点为5.10,最适pH值为5.5,最适温度为60℃.酶在pH 3.6~9.2、温度10℃～55 ℃的范围内较稳定.以对硝基苯-N-乙酰-β-D-氨罐葡萄糖苷(pNP-NAG)为底物,测得米氏常数K_m为0.455 mmol L~(-1),最大反应速度V_m为17.34μmol L~(-1)min~(-1),活化能为41.70 kJ mol~(-1).图8表1参15     

MWNTs/TiO2/聚酯功能复合膜吸附及其净化性能

以聚酯工业滤布为基膜,采用溶胶凝胶和浸渍方法制备了具有吸附-光催化功能的多壁碳纳米管(MWNTs)/TiO2涂层的复合膜,该复合膜对模拟水样低浓度(10mg/L)的双酚A具有较高吸附性能.随着复合膜上负载二氧化钛中的MWNTs的比例(17.6%,29.9%,和46.0%)增加,吸附去除率显著提高;吸附饱和的复合膜上的污染物双酚A可通过20W 紫外灯(l=254nm)照射Fenton氧化反应去除.吸附实验和HPLC分析表明,除了超声处理会引起浸渍负载的材料脱落外,复合膜吸附性能恢复较好.     

污泥热水解技术研究进展

热水解可以改善污泥的生物降解性能和脱水性能,提高后续厌氧消化系统中有机物的去除率。本文阐述了热水解对污泥物理特性主要包括流变特性和脱水行为的影响;分析了热水解对污泥中氨氮浓度及对厌氧消化的作用;同时介绍了热水解技术对整个污泥处理系统能量需求的影响。指出：热水解改善了污泥的厌氧消化性能,提高了沼气等再生资源的产量,且厌氧消化产生的沼气量与热水解技术所需的能量基本平衡。     

Influence of physical properties of ammonium nitrate on the detonation behaviour of ANFO

In order to obtain a better understanding of the non-ideal detonation behaviour of ammonium nitrate based explosives, detonation velocities of ANFO (ammonium nitrate and fuel oil) prepared with different kinds of ammonium nitrate (AN) were measured in steel tubes. In this series of test six kinds of AN were used and the influence of the pore diameter, the pore volume and the particle diameter of the AN particle on the detonation velocity of ANFO was investigated.

It was found that the pore diameter and the pore volume had a strong influence on the detonation velocities of ANFO. In the case of ANFO samples which were prepared with AN that had the same pore diameter and the pore volume, when tested the highest detonation velocity (3.85 km/s) was observed when the smallest particle diameter (<0.85 mm) was used. This value corresponded to 75% of the ideal detonation velocity, which was theoretically predicted by the CHEETAH code with the JCZ3-EOS.

The 12 months aging showed the change of the detonation velocities of ANFO and the reaction of ANFO was influenced both by the physical and the chemical properties of AN particles and oil during the storage period.     

制度与市场机制在治理污染中的作用

寻找一种既能促进经济发展又能保护环境的控制环境污染的有效途径具有十分重要的意义。新制度经济理论为环境污染的控制及其政策的制定提供了理论基础。该理论认为,当传统的管制方法不能实现资源最优配置的时候,通过界定产权和进行产权交易的方法是可以得到满意结果的。     

酸浸粉煤灰混凝法处理制革废水的研究

笔者研究了在热电厂粉煤灰中加入少量的鼓风炉铁泥和适量的助溶剂HS,在加热条件下用稀硫酸搅拌浸取2h后,制得集物理吸附和化学混凝为一体的混凝剂。这种混凝剂与聚硅酸铝铁(PSAF)絮凝剂配合处理COD为1500～2000mg/L制革废水,SS,COD,硫化物和铬的去除率分别为95%,93%,92%和88%。该法的显著特点是混凝沉降速度快,污泥体积小,处理废水费用低,此外还探讨了酸浸粉煤灰混凝剂对制革废水的混凝沉降机理。      

Thermal and Mechanical Properties of Plastics Molded from Sodium Dodecyl Sulfate-Modified Soy Protein Isolates

Soybean protein is a potential material for manufacturing of biodegradable plastics. The objective of this investigation was to characterize the thermal and mechanical properties of plastics made from sodium dodecyl sulfate (SDS)-modified soy proteins. Soy protein isolate (SPI) was prepared from defatted soy flour, modified with various concentrations of SDS, and then molded into plastics. The temperatures of denaturation of the modified soy protein increased at low SDS concentration and then decreased at high SDS concentration. At the same SDS concentration, the plastics molded from the modified soy proteins showed a similar temperature of denaturation, but a lower enthalpy of denaturation compared to the modified soy protein. Young's modulus of the plastics decreased as SDS concentration increased, and the tensile strength and strain at break of the plastics reached a maximum value at 1% SDS modification. Two glass transition temperatures were identified corresponding to the 7S and 11S globulins in SPI by dynamic mechanical analysis, and they decreased as SDS concentration increased. The SDS modification increased the water absorption of the plastics.     

聚氯乙烯基复合隔声材料的研究

将聚氯乙烯与无机超细材料混合,研制了一种新型复合隔声材料,其平均隔声指数为20dB左右.采用四传感器驻波管法对复合材料进行了隔声性能测试,并讨论了无机物含量及粒径分布等因素对隔声性能的影响.     

黄土地层构造差异成因及其对自然环境的影响

陕甘宁地块上广泛分布的黄土地层的破坏是黄河水患的主要原因,黄土地层有一定的抗侵蚀能力,但当被开垦时,其抗侵蚀能力会大幅降低,在陕甘宁黄土地层分布区减少,以至最终基本停止农耕而瞠步代之以林草,确系治黄的根本方略,陕北是黄土高原水土流失最严重的地区,是黄河泥沙最主要的来源地,但区内黄土地层受侵蚀的状况却具有分带性,北东和北西两组基底断裂构造对其有重要影响,并对毛乌素沙漠的位置以及无定河环形构造的活动状况有一定控制作用,这些都是在陕北开展山川秀美工程过程中必须考虑到的因素,由此得到启迪;在开发自然资源,环境保护和减灾工作中,必须首先认识环境的自然属性。