高效磷吸附剂Mg/Al-LDO的制备及除磷机制

针对污水中磷的去除问题,采用优化后的恒定pH值共沉淀法制备了Mg/Al-layered double hydroxides(Mg/Al-LDHs),经高温焙烧得到高效磷吸附剂Mg/Al-layered double oxide(Mg/Al-LDO);在对其吸附特性研究的基础上,并结合Zeta电位、XRD、FTIR分析吸附前后材料等电点、晶体结构及层间阴离子的变化,探讨Mg/Al-LDO吸附除磷机制.结果表明,采用优化后的共沉淀法,在Mg/Al比为2∶1,焙烧温度450℃,焙烧时间2 h条件下制备出的Mg/Al-LDO对磷酸根吸附性最好,最大吸附容量可达到176.94 mg·g-1,与理论吸附容量191.57 mg·g-1基本一致,远高出Mg/Al-LDHs及其它磷吸附剂.实验数据对准二级反应动力学模型的拟合结果较好,吸附过程符合Langmuir吸附等温模型.结合Zeta电位、XRD、FTIR的结果推测,Mg/AlLDO吸附除磷主要是通过静电引力、阴离子插层、离子交换、表面配位这4种作用协同完成.     

苯基改性的介孔分子筛SBA-15的合成与表征

采用一步法在酸性条件下以聚乙氧基聚丙氧基聚乙氧基三嵌段共聚物(P123)为模板剂,用正硅酸乙酯(TEOS)和苯基三甲氧基硅烷(PTMS)直接缩合制备了苯基改性介孔分子筛Ph-SBA-15,并用红外光谱(FTIR)、小角X射线衍射(SAXRD)、热重分析(TGA)、透射电镜(TEM)和氮气吸附-脱附对样品进行了表征。结果表明,制备的样品不仅保持了高度有序的SBA-15的二维六角结构,而且具有较高的热稳定性,较大的比表面,孔容和孔径。     

Co- or Ni-modified Sn-MnOx low-dimensional multi-oxides for high-efficient NH3-SCR De-NOx: Performance optimization and reaction mechanism

NH₃-SCR performances were explored to the relationship between structure morphology and physio-chemical properties over low-dimensional ternary Mn-based catalysts prepared by one-step synthesis method.Due to its strong oxidation performance,Sn-MnOx was prone to side reactions between NO,NH₃ and O₂,resulting in the generation of more NO₂ and N₂ O,here most of N₂ O was driven from the non-selective oxidation of NH₃,while ...     

Material conversion from paper sludge ash in NaOH solution to synthesize adsorbent for removal of Pb^2＋, NH^4＋ and PO4^3- from aqueous solution

Material conversion from paper sludge ash (PSA) in NaOH solution was attempted to synthesize the adsorbent for removal of inorganic pollutants, such as Pb2+, NH4 + and PO4 3?? from aqueous solution. PSA of 0.5 g was added into 10 mL of 3 mol/L NaOH solution, and then heated at 80, 120, and 160°C for 6–48 hr to obtain the product. PSA mainly composed of two crystalline phases, gehlenite (Ca2Al2SiO7) and anorthite (CaAl2Si2O8), and amorphous phase. Hydroxysodalite (Na6Al6Si6O24 8H2O) was formed at 80°C, and anorthite dissolved, whereas gehlenite remained una ected. Katoite (Ca3Al2SiO4(OH)8) was formed over 120°C, and hydroxycancrinite (Na8(OH)2Al6Si6O24 2H2O) was formed at 160°C, due to the dissolution of both gehlenite and anorthite. Specific surface areas of the products were almost same and were higher than that of raw ash. Cation exchange capacities (CECs) of the products were also higher than that of raw ash, and CEC obtained at lower temperature was higher. Removal abilities of products for Pb2+, NH4 +, and PO4 3?? were higher than that of raw ash.With increasing reaction temperature, the removal e ciencies of Pb2+ and NH4 + decreased due to the decrease of CEC of the product, while removal e ciency for PO4 3?? was almost same. The concentrations of Si and Al in the solution and the crystalline phases in the solid during the reaction explain the formation of the product phases at each temperature.     

TiO2表面沉积Ag粒子及其可见光下降解含盐废水中的苯酚

为了制备可见光激发下能高效降解含盐废水中有机物的光催化剂,首次以商用TiO_2光催化剂(P25)为载体,利用吸附相反应技术一步获得了Ag沉积的可见光响应复合光催化剂.同时,通过XPS、TEM、HRTEM及紫外可见漫反射光谱图,结合多种高含盐水体系中苯酚的光催化降解过程,研究了不同Ag沉积对催化剂可见光活性的影响.结果发现,吸附平衡后P25表面富含水的吸附层可作为反应和粒子的生成场所,生成量子尺寸的Ag粒子.另外,在吸附层中生成的Ag粒子均匀分布于P25表面并与之紧密结合,并在TiO_2晶格结构中引入晶格交错结构.Ag与TiO_2的表面等离子体共振效应和晶格交错结构共同提升了催化剂的可见光响应和电荷的分离效率,增强了催化剂对苯酚的可见光催化性能.在含盐废水体系中,盐离子数量越多,催化剂在可见光下降解苯酚过程受到的干扰越大.     

基于多目标决策的节能减排绩效评估

利用全排列多边形图示指标法构建评价模型,从资源能源消耗、污染物排放、综合利用、环保治理及无害化等方面构建节能减排评价指标体系,并对福建省2001-2010年节能减排进行绩效评估.结果表明,福建省节能减排绩效的优劣顺序分别为:2010、2009、2003、2002、2008、2007、2004、2001、2006、2005年.2005-2006年福建省在废物综合利用、环保治理及无害化等方面取得了一定的成效,但与2001-2004年相比优势不明显,而在资源能源消耗与污染排放方面却出现了大幅度的下滑.2007年以来,福建省正在逐步加大重点行业和重点企业的节能减排力度,因此,在节能减排方面取得了较明显的成效.评价结果较好地体现了福建省节能减排的现状与不足,为推动节能减排绩效评估工作的发展提供了科学依据.     

沿海滩涂围垦生态补偿标准构建——基于能值拓展模型衡量的生态外溢价值

论文综合利用能值分析法、生态足迹法等生态经济学方法,结合Shannon-Wiener指数和生态消费系数构建了沿海滩涂围垦生态补偿能值拓展模型以测算滩涂在各时期的生态外溢价值,并以生态外溢价值改变量作为滩涂围垦生态损害的衡量标准,且以此为生态补偿依据,在生态价值系数调整法的基础上建立了沿海滩涂围垦生态补偿标准。最后以杭州湾新区为例,测算了该区域滩涂围垦过程中各年份生态补偿标准,结果显示,2000—2015年,该区域生态补偿标准从2000年0美元/m²平缓递增到2015年0.05美元/m²。此研究表明,能值拓展模型能有效弥补传统的基于生态服务价值模型的一些不足,使评估标准相对客观化,评估结果动态化和体现对补偿主客体双方意愿的尊重。     

一株新颖的Providencia sp.菌降解吲哚及合成靛蓝的特性研究

吲哚是一种典型的氮杂环芳烃污染物,在焦化废水和畜牧废水中大量存在.本研究从近海泥沙中分离纯化得到一株高效吲哚降解菌DCX,经16S rRNA基因序列比对分析,鉴定其为普罗维登斯菌属(Providencia sp.).该菌株能够以吲哚为唯一碳源,在28 h内将100 mg·L~(-1)吲哚完全降解.液相色谱/飞行时间-质谱联用(LC/TOF-MS)的结果表明,靛蓝、靛红、靛红酸及邻氨基苯甲酸是菌株DCX降解吲哚过程中的中间产物.此外,本研究中发现,外加营养物质可以促进菌株DCX降解吲哚,特别是加入酵母浸粉后,反应体系中会产生大量靛蓝.利用表面响应法确定菌株DCX转化吲哚合成靛蓝的最优条件为:吲哚207.49 mg·L~(-1),酵母浸粉2.9 g·L-1,接菌量4.23%(V/V),并且在最优条件下,靛蓝产率达到最高(9.90%),比初始条件提高了4.38倍.     

Synthesis and in vitro biological evaluation of 3, 4-annelated coumarin-pyrimido-pyrimidine systems

3,4-Annelated coumarin-pyrimido-pyrimidine systems (7-imino-8-mercapto-7H-5-oxa-7a,9,12-triaza-benzo[a]anthracen-6-one 2 and 8-hydroxy-7-imino-10-methyl-7H-5-oxa-7a,9,12-triaza-benzo[a]anthracen-6-one 3) were synthesized by the action of 4-amino-2-mercapto-pyrimidine, 2-amino-4-hydroxy-6-methylpyrimidine, respectively, on 4-chlorocoumarin-3-carbonitrile 1. The synthesized compounds were examined for in vitro antibacterial activity against 4 bacterial cultures: Staphylococcus aureus, Streptococcus pneumonia, Escherichia coli, and Aeromonas Salmonicida. The antibacterial activity of synthesized compounds 2 and 3 was compared to antibacterial activity of novobiocin as a standard drug.     

Green synthesis and characterization of metal ions-mixed titania for application in dye-sensitized solar cells

Abstract

The objective of the present study is to synthesize various metal ions mixed TiO₂ nanoparticles using a continuous hydrothermal synthesis pilot reactor for dye-sensitized solar cells (DSCs). In the pilot plant, aqueous solutions of the metal salts are mixed with a flow of supercritical water (450?°C and 24.1?MPa) in a confined jet mixer for continuous synthesis of metal ions-mixed nano-titania. Characterization of the particles was made using Brunauer–Emmett–Teller technique for specific surface area, powder X-ray diffraction analysis and transmission electron microscopy for identification and crystallite size, X-ray photoelectron spectroscopy for surface analysis and infrared spectroscopy for distinct group identification. Following the already existing procedures and using the titanates synthesized, dye-sensitized cells of 1?cm² area were assembled and their photovoltaic parameters were evaluated under standard test conditions. The power conversion efficiencies (η %) for 40?mol % Zn²⁺, 5?mol % Zr⁴⁺ and 10?mol % Zn⁴⁺ titania were obtained to be 4.8, 4.95 and 4.9, respectively. The promising efficiency results from a greener and large-scale production of nano-titania is a step forward towards commercializing DSC technology.